2009 PONTIAC VIBE turn signal bulb

Turn and Lane-Change
Signals
An arrow on the instrument panel
cluster ashes in the direction of the
turn or lane change.
Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to ash to signal a lane
change. Hold it there until the
lane change is completed.
The lever returns to its starting
position whenever it is released.
If after signaling a turn or a
lane change the arrow ashes
rapidly or does not come on,
a signal bulb may be burned out.
Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
SeeFuses and Circuit Breakers
on page 9-36.
Headlamp High/
Low-Beam Changer
The headlamps must be on for this
feature to work.
Push the turn signal lever away
from you to turn the high beams on.
This instrument panel cluster light
3comes on while the high beam
headlamps are on.
Pull the lever towards you to return
to low beams.
Flash-to-Pass
This feature is used to signal to the
vehicle ahead that you want to pass.
With the lever in the low-beam
position, pull the lever toward you to
momentarily switch to high-beams.
If the headlamps are on when the
lever is released, the high-beams will
return to low-beam.
Windshield Wipers
The windshield wiper/washer lever
is located on the right side of
the steering column.
Move the lever to one of the
following positions:
z(Mist):Move the lever to mist,
for a single wiping cycle and then
release. The wipers stop after
one wipe.
((Off):Move the lever to this
position to turn the wipers off.
Instruments and Controls 4-7
2009 - Pontiac Vibe Owner Manual

Bulb Replacement
For the proper type of replacement
bulbs, seeReplacement Bulbs
on page 9-35.
For any bulb changing procedure
not listed in this section, contact
your dealer/retailer.
Halogen Bulbs
{CAUTION
Halogen bulbs have pressurized
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure
to read and follow the instructions
on the bulb package.
Headlamps and Parking
Lamps
A. High-beam Headlamp
B. Turn Signal Lamp/Parking Lamp
C. Low-beam Headlamp
High-beam and Low-beam
Headlamps
To replace the High-beam or
Low-beam Headlamp:
1. Open the hood. SeeHood
Release on page 9-5.
2. Turn the bulb socket
counterclockwise and pull it out
of the headlamp assembly.
Vehicle Service and Care 9-31
2009 - Pontiac Vibe Owner Manual

3. Unplug the connector while
pressing down on the release tab.
4. Pull the old bulb straight out.
5. Push the new bulb straight
in until it clicks.
6. Push the bulb socket into the
headlamp assembly and turn
it clockwise to secure it in
its original location.
Front Turn Signal Lamp and
Parking Lamp
To replace the Front Turn Signal
Lamp or Parking Lamp:
1. Open the hood. SeeHood
Release on page 9-5.
2. Turn the bulb socket
counterclockwise and pull
it out of the lamp assembly.3. Pull the old bulb straight out of
the bulb socket.
4. Push the new bulb straight in
until it clicks.
5. Push the bulb socket into
the lamp assembly and turn
clockwise to secure it in
its original location.
9-32 Vehicle Service and Care
2009 - Pontiac Vibe Owner Manual

Taillamps
A. Turn Signal Lamp
B. Stoplamp/Sidemarker
Lamp/Taillamp
C. Back-up LampTo replace one of these lamps:
1. Open the liftgate.
2. Remove the storage
compartment cover in the rear
cargo area of the vehicle to
access the bulbs.
3. Turn the bulb socket
counterclockwise and pull it out.Passenger Side
Driver Side
Vehicle Service and Care 9-33
2009 - Pontiac Vibe Owner Manual

Following Distance
Stay at least twice as far behind the
vehicle ahead as you would when
driving your vehicle without a trailer.
This can help you avoid situations
that require heavy braking and
sudden turns.
Passing
More distance in front is needed to
pass when towing a trailer. And,
because the tow vehicle and trailer
are longer, you will need to go
farther beyond the passed vehicle
before you can return to your lane.
Backing Up
Hold the bottom of the steering
wheel with one hand. Then, to move
the trailer to the left, just move that
hand to the left. To move the trailer
to the right, move your hand to the
right. Always back up slowly and, if
possible, have someone guide you.
Making Turns
Notice:Making very sharp turns
while trailering could cause
the trailer to come in contact with
the vehicle. The vehicle could
be damaged. Avoid making very
sharp turns while trailering.
When you are turning with a trailer,
make wider turns than normal.
Do this so your trailer will not strike
soft shoulders, curbs, road signs,
trees or other objects. Avoid jerky or
sudden maneuvers. Signal well in
advance.
Turn Signals When Towing a
Trailer
When you tow a trailer, your vehicle
may need a different turn signal
asher and/or extra wiring. Check
with your dealer/retailer. The arrows
on the instrument panel ash
whenever you signal a turn or lane
change. Properly hooked up, the
trailer lamps also ash, telling other
drivers you are about to turn, change
lanes or stop.When towing a trailer, the arrows
on the instrument panel will ash for
turns even if the bulbs on the trailer
are burned out. Thus, you may think
drivers behind you are seeing your
signal when they are not. It is
important to check occasionally to be
sure the trailer bulbs are still working.
Driving On Grades
Reduce speed and shift to a lower
gearbeforeyou start down a long or
steep downgrade. If you do not shift
down, you might have to use your
brakes so much that they would get
hot and no longer work well.
On a long uphill grade, shift down
and reduce your speed to around
45 mph (70 km/h) to reduce the
possibility of the engine and the
transmission overheating.
Vehicle Service and Care 9-81
2009 - Pontiac Vibe Owner Manual

Removing the Flat Tire and
Installing the Spare Tire.....9-64
Removing the Spare Tire
and Tools........................9-63
Replacement Bulbs..............9-35
Replacement Parts,
Maintenance....................10-4
Replacing LATCH System
Parts After a Crash...........1-49
Reporting Safety Defects
Canadian Government.....12-15
General Motors...............12-16
United States
Government................12-15
Restraint System Check
Replacing Airbag System
Parts After a Crash........1-35
Replacing Safety Belt
System Parts After a
Crash..........................1-20
Retained Accessory Power...... 8-4
Roadside
Assistance Program..........12-5
Rocking Your Vehicle to
Get it Out ........................8-31
Routing, Engine Drive Belt....10-5
Running the Vehicle While
Parked............................8-17S
Safety Belt Reminders..........4-14
Safety Belts.......................... 1-8
Care of ...........................1-20
Check.............................1-20
How to Wear Safety Belts
Properly.......................1-11
Lap-Shoulder Belt.............1-16
Replacing Parts After a
Crash..........................1-20
Safety Belt Extender.........1-19
Safety Belt Use During
Pregnancy....................1-19
Scheduled Maintenance........11-4
Seatback, Folding Passenger . . . 1-4
Seats
Head Restraints................. 1-6
Height Adjuster.................. 1-2
Passenger Folding
Seatback....................... 1-4
Rear Seat Operation........... 1-7
Reclining Seatbacks............ 1-3
Securing Child
Restraints................1-50, 1-53
Security Light......................4-22Service................................ 9-2
Accessories and
Modications.................. 9-3
Adding Equipment to the
Outside of the Vehicle..... 9-4
All-Wheel-Drive Light.........4-24
California Perchlorate
Materials Requirements.... 9-3
California Proposition
65 Warning.................... 9-3
Doing Your Own Work........ 9-4
Engine Soon Lamp...........4-20
Owner Checks................... 9-5
Publications Ordering
Information.................12-16
Service Airbag Notication
System Message..............4-16
Service, Scheduling
Appointments...................12-8
Servicing Your
Airbag-Equipped Vehicle....1-33
Setting the Clock................... 6-2
Sheet Metal Damage............9-89
Shifting Into Park.................8-13
Shifting Out of Park..............8-14
Signals, Turn and
Lane-Change..................... 4-7
i-8 INDEX
2009 - Pontiac Vibe Owner Manual