2009 PONTIAC VIBE cruise control

Instruments and
Controls
Instrument Panel
Overview
Instrument Panel
Overview...........................4-2
Hazard Warning Flashers. . . .4-3
Horn...................................4-3
Tilt Wheel...........................4-4
Turn Signal/Multifunction
Lever................................4-4
Cruise Control....................4-4
Turn and Lane-Change
Signals.............................4-7
Headlamp High/
Low-Beam Changer..........4-7
Flash-to-Pass......................4-7
Windshield Wipers..............4-7
Windshield Washer.............4-8
Rear Window Wiper/
Washer.............................4-8
Accessory Power
Outlet(s)............................4-9
Power Outlet 115 Volt
Alternating Current..........4-10
Ashtray(s).........................4-10
Warning Lights, Gages,
and Indicators
Warning Lights, Gages,
and Indicators.................4-11
Instrument Panel Cluster. . .4-12
Speedometer and
Odometer........................4-13
Trip Odometer(s)...............4-13
Tachometer.......................4-13
Safety Belt Reminders......4-14
Airbag Readiness Light.....4-14
Passenger Airbag Status
Indicator..........................4-15
Service Airbag Notication
System Message.............4-16
Charging System Light......4-16
Brake System Warning
Light................................4-17
Antilock Brake System
(ABS) Warning Light.......4-18
Speed Sensitive Power
Steering (SSPS)
Warning Light
..................4-18
Low Tire Pressure
Warning Light..................4-18
Traction Control System
(TCS) Warning Light.......4-19
StabiliTrak®Indicator
Light................................4-19
Engine Coolant
Temperature Gage..........4-19
Malfunction
Indicator Lamp................4-20
Security Light....................4-22
Oil Pressure Light.............4-22
Fog Lamp Light................4-23
Lights On Reminder..........4-23
Taillamp Indicator Light.....4-23
Cruise Control Light..........4-23
Low Washer Fluid
Warning Light..................4-23
Service All-Wheel Drive
Light................................4-24
Highbeam On Light...........4-24
Door Ajar Light.................4-24
Fuel Gage........................4-24
Low Fuel Warning Light. . . .4-25
OnStar®System
OnStar®System................4-25
Instruments and Controls 4-1
2009 - Pontiac Vibe Owner Manual

The main components of the
instrument panel are the following:
A.Outside Power Mirror(s) on
page 2-14.
B.Outlet Adjustment on page 7-3.
C.Turn Signal/Multifunction
Lever on page 4-4.
D.Instrument Panel Cluster on
page 4-12.
E.Windshield Wipers on page 4-7.
F. Passenger Airbag Status
Indicator.Passenger Sensing
System on page 1-28.
Security Light. SeeContent
Theft-Deterrent on page 2-10.
G.Hazard Warning Flashers on
page 4-3.
H.Audio System(s) on page 6-1.
I.Traction Control System (TCS)
on page 8-21.
J.Content Theft-Deterrent on
page 2-10.
K.Driver Storage Compartment
on page 3-3.
L.Hood Release on page 9-5.M.Audio Steering Wheel Controls
on page 6-13.
N.Tilt Wheel on page 4-4.
O.Horn on page 4-3.
P.Cruise Control on page 4-4
(If Equipped).
Q.Ignition Positions on page 8-2.
R. Tire Pressure Reset Button
(Out of View). SeeTire Pressure
Monitor Operation on page 9-50.
S.Power Outlet 115 Volt Alternating
Current on page 4-10On/Off
Button.
T. Cigarette Lighter (If Equipped)
or Accessory Power Outlet.
Ashtray(s) on page 4-10
orAccessory Power Outlet(s)
on page 4-9.
U. Shift Lever.Automatic
Transmission Operation
(Four Speed) on page 8-6or
Automatic Transmission
Operation (Five Speed)
on page 8-8orManual
Transmission Operation
on page 8-11.V.Power Outlet 115 Volt Alternating
Current on page 4-10.
W.Climate Control System on
page 7-1.
X.Hooks on page 3-3
.
Y.Glove Box on page 3-1.
Hazard Warning Flashers
|
(Hazard Warning Flasher):
Press this button located on
the instrument panel, to make the
front and rear turn signal lamps ash
on and off. This warns others that
you are having trouble.
Press
|again to turn the
ashers off.
Horn
Press near or on the horn symbols
on the steering wheel pad to
sound the horn.
Instruments and Controls 4-3
2009 - Pontiac Vibe Owner Manual

Tilt Wheel
A tilt and telescope wheel lets the
steering wheel position be adjusted.
The adjustment lever is located
on the left side of the steering
column.
Pull the lever down to move the
steering wheel up or down and in or
out. Pull the lever up to lock the
steering wheel in place.
Do not adjust the tilt and telescope
lever while driving.
Turn Signal/Multifunction
Lever
The lever on the left side of the
steering column includes the
following:
O:Exterior Lamps.
G:Turn and Lane-Change
Signals.
2:Headlamp High/Low-Beam
Changer.
#:Fog Lamps (If Equipped).
Flash-to-Pass Feature.
Information for these features is on
the pages following.
Cruise Control
For vehicles with cruise control, the
lever is located on the right side
of the steering wheel.
Cruise control, lets a speed of
25 mph (40 km/h) or more be
maintained without keeping your
foot on the accelerator. Cruise
control does not work at speeds
below 25 mph (40 km/h).
4-4 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

{CAUTION
Cruise control can be dangerous
where you cannot drive safely at
a steady speed. So, do not use
the cruise control on winding
roads or in heavy traffic.
Cruise control can be dangerous
on slippery roads. On such roads,
fast changes in tire traction can
cause excessive wheel slip, and
you could lose control. Do not use
cruise control on slippery roads.Setting Cruise Control{CAUTION
If you leave your cruise control on
when you are not using cruise,
you might hit a button and go into
cruise when you do not want to.
You could be startled and even
lose control. Keep the cruise
control switch off until you want to
use cruise control.
1. Press the ON-OFF button at the
end of the lever. The CRUISE
light on the instrument panel
cluster comes on. SeeCruise
Control Light on page 4-23.
2. Get to the desired speed.
3. Move the lever down to−SET
and release it.
4. Take your foot off the accelerator
pedal.If the cruise control indicator light
ashes, press the ON-OFF button
once to deactivate the system, and
then press the button back on.
If the cruise control speed cannot be
set or the cruise control cancels
immediately after being activated,
there may be a problem with the
cruise control system. See your
dealer/retailer.
Resuming a Set Speed
If the brakes are applied after the
cruise control is set, the cruise
control is turned off.
If the vehicle speed is 25 mph
(40 km/h) or greater, push the lever
up to +RES (Resume/Accelerate)
to return to the previously set speed.
Instruments and Controls 4-5
2009 - Pontiac Vibe Owner Manual

Increasing Speed While Using
Cruise Control
There are three ways to increase
the vehicle speed:
Use the accelerator pedal to get
to the higher speed. Move the
lever down to−SET. Release the
lever and the accelerator pedal.
Move the cruise lever up
to +RES. Hold it there until the
desired speed is reached,
and then release the lever.
To increase the vehicle speed in
very small amounts, move the
lever to +RES briey and then
release it. Each time this is done,
the vehicle goes about 1 mph
(1.6 km/h) faster.Reducing Speed While Using
Cruise Control
There are two ways to reduce the
vehicle speed while using cruise
control:
Push and hold the lever to−SET
until the desired lower speed is
reached, then release it.
To slow down in very small
amounts, push the lever
down briey. Each time this
is done, the vehicle will go about
1 mph (1.6 km/h) slower.
Passing Another Vehicle While
Using Cruise Control
Use the accelerator pedal to
increase the vehicle speed.
When you take your foot off the
pedal, the vehicle slows down to
the cruise control speed set earlier.
Using Cruise Control on Hills
The cruise control performance will
vary depending upon the vehicle
speed, load, and the steepness of
the hills.When going up steep hills, you might
have to step on the accelerator pedal
to maintain the vehicle speed.
When going downhill, you might
have to brake or shift to a lower gear
to keep the vehicle speed down.
Applying the brake or downshifting
to 2 SECOND or L LOW turns
off the cruise control.
Ending Cruise Control
There are several ways to turn off
the cruise control:
Step on the brake pedal or push
the clutch pedal, if the vehicle
has a manual transmission.
Press the ON-OFF button.
Pull the cruise control lever
toward you.
Erasing Speed Memory
The cruise control set speed memory
is erased when the cruise control or
the ignition is turned off.
4-6 Instruments and Controls
2009 - Pontiac Vibe Owner Manual

If the light comes on and stays on,
it means that oil is not owing
through the engine properly.
The vehicle could be low on oil and
might have some other system
problem.
Fog Lamp Light
For vehicles with this feature,
this light comes on whenever the
front fog lamps are on.
SeeExterior Lamps Controls on
page 5-1for more information.
Lights On Reminder
This light comes on whenever the
headlights are on.
SeeExterior Lamps Controls on
page 5-1for more information.
Taillamp Indicator Light
This light will come on when your
taillamps are on.
SeeExterior Lamps Controls on
page 5-1for more information.
Cruise Control Light
The CRUISE light comes on when
the cruise control is on.
SeeCruise Control on page 4-4for
more information.
Low Washer Fluid
Warning Light
This light comes on when the
windshield washer uid is low.
SeeWindshield Washer Fluid on
page 9-24for more information.
Canada Only
Canada Only
Instruments and Controls 4-23
2009 - Pontiac Vibe Owner Manual

Driving in Rain and on
Wet Roads
Rain and wet roads can reduce
vehicle traction and affect your
ability to stop and accelerate.
Always drive slower in these types
of driving conditions and avoid
driving through large puddles and
deep-standing or owing water.
{CAUTION
Wet brakes can cause crashes.
They might not work as well in
a quick stop and could cause
pulling to one side. You could
lose control of the vehicle.
After driving through a large
puddle of water or a car/vehicle
wash, lightly apply the brake
pedal until the brakes work
normally.
(Continued)
CAUTION (Continued)
Flowing or rushing water creates
strong forces. Driving through
owing water could cause your
vehicle to be carried away. If this
happens, you and other vehicle
occupants could drown. Do not
ignore police warnings and be
very cautious about trying to
drive through owing water.
Hydroplaning
Hydroplaning is dangerous. Water
can build up under your vehicle’s
tires so they actually ride on the
water. This can happen if the road
is wet enough and you are going
fast enough. When your vehicle is
hydroplaning, it has little or no
contact with the road.There is no hard and fast rule about
hydroplaning. The best advice is
to slow down when the road is wet.
Other Rainy Weather Tips
Besides slowing down, other wet
weather driving tips include:
Allow extra following distance.
Pass with caution.
Keep windshield wiping
equipment in good shape.
Keep the windshield washer uid
reservoir lled.
Have good tires with proper tread
depth. SeeTires on page 9-41.
Turn off cruise control, if
equipped.
Driving and Operating 8-27
2009 - Pontiac Vibe Owner Manual

{CAUTION
Coasting downhill in N (Neutral) or
with the ignition off is dangerous.
The brakes will have to do all the
work of slowing down and they
could get so hot that they would
not work well. You would then
have poor braking or even none
going down a hill. You could crash.
Always have the engine running
and the vehicle in gear when going
downhill.
Stay in your own lane. Do not
swing wide or cut across the
center of the road. Drive at
speeds that let you stay in
your own lane.
Top of hills: Be alert — something
could be in your lane (stalled car,
accident).
Pay attention to special road
signs (falling rocks area, winding
roads, long grades, passing or
no-passing zones) and take
appropriate action.
Winter Driving
Driving on Snow or Ice
Drive carefully when there is snow
or ice between the tires and the road,
creating less traction or grip. Wet ice
can occur at about 32°F (0°C) when
freezing rain begins to fall, resulting
in even less traction. Avoid driving on
wet ice or in freezing rain until roads
can be treated with salt or sand.
Drive with caution, whatever the
condition. Accelerate gently so
traction is not lost. Accelerating too
quickly causes the wheels to spin
and makes the surface under the
tires slick, so there is even less
traction.
Try not to break the fragile traction.
If you accelerate too fast, the drive
wheels will spin and polish the
surface under the tires even more.TheAntilock Brake System (ABS)
on page 8-20improves vehicle
stability during hard stops on
a slippery roads, but apply the
brakes sooner than when on
dry pavement.
Allow greater following distance
on any slippery road and watch for
slippery spots. Icy patches can occur
on otherwise clear roads in shaded
areas. The surface of a curve or an
overpass can remain icy when the
surrounding roads are clear. Avoid
sudden steering maneuvers and
braking while on ice.
Turn off cruise control, if equipped,
on slippery surfaces.
Driving and Operating 8-29
2009 - Pontiac Vibe Owner Manual