99
   Levels   
 CHECKS 
6
  Cooling  system  
 Only use the fluid recommended by the  
manufacturer.  
 Otherwise, you risk seriously damaging your  
engine.  
 When the engine is warm, the temperature  
of the coolant is controlled by the engine 
fan. As this fan can operate with the ignition 
key removed and because the cooling 
system is pressurised, wait for at least one 
hour after the engine has stopped before 
carrying out any work.  
 Slacken the cap by 1/4 of a turn to release  
the pressure to prevent any risk of scalding. 
When the pressure has dropped, remove the 
cap and top up the level with coolant.  
 If fluid has to be added frequently, this  
indicates a failure which must be checked by 
a  PEUGEOT  dealer as soon as possible.   Power  steering  fluid  level  
 The vehicle must be parked on level ground  
with the engine cold. Unscrew the cap 
integrated with the gauge and check the 
level which must be between the MIN and 
MAX marks.  
 When this occurs with the engine running it 
is due to the start of saturation of the particle 
emission filter (exceptionally prolonged 
urban type driving conditions: low speed, 
long traffic jams, ...).  
 In order to regenerate the filter, you are  
advised to drive at a speed higher than 
40 mph (60 km/h) for at least five minutes 
as soon as possible, when traffic conditions 
permit (until the message disappears and 
the service warning light is switched off).  
 During regeneration of the particle emission  
filter, relay noise may be heard under the 
fascia.  
 If the message is still displayed and if the  
service warning light remains on, contact a 
 PEUGEOT  dealer. 
  Topping up  
 The level must be between the MIN and  
MAX marks on the expansion bottle. 
If more than 1 litre of fluid is required to top 
up the level, have the system checked by a 
 PEUGEOT  dealer.      Windscreen  wash  and  headlamp  
wash  level  
 For best quality cleaning and for your safety,  
we would advise that you use products of 
the  PEUGEOT  Universal range.  
 Capacity of the screenwash reservoir:  
approximately 4.5 litres.  
 If your vehicle is fitted with headlamp  
washers, the capacity of the reservoir is 
7.5 litres.  
 To guarantee optimum cleaning and prevent  
freezing, this fluid must not be topped up or 
replaced with water.  
  Diesel  additive  level  (Diesel  
with  particle  emission  filter)  
 The minimum level of this additive  
is indicated by lighting of the 
service warning light, accompanied by 
an audible signal and a message on the 
display.    Topping up  
 It is imperative that this additive is topped up  
by a  PEUGEOT  dealer without delay.    
         
        
        116
   Changing  a  fuse   
 CHANGING A FUSE 
 The three fuse boxes are placed:  
   -   in the fascia panel on the right-hand side (behind the storage compartment,  
retractable), 
  -   in the passenger compartment (battery  compartment), 
  -   under the bonnet.   
 If fitted on your vehicle, a further fuse  
box is added for towing, the towbar and 
the connections for the coachbuilder and 
platform cab conversions. It is located on the 
right behind the load retaining partition. 
  Removing  and  fitting  a  fuse  
 Before changing a fuse, the cause of the  
fault must be found and rectified.  
   -   Use the pliers.     
Always replace a faulty fuse with a fuse  
of the same rating.   
  PEUGEOT  will not accept responsibility 
for the cost incurred in repairing your 
vehicle or for rectifying the malfunctions 
resulting from the installation of accessories 
not supplied and not recommended by 
 PEUGEOT  and not installed in accordance 
with its instructions, in particular when 
the combined consumption of all of the 
additional equipment connected exceeds 
10 milliamperes.  
 The descriptions communicated are only 
the fuses which can be changed by the 
user using the pliers and replacement fuses 
located behind the fascia panel storage 
compartment on the right-hand side. For any 
other operations, visit a  PEUGEOT  dealer. 
 Intended for professionals: for 
complete fuse and relay information, 
consult the "Methods" diagram via the 
Network.    
         
        
        120
   Changing  a  fuse   
 TOWING/TOWBAR/COACHBUILDERS/PLATFORM CAB FUSES 
 The descriptions communicated are an  
indication only as this additional box relates 
to other information which depends on the 
coachbuilder/vehicle modifier for which this 
document cannot act as a technical support.    
Fuses         A (amps)       Allocation   
   
1         15     Free 
   
2         15     Ignition relay and optional generator 
   
3         15     Trailer 12 V supply 
   
4         15     Permanent supply for vehicle modifiers 
   
5         10     Hazard warning lights