2009 Peugeot 607 Dag boot
[x] Cancel search: bootPage 116 of 182
1010
100
Access to the spare wheel and the
jack in the boot
Detach the luggage net.
Lift the boot carpet using the lifting
hook. Secure this hook behind the
boot seal.
CHANGING A WHEEL
Tools available
The following tools are located in the
polystyrene holder in the centre of the
spare wheel:
1. Wheelbrace.
2. Centralising tool.
3. Wheelbrace extension.
4. Jack.
5. Removable towing eye.
6. Alloy wheel trim remover.
7. Trim cover tool. Removal
F o r v e h i c l e s w i t h a l l o y w h e e l s fi t t e d
with wheel trims, pull the centre trim
by using tool 6 in one of the holes.
Loosen the wheel bolts.
Take the jack 4 from the tool kit .
Place the jack in one of the four
locations A underneath the vehicle
(the nearest one to the wheel to be
changed).
Extend the jack using wheelbrace 1
and the extension 3 .
Remove a wheel bolt at the top
a n d fi t t h e c e n t r a l i s i n g t o o l 2 in its
place.
Unscrew the other bolts and remove
the wheel.
Park the vehicle so that it does
n o t o b s t r u c t t r a f fi c : t h e g r o u n d
must be level, stable and non-
slippery.
Apply the handbrake, switch off the igni-
t i o n a n d e n g a g e fi r s t o r r e v e r s e g e a r ( p o -
sition P for the automatic gearbox).
It is imperative to ensure that the occu-
pants get out of the vehicle and wait in
a safe location.
Never go underneath a vehicle which is
supported only by a jack; use a ramp.
T h e j a c k a n d a l l o f t h e t o o l s a r e s p e c i fi c
to your vehicle. Do not use them for other
purposes.
Page 120 of 182
1010
104
Integrated direction indicator
repeaters Amber coloured bulbs, such
as the direction indicators and
side repeaters, must be re-
placed with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r . Rear lights
R e m o v e t h e t w o b u t t e r fl y n u t s s e -
curing the light.
Remove the eyelet.
Take out the lamp.
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
1. D i r e c t i o n i n d i c a t o r s : H p 1 6 .
2. Brake lights/side lights: Hp16.
Detach the luggage net.
Lift the boot carpet with the lifting
hook. Secure this hook behind the
boot seal.
Unclip the lower part of the sill trim,
then dislodge it by pulling upwards.
Remove the plastic retainer clip
s e c u r i n g t h e s i d e t r i m t o t h e fl o o r .
Unclip the side trim.
Push the repeater forwards and re-
lease it.
Remove the repeater and change it.
This can be obtained from a PEUGEOT
dealer. Rear wing lights
Page 121 of 182
1010
104
Integrated direction indicator
repeaters Amber coloured bulbs, such
as the direction indicators and
side repeaters, must be re-
placed with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r . Rear lights
R e m o v e t h e t w o b u t t e r fl y n u t s s e -
curing the light.
Remove the eyelet.
Take out the lamp.
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
1. D i r e c t i o n i n d i c a t o r s : H p 1 6 .
2. Brake lights/side lights: Hp16.
Detach the luggage net.
Lift the boot carpet with the lifting
hook. Secure this hook behind the
boot seal.
Unclip the lower part of the sill trim,
then dislodge it by pulling upwards.
Remove the plastic retainer clip
s e c u r i n g t h e s i d e t r i m t o t h e fl o o r .
Unclip the side trim.
Push the repeater forwards and re-
lease it.
Remove the repeater and change it.
This can be obtained from a PEUGEOT
dealer. Rear wing lights
Page 122 of 182
1010
105
Remove the three plastic retainer
clips securing the cover trim (those
nearest to the lamp).
Move aside the trim.
Disconnect the lamp harness.
Extract the lamp from its housing.
R e m o v e t h e fl a t s e a l .
Unclip the bulb holder.
Change the faulty bulb.
Clip the bulb holder.
P u t t h e fl a t s e a l b a c k i n p l a c e .
W h e n r e fi t t i n g i t , e n s u r e t h a t t h e l a m p
is correctly positioned and secured.
N u m b e r p l a t e l i g h t s : W 5 W.
Remove the transparent cover using
a screwdriver blade.
Change the faulty bulb.
Boot lid lights
1. Reversing lights: Hp16.
2. S i d e l i g h t s : H p 1 6 .
3. Fog lamps: Hp16.
I f y o u e n c o u n t e r a n y d i f fi c u l t i e s ,
contact a PEUGEOT dealer.
Page 123 of 182
1010
106
C H A N G I N G A F U S E
The fuse boxes are placed in the lower
part of the fascia (driver's side), in the
engine compartment (left-hand side)
and in the left boot trim.
R e p l a c i n g a f u s e
Before replacing a fuse, the cause of
the incident must be found and recti-
fi e d . T h e f u s e n u m b e r s a r e i n d i c a t e d
on the fuse box.
Correct Incorrect
F u s e N ° Rating F u n c t i o n s
F31 5 A Right-hand brake light.
F32 5 A Left-hand brake light.
F33 5 A Third brake light.
F34 - Not used.
F35 5 A
T y r e u n d e r - i n fl a t i o n d e t e c t i o n c o n t r o l u n i t , C D c h a n g e r .
F36 30 A Passenger seat relay.
F37 30 A Passenger and rear right heated seats.
F38 30 A Driver's and rear left heated seats.
F39 30 A Driver's seat relay.
F40 5 A Diagnostics socket.
Always replace a faulty fuse
with a fuse of the same rating
(same colour).
Use the special pliers located
on the support next to the fuse box,
this support also contains the replace-
ment fuses.
F a s c i a f u s e s
To access the fuses, open the cover
of the storage compartment on the
driver's side. Tilt the fuse box down-
wards.
Page 124 of 182
1010
106
C H A N G I N G A F U S E
The fuse boxes are placed in the lower
part of the fascia (driver's side), in the
engine compartment (left-hand side)
and in the left boot trim.
R e p l a c i n g a f u s e
Before replacing a fuse, the cause of
the incident must be found and recti-
fi e d . T h e f u s e n u m b e r s a r e i n d i c a t e d
on the fuse box.
Correct Incorrect
F u s e N ° Rating F u n c t i o n s
F31 5 A Right-hand brake light.
F32 5 A Left-hand brake light.
F33 5 A Third brake light.
F34 - Not used.
F35 5 A
T y r e u n d e r - i n fl a t i o n d e t e c t i o n c o n t r o l u n i t , C D c h a n g e r .
F36 30 A Passenger seat relay.
F37 30 A Passenger and rear right heated seats.
F38 30 A Driver's and rear left heated seats.
F39 30 A Driver's seat relay.
F40 5 A Diagnostics socket.
Always replace a faulty fuse
with a fuse of the same rating
(same colour).
Use the special pliers located
on the support next to the fuse box,
this support also contains the replace-
ment fuses.
F a s c i a f u s e s
To access the fuses, open the cover
of the storage compartment on the
driver's side. Tilt the fuse box down-
wards.
Page 128 of 182
1010
110
C H A N G I N G A W I N D S C R E E N
W I P E R B L A D E
Placing the wiper blades in the
maintenance position
Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
E N E R G Y E C O N O M Y M O D E
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, sunroof, electric seats,
audio equipment, telephone, dipped
headlamps, video, etc.) can only be
used for a limited combined duration,
to prevent discharging of the battery.
Once this period has elapsed, a
switching to economy mode message
appears on the multifunction display
and the active functions are put on
standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to exit the economy mode and
resume the use of these functions im-
mediately, the engine must be started
and left to run for a few minutes.
If the engine has been running for at
least 10 minutes, all of the functions
are active for 30 minutes.
If the engine has been running for
less than 10 minutes, this duration
before returning to economy mode is
5 minutes. All of these functions are
available when the engine is
running.
If the telephone is being used
when economy mode starts, it will still
b e p o s s i b l e t o fi n i s h t h e c a l l .
L O A D R E D U C T I O N F U N C T I O N
When driving, certain functions (air con-
ditioning, heated rear screen, heating
system for passenger compartment of
diesel vehicles, etc.) may be switched
off temporarily, depending on the level
of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
s u f fi c i e n t .
Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated manually.
Replacing a blade
Lift the arm, then unclip the blade
and remove it.
Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. A fl a t b a t t e r y p r e v e n t s t h e e n -
gine from starting.
If the doors or boot are opened
several times or if the alarm is
triggered, this may result in activation
of the energy economy mode.
Page 129 of 182
1010
111
BATTERY
The battery is located behind the left
boot trim.
TOWING YOUR VEHICLE
Lifting (2 wheels only on the road)
It is preferable to raise the vehicle using
professional lifting equipment.
N e v e r u s e t h e r a d i a t o r c r o s s m e m b e r .
When towing with the engine
switched off, there is no brak-
ing or steering assistance.
S p e c i a l f e a t u r e s o f t h e a u t o m a t i c g e a r b o x
Towing a vehicle with an automatic
gearbox in reverse gear is prohibited
(absence of lubrication).
W i t h o u t l i f t i n g (4 wheels on the road)
You should always use a towbar.
The towing eye is inside the spare
wheel.
When being towed with all
four wheels on the ground, it
is imperative that the following
rules are obeyed:
- selector lever in position N ,
- the vehicle must be towed at a speed of less than 30 mph (50 km/h) over
a maximum distance of 30 miles
(50 km),
- do not add oil to the gearbox.
From the front:
Carefully unclip the bottom of the
cover, using a small screwdriver.
Screw in the towing eye until it
locks.
From the rear:
Carefully unclip the top of the cover
using a small screwdriver.
Screw in the towing eye until it
locks. To disconnect the battery:
pull the handle downwards and
fold back the panel to gain access
to the battery,
disconnect the green terminal (-) of
the battery.
It is advisable to disconnect
the battery if the vehicle is not
to be used for a period of more
than one month.
V e h i c l e s f i t t e d w i t h a m a n u a l g e a r b o x ( D i e s e l v e r s i o n )
O n v e h i c l e s fi t t e d w i t h a m a n u a l g e a r -
box, the gear lever must be in neutral.
Failure to observe this special condi-
tion may result in damage to certain
braking components and the absence
of braking assistance when the engine
is restarted.