3COMFORT
52
Head restraint height and angle
adjustment Front seat active head restraint
T h i s s y s t e m p r e v e n t s " w h i p l a s h " .
I n t h e e v e n t o f a r e a r i m p a c t , t h e a c t i o n
o f t h e b o d y o n t h e s e a t b a c k m o v e s
t h e h e a d r e s t r a i n t f o r w a r d s a n d u p -
w a r d s p r e v e n t i n g t h e h e a d f r o m b e i n g
t h r o w n b a c k .
Front armrest Driver's seat lumbar adjustment
Heated seats adjustment
0
: O f f .
1
: L o w .
2
: M e d i u m .
3
: H i g h .
The adjustment is correct when
t h e t o p o f t h e h e a d r e s t r a i n t i s
a l i g n e d w i t h t h e t o p o f t h e h e a d
o f t h e o c c u p a n t o f t h e s e a t .
Never drive with the head re-
straints removed and stored in
t h e v e h i c l e . T h i s i s d a n g e r o u s
a n d t h e y m a y b e t h r o w n i n t h e
e v e n t o f s h a r p b r a k i n g . T h e y m u s t b e
i n p l a c e a n d a d j u s t e d c o r r e c t l y .
T o c h a n g e t h e p o s i t i o n o f t h e a r m r e s t :
Lift the handle 1 .
T h e a r m r e s t f o l d s f o r w a r d s a n d u p -
w a r d s .
T o r e t u r n t o t h e i n i t i a l p o s i t i o n , p u s h
t h e a r m r e s t b a c k w a r d s a n d p r e s s i t t o
e n g a g e .
O p e r a t e t h e l e v e r t o o b t a i n t h e c o r r e c t
p o s i t i o n . To raise or lower the head restraint,
p u l l i t f o r w a r d s t h e n s l i d e i t .
To tilt the head restraint, tilt the lower
p a r t f o r w a r d s o r b a c k w a r d s .
To remove the head restraint, move it
a l m o s t t o t h e h i g h e s t p o s i t i o n , l i f t t h e
t a b u s i n g a c o i n a n d p u l l i t f o r w a r d s
a n d u p w a r d s a t t h e s a m e t i m e .
T o r e fi t t h e h e a d r e s t r a i n t , e n g a g e t h e
s t a l k s i n t h e h o l e s k e e p i n g i n l i n e w i t h
t h e s e a t b a c k .
W i t h t h e e n g i n e r u n n i n g , t u r n t h e d i a l .
T h e t e m p e r a t u r e o f t h e s e a t i s r e g u l a t e d
a u t o m a t i c a l l y .
7SAFETY
87
SEAT BELTS
Detection of fastening of the front
seat belts
When the ignition is switched on , if a
front passenger has not fastened his seat
belt and if the vehicle speed is below
13 mph (20 km/h) , you are warned by
lighting of the seat belt warning light .
The warning light switches off when the
seat belt(s) concerned is(are) fastened.
If the vehicle speed is above 13 mph
(20 km/h) , y o u a r e w a r n e d b y fl a s h i n g
of the seat belt warning light , an
audible signal and a message on the
multifunction display locating the un-
fastened seat belt(s).
Front seat belts with
pre-tensioner and force
limiter
In the event of a serious front impact,
the pre-tensioning system instantly
t i g h t e n s t h e s e a t b e l t s fi r m l y a g a i n s t
the bodies of the occupants.
The pre-tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pressure
of the seat belt against the chest of the
occupant, so increasing his protection.
Rear seat belts
T h e r e a r s e a t s a r e a l l fi t t e d w i t h a
three-point inertia reel seat belt.
The rear side seat belts have a force
l i m i t e r a n d m a y b e fi t t e d w i t h a p r e -
tensioning inertia reel.
To fasten the seat belts
Pull the strap, then insert the
tongue into the buckle.
Check that the seat belt is secured
correctly by pulling the strap.
To unfasten the seat belts
Press the red button on the buckle. Before folding the seat back, pull the
strap and insert the seat belt tongue
into the buckle. This precaution will
ensure that each seat belt is in place
when the rear seats are lifted again.
Note: a bag or an animal
placed on the front passenger
seat may trigger the lighting of
the warning light.
The audible signal ceases and the
warning light switches off when the
seat belt concerned is fastened.
After two minutes without any action on
t h e s e a t b e l t s , t h e fl a s h i n g w a r n i n g l i g h t
remains on permanently and the audible
signal ceases. All of the warnings cease
when a door is opened or when the
engine is switched off.
Front seat belt height adjustment:
To lower the attachment point,
squeeze control 1 and slide it
downwards,
To raise the attachment point, slide
control 1 upwards.
