Page 77 of 113
72
CHANGING A WHEEL
Operating procedure for replacing a
faulty wheel with the spare wheel using
the tools provided with the vehicle.
Parking the vehicle
- If possible, park the vehicle on level, stable and non-slippery ground.
- A p p l y t h e h a n d b r a k e , e n g a g e fi r s t o r reverse gear. Access to the spare wheel and
the jack
The wheel is located outside the
vehicle, under the boot, supported by a
metal carrier.
- Remove the wheelbrace
1 , secured
on the rear right inner panel of
the boot .
- Using the wheelbrace 1 , slacken the
spare wheel carrier retaining bolt,
located inside the boot under the
carpet .
- Lift the carrier to release the hook rearwards, then lower it.
- Remove the jack storage case 2
located in the spare wheel. Removing a wheel
- Chock the rear of the wheel diagonally
opposite the wheel to be changed.
- Remove the wheel trim using the wheelbrace, by pulling at the valve
passage hole.
- Slacken the wheel bolts.
- Place the jack under the locating point on the sub-frame E that is
closest to the wheel to be changed.
Ensure that the entire surface of the
jack base plate is in contact with the
ground.
- Extend the jack, completely unscrew the bolts and remove the wheel.
Page 78 of 113
!
73
Fitting the wheel
- Once the wheel is in place, pre-tight-en it lightly using the wheelbrace.
- Fold the jack and remove it.
- Tighten the bolts using the wheel- brace.
- R e fi t t h e w h e e l t r i m s t a r t i n g a t t h e valve passage hole and press with
the palm of the hand. Putting the wheel back in place
- Put the jack storage case back in
the wheel.
- Put the wheel back in the carrier.
- Raise the wheel, then the carrier and reposition the hook.
- Do not forget to retighten the spare wheel carrier retaining bolt fully.
- Stow the wheelbrace. For your safety, always change a
wheel:
- on level, stable and non slip-
pery ground,
- with the handbrake applied, ignition off,
- w i t h fi r s t o r r e v e r s e g e a r e n - gaged,
- with the vehicle chocked,
- never go underneath a vehicle raised using a jack (use an
axle stand).
After changing the wheel
- Have the tightening of the bolts and the pressure of the
spare tyre checked as soon
as possible by a PEUGEOT
dealer.
- Have the punctured tyre re- paired and replace it on the
vehicle as soon as possible.
Page 80 of 113
75
SPECIAL FEATURES OF ALLOY WHEELS
Bolt covers
Alloy wheel bolts are covered by chrome
trims.
Use the yellow tool 4 to remove the
trims before slackening the bolts.
The yellow tool 4 is located:
- in the glove box or,
- in the jack storage case. Fitting the spare wheel
If your vehicle is equipped with a steel
s p a r e w h e e l , w h e n fi t t i n g i t , i t i s
normal
to notice that the bolt washers do not
come into contact with the rim. The
spare wheel is secured by the cone
shape of each bolt.
Fitting snow tyres
I f y o u fi t s n o w t y r e s t h a t a r e m o u n t e d o n
steel rims on your vehicle, it is essential
that you use special bolts available from
PEUGEOT dealers.
