Page 13 of 113
!
16
The indicator/warning light comes
o n c o n t i n u o u s l y o r fl a s h e s .
Some indicator/warning lights may
light in two different ways. Only by
relating the type of lighting to the
vehicle operating status can it be
ascertained whether the situation
is normal or whether a fault has oc-
curred.
Indicator and warning lights
Visual indicators which inform the driver
when a system comes into operation
(operation or deactivation indicator
lights) or of the occurrence of a fault
(warning light).
Associated warnings
The lighting of certain indicator/warning
lights may be accompanied by an audible
signal and a message on the multifunc-
tion display. Operation indicator lights
The lighting of one of the following indi-
c a t o r l i g h t s c o n fi r m s t h a t t h e c o r r e s p o n d -
ing system has come into operation.
Left-hand direction indicator.
Handbrake applied.
Right-hand direction indicator.
Main beam headlamps.
Dipped headlamps.
Diesel engine pre-heating.
Wait until this switches off
before operating the starter.
Front fog lamps.
Rear fog lamps.
When the ignition is switched on
The warning lights come on for a few
seconds when the vehicle ignition is
switched on.
When the engine is started, these warn-
ing lights should switch off.
If they remain on, before moving off,
consult the text relating to the warning
light concerned.
Page 49 of 113
i
47
LIGHTS STALK
System for selecting and controlling the
various front and rear lights providing
the vehicle's lighting. Manual controls
Lights off
Side lights
Dipped/Main beam
headlamps
Lighting
The various front and rear lights of the
vehicle are designed to improve the
driver's visibility in relation to the exte-
rior conditions:
- side lights, to be seen,
- dipped headlamps, to see without
dazzling other drivers,
- main beam headlamps, for good visibility when the road is clear,
- rear fog lamp, to be seen from a distance,
- front fog lamps, for even better visibility.
Programming
Various automatic lighting control
modes are also available according to
the following options:
- follow-me-home lighting,
- automatic lighting. Selection is by turning ring
A .
Automatic switching on of
lights Lights on reminder
With the ignition off and the automatic
lighting function switched off, when the
driver's door is opened, a buzzer sounds
if you have left your lights on.
Front fog lamps and rear fog
lamp
Rotate the ring forwards to switch on
and backwards to switch off. The status
i s c o n fi r m e d b y t h e i n d i c a t o r l i g h t o n t h e
instrument panel.
V e h i c l e s fi t t e d w i t h a r e a r f o g
lamp (ring B)
Dipped/Main beam change
Pull the stalk towards you. When the lights are switched off
automatically, the rear fog lamp
and the dipped headlamps re-
main on (turn the ring backwards
to switch off the rear fog lamp.
The dipped headlamps and side
lights then switch off).
This only operates with the dipped/main
beam headlamps.
Page 81 of 113
i
76
CHANGING A BULB
Front lights
1. Direction indicators
(PY21 W amber).
2. Side lights (W 5 W).
3. Dipped headlamps (H7-55 W).
4. Main beam headlamps (H1-55 W).
5. Fog lamps (PSX-24 W).
Operating procedure for replacing a
faulty bulb with a new bulb. These
operations must be carried out
with the
ignition off .
To gain access to the bulbs on the right-
hand side:
- Remove the screenwash reservoir fi l l e r t u b e .
- Unclip the engine harness 1 .
- Remove the nut from the engine control unit support 2 using a size
10 spanner.
- Remove the engine control unit and support assembly. After changing the faulty bulb:
- Slide the two lugs of the control unit
support into the locations A .
- Put the engine control unit back in place.
- Tighten the engine control unit sup- port nut (size 10 spanner).
- Reclip the engine harness.
These bulbs are available from
PEUGEOT dealers.
In certain climatic conditions (low
temperature, humidity), conden-
sation inside the glass of the
headlamps and lights is normal .
However, contact a PEUGEOT
dealer if water is present in the
headlamps.
Page 89 of 113
83
or
Fuse N° Rating Functions
1 10 A Pre-heat unit (diesel) - Water in diesel sensor -
R e v e r s i n g l i g h t s w i t c h - S p e e d s e n s o r - A i r fl o w
sensor (diesel)
2 15 A Canister solenoid valve - Fuel pump
3 10 A ABS engine control unit
4 10 A Engine control unit
5 - Not used
6 15 A Front fog lamps
7 - Not used
8 20 A Fan assembly relay - Engine control unit - Diesel
injection pump - Diesel high pressure regulator -
Engine management solenoid valve
9 15 A Left-hand dipped beam
10 15 A Right-hand dipped beam 11 10 A Left-hand main beam
12 10 A Right-hand main beam
13 15 A Horn
14 10 A Front and rear windscreen wash pumps
15 30 A Throttle housing heater - Diesel injection pump -
O x y g e n s e n s o r - E n g i n e c o n t r o l u n i t - A i r fl o w
sensor - Ignition coil - Engine management
solenoid valve - Diesel heater - Injectors
16 30 A Air pump relay
17 30 A High and low speed windscreen wiper
18 40 A Air conditioning fan
Engine compartment fuse box
To gain access to the box in the engine
compartment (next to the battery), un-
clip the cover.
After carrying out work, close the cover
very carefully.