2009 Peugeot 206 P Dag display

!
67
Programming

 Turn dial 1 to the "LIMIT" position:
the speed limiter mode is selected
but is not switched on (OFF).
Exceeding the programmed speed
Pressing the accelerator pedal to exceed the programmed
speed will not have any effect unless you press the pedal

fi rmly past the point of resistance .
The speed limiter is deactivated temporarily and the pro-
grammed speed, which is still displayed, fl ashes.
Returning to the programmed speed, by means of int entional
or unintentional deceleration of the vehicle, automaticall y
cancels the fl ashing of the programmed speed. Return to normal driving

 Turn dial 1 to the "0" position: the
speed limiter mode is deselected.
The display returns to the distance
recorder.
You do not have to switch the speed
limiter on in order to set the speed.

 Switch the speed limiter off by pressing button 4 : the dis-
play confi rms that it has been switched off (OFF).

 Switch the speed limiter back on by pressing button 4
again.

 Set the speed value by pressing button 2 or 3 (e.g.:
55 mph (90 km/h)).
You can then change the programmed speed using buttons

2 and 3 :
- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.

 Switch the speed limiter on by pressing button 4 . Operating fault
In the event of a speed limiter malfunc-
tion, the speed is cleared resulting in
fl ashing of the dashes.
Have the system checked by a PEUGEOT
dealer.
On a steep descent or in the event
of sharp acceleration, the speed
limiter will not be able to prevent
the vehicle from exceeding the pro-
grammed speed.
To avoid any risk of jamming of the
pedals:
- ensure that the mat is posi-tioned correctly,
- do not fi t one mat on top of an- other.

82

Fuse N° Rating
Functions
1 - Not used
4 20 A Multifunction display - Boot lighting - Audio equipment - Steering wheel controls - Trailer
5 - Not used
6 10 A Coolant level - Audio equipment
7 15 A Driving school accessory - Alarm fi tted as an accessory
9 - Not used
10 40 A Rear screen demisting 11 15 A Rear windscreen wiper
12 30 A Front electric windows
14 10 A Engine fuse box - Air bags - Steering wheel con trols - Rain sensor
15 15 A Instrument panel - Multifunction display - Air conditioning - Audio equipment
16 30 A Locking/unlocking controls for doors, bonnet a nd boot
20 10 A Right-hand brake light
21 15 A Left-hand brake light - 3rd brake light
22 20 A Front courtesy light - 12 volt accessories socket
S1 Shunt PARC shunt

!i
86
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, cer-
tain functions (windscreen wiper, cour-
tesy lights, audio equipment, dipped
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
proximately fi fteen minutes, to prevent
discharging of the battery.
Once the fi fteen minutes are over, the
message "Economy mode active" ap-
pears on the multifunction display and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
between fi ve and fi fteen minutes.
A fl at battery will prevent the en-
gine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle towed.
Towing your vehicle


On the front bumper, unclip the cover A
to gain access to the towing eye.

 Switch on the hazard warning lights
on the towed vehicle.

 Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components and
the absence of braking assistance
the next time the engine is started.