Page 82 of 113
i
77
Turn the bulb holder a quarter turn
and remove it.
Pull the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
s p e c i fi c a t i o n a n d c o l o u r .
Direction indicators
Disconnect the headlamp main con-
nector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Pull the bulb and change it. Dipped headlamps
Disconnect the headlamp main con-
nector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Press the connector downwards to
release the bulb.
Pull the bulb and change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
Side lights
Page 83 of 113
!
78
Front fog lamp
Slide a hand under the bumper.
Turn the connector a quarter turn
and remove the assembly.
Remove the bulb and change it.
Main bean headlamps
Disconnect the headlamp main con-
nector, pulling the red control.
Remove the plastic protective cover
turning it a quarter turn.
Move aside the springs to release
the bulb and pull the bulb.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order. Direction indicator side repeater
Push the repeater forwards and
release it.
Remove the repeater and change it.
Repeaters can be obtained from a
PEUGEOT dealer.
High pressure washing
When using this type of washing
on stubborn dirt, do not persist
on the headlamps, the lights and
their surround to avoid damaging
their coating and their seal.
Page 92 of 113
!i
86
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, cer-
tain functions (windscreen wiper, cour-
tesy lights, audio equipment, dipped
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
p r o x i m a t e l y fi f t e e n m i n u t e s , t o p r e v e n t
discharging of the battery.
O n c e t h e fi f t e e n m i n u t e s a r e o v e r , t h e
message "Economy mode active" ap-
pears on the multifunction display and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
b e t w e e n fi v e a n d fi f t e e n m i n u t e s .
A fl a t b a t t e r y w i l l p r e v e n t t h e e n -
gine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle towed.
Towing your vehicle
On the front bumper, unclip the cover A
to gain access to the towing eye.
Switch on the hazard warning lights
on the towed vehicle.
Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components and
the absence of braking assistance
the next time the engine is started.
