2009 Peugeot 206 P Dag seats
[x] Cancel search: seatsPage 4 of 113
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1. Speed limiter/cruise control switch.
2. Steering wheel height adjustment
control.
3. Lights and direction indicators
control.
4. Instrument panel
Instrument panel lighting rheostat.
5. Driver's air bag.
Horn.
6. Handbrake.
7. Front electric window controls.
8. Central locking control.
9. Bonnet opening control.
10. Fuse box.
11. Headlamp height adjustment.
12. Passenger air bag disarming.
13. Heated seats control.
14. Deactivation of the ESP/ASR.
Page 6 of 113
FAMILIARISATION
SIT COMFORTABLY
Front seat adjustments
1. Forwards-backwards adjustment.
2. Head restraint height adjustment.
3. Seat back angle adjustment.
32
4. Access to the rear seats (3-door).
5. Height adjustment. Steering wheel adjustment
1. Unlocking of the control.
2. Adjustment of the height.
3. Locking of the control.
38
Page 10 of 113
FAMILIARISATION
MONITOR THOROUGHLY
1. When the ignition is on, the orange
and red warning lights come on.
2. When the engine is running, these
warning lights should switch off.
If warning lights remain on, refer to the
page concerned.
Warning lights
16
Instrument panel
A. When the ignition is on, the fuel
gauge needle should rise.
B. When the engine is running, the
associated low level warning light
should switch off.
If the levels are not correct, top up as
required.
15 Controls
A. Passenger air bag disarming.
58
B. Heated seats control.
33
C. Deactivation of the ESP/ASR.
54
D. Central locking/unlocking.
44
Page 24 of 113
26
VENTILATION
System which creates and maintains
comfortable conditions in the vehicle's
passenger compartment.
Air treatment
The incoming air follows various routes
depending on the controls selected by
the driver:
- direct arrival in the passenger com-partment (air intake),
- passage through a heating circuit (heating),
- passage through a cooling circuit (air conditioning). The temperature control enables you to
obtain the level of comfort required by
mixing the air of the various circuits.
The air distribution control enables you
to diffuse the air in the passenger com-
partment combining several air vents.
T h e a i r fl o w c o n t r o l e n a b l e s y o u t o i n -
crease or reduce the speed of the ven-
tilation blower.
The air circulating in the passenger
c o m p a r t m e n t i s fi l t e r e d a n d o r i g i n a t e s
either from the outside via the grille lo-
cated on the bonnet or from the inside
in air recirculation mode.
Control panel
The controls of this system are grouped
together on the centre console. De-
pending on the model, the functions of-
fered are:
- the level of comfort required,
- t h e a i r fl o w ,
- the air distribution,
- the de-icing and demisting,
- the manual or automatic air condi-
tioning controls.
Air diffusion
1. Windscreen de-icing or demisting
vents.
2. Front side window de-icing or de-
misting vents.
3. Side adjustable and closing vents.
4. Central adjustable and closing vents.
5. Air outlets to the front footwells.
6. Lower air outlets (under the front
seats) * .
*
Only operational with automatic air
conditioning.
Page 25 of 113
i
27
The air conditioning system does
not contain chlorine and does not
present any danger to the ozone
layer.
In order for these systems to be fully effective, follow the operation and main-
tenance rules below:
If the interior temperature remains very high after the vehicle has been
parked in the sun for a considerable time, do not hesitate t o ventilate the
passenger compartment for a few minutes.
P l a c e t h e a i r fl o w c o n t r o l a t a s u f fi c i e n t l e v e l t o p r o v i d e a n a d e q u a t e r e -
newal of air in the passenger compartment.
To obtain an even air distribution, take care not to obst ruct the exterior air
intake grille located on the bonnet, the vents and the a ir passages under
the front seats.
Operate the air conditioning system for 5 to 10 minutes, on ce or twice a
month to keep it in perfect working order.
E n s u r e t h a t t h e p a s s e n g e r c o m p a r t m e n t fi l t e r i s i n g o o d c o n d i t i o n a n d
h a v e t h e fi l t e r e l e m e n t s r e p l a c e d r e g u l a r l y ( r e f e r t o t h e " C h e c k s " s e c t i o n ) .
W e r e c o m m e n d t h e u s e o f a c o m b i n e d p a s s e n g e r c o m p a r t m e n t fi l t e r .
T h a n k s t o i t s s e c o n d s p e c i a l a c t i v e fi l t e r , i t c o n t r i b u t e s t o t h e p u r i fi c a t i o n
of the air breathed by the occupants and the cleanness of th e passenger
compartment (reduction of allergic symptoms, bad odours and greasy
deposits).
To guarantee correct operation of the air conditioning syste m, you are also
advised to have it checked regularly.
If the system does not produce cold air, do not use it and contact a
PEUGEOT dealer.
When towing the maximum load on a steep gradient in high temperatures,
switching off the air conditioning permits the recovery of engi ne power and
therefore improvement of the towing capacity.
The condensation created by the air conditioning results in a discharge of
water under the vehicle which is perfectly normal.
Page 32 of 113
!i
33
1 - F o r w a r d s - b a c k w a r d s a d j u s t m e n t
Lift the control and slide the seat for-
wards or backwards.
2 - H e i g h t a d j u s t m e n t
Pull the handle upwards.
Remove your weight from the seat to
raise, or press on the seat to lower.
3 - A c c e s s t o t h e r e a r s e a t s
(3-door), A or B according to model
A. P l a c e y o u r fi n g e r s i n o n e o f t h e t w o
handles and push forwards to fold
down the seat back and move the
seat forwards.
When put back, the seat returns to its initial position.
No person or object must prevent the seat from returning to its initial
position. Returning to this position is
necessary for the seat to lock. 4 - Seat back angle adjustment
Push the handle towards the rear.
5 - H e a d r e s t r a i n t h e i g h t a d j u s t m e n t
To raise the head restraint, pull it up-
wards.
T h e a d j u s t m e n t i s c o r r e c t w h e n t h e
u p p e r e d g e o f t h e h e a d r e s t r a i n t i s
l e v e l w i t h t h e t o p o f t h e h e a d .
T h e h e a d r e s t r a i n t i s fi t t e d w i t h a f r a m e
with notches, which prevent the head
restraint dropping down (this is a safety
device in case of impact).
FRONT SEATS
Seat consisting of a seat cushion, seat
back and head restraint which can all
be adjusted to your optimum driving
and comfort position.
Never drive with the head re-
straints removed; they should be
in place and correctly adjusted.
It is impossible to access the rear
seats if the front seat is in a reclin-
ing position.
Heated seats
Press the switch, located on the con-
trol bar next to the steering wheel. The
temperature is regulated automatically.
Press again to switch off.
R e a r h e a d r e s t r a i n t
These have a position for use (high)
and a position for storage (low).
To lower the head restraints, press the
lug.
They can also be removed.
To remove the head restraints, pull up-
wards as far as the stop then press the
release control.
To lower the head restraint, push simul-
taneously:
- the button on the left-hand guide at
the base of the head restraint frame,
- the head restraint downwards.
To remove the head restraint, press the lug.
B. P l a c e y o u r fi n g e r s i n o n e o f t h e t w o
handles and push forwards to fold
down the seat back. The seat does
not move forwards.
When put back, the seat back re- turns to its initial angle.
Page 33 of 113
!!
34
REAR SEATS
- position the seat belt under the belt holder 2 ,
- pull control 3 to unlock the seat
back 4 ,
- remove or lower the head restraint,
- tilt the seat back 4 . When repositioning:
- return the seat back to the upright
position,
- fold back the seat cushion,
- reposition the seat belt buckles before locking the front of the seat
cushion.
- check that the seats are locked cor- rectly.
Control 3 must be in the low position.
Rear seat or bench seat which can be
folded to adapt the load space in the
boot.
To fold the rear seats:
- lift the front of the seat cushion
1 ,
- tilt the seat cushion 1 against the
front seats,
T a k e c a r e n o t t o t r a p t h e s e a t
belts.
A l w a y s s t a r t w i t h t h e s e a t , n e v e r
t h e s e a t b a c k ( r i s k o f d a m a g e ) .
Page 34 of 113
!!
35
BENCH SEAT
- position the seat belt under the belt holder 2 ,
- pull the controls 3 to unlock the seat
back 4 ,
- remove or lower the head restraints,
- tilt the seat back 4 . When repositioning:
- return the seat back to the upright
position,
- fold back the seat cushion,
- reposition the seat belt buckles before locking the front of the seat
cushion.
- check that the bench seat is secured fi r m l y .
The controls 3 must be in the low
position.
To fold the bench seat:
- lift the front of the seat cushion
1 ,
- tilt the seat cushion 1 against the
front seats,
T a k e c a r e n o t t o t r a p t h e s e a t
belts.
A l w a y s s t a r t w i t h t h e s e a t , n e v e r
t h e s e a t b a c k ( r i s k o f d a m a g e ) .