177
Self-help, vehicle care
Picture no: 14763s.tif
The edge of the jack base must be
planted firmly and vertically in line with
the contact point.
Raise vehicle by turning crank handle.
If this is not the case, carefully lower the
vehicle immediately and reposition the
jack.
5. Unscrew the wheel bolts.
Picture no: 11647s.tif
If the wheel bolt s have retaining
washers 3, they must not be removed.
6. Change wheel. Notes on spare wheel 3172. Notes on temporary spare wheel
3 173.
7. Screw in the wheel bolts. Push the wheel bolt wrench 3 on as far as possible and
tighten the wheel bolts slightly.
8. Lower vehicle.
9. Push the wheel bolt wrench 3 on as far
as possible and tighten crosswise.
Tightening torque is 110 Nm. 10. Before refitting the wheel trim, clean the
wheel around the retaining clips. Valve
symbol 3 on back of wheel trim must
point towards valve on wheel.
Align and refit wheel trim or wheel bolt
caps 3.
Alloy wheels 3: put hub cap on and
engage, inserting pin on rear of hub
cap into relevant hole in wheel.
Alloy wheels with anti-theft lock 3: Put
hub cap on. Insert and tighten anti-
theft lock 3.
11. Stow removed wheel, tool kit and warning triangle in the luggage
compartment 3171.
12. Check the tyre pressure of the newly mounted wheel.
13. Have the wheel bolt tightening torque (110 Nm) checked.
14. Replace the faulty tyre on the wheel that was removed.
228 Technical DataTyres Restrictions
Not all tyres available on the market
currently meet the structural requirements.
We recommend that you consult an Opel
Partner concerning suitable tyre makes.
These tyres have undergone special tests
to establish their reliability, safety and
specific suitability for Opel vehicles.
Despite continuous market monitoring, we
are unable to assess these attributes for
other tyres, even if they have been granted
approval by the relevant authorities or in
some other form.
Further information 3153. Winter tyres
3
Tyres of size 205/50 R 16 are not suitable
for use as winter tyres except on vehicles
with the Z 16 LET engine.
Tyres of size 205/45 R 17 are not suitable
for use as winter tyres. If winter tyres are in use, the spare wheel
may still be fitted with a summer tyre. Use
of the spare wheel may alter vehicle
handling. Obtain a replacement for the
faulty tyre as soon as possible, and have
the wheel balanced and fitted to the
vehicle.
Further information 3
157.
Tyre chains
3
Tyre chains may be used on the front
wheels only.
We recommend the use of tyre chains with
a fine mesh that add no more than 10 mm
to the running surface and the insides of
the tyres (including chain lock).
Tyre chains are not permitted on tyre
sizes 205/50 R 16 and 205/45 R 17.
Further information 3157. Wheels Wheel bolt tightening torque: 110 Nm.
Spare wheel
3
Depending on model, the spare wheel is
designed as a temporary spare wheel 3.
When using the spare wheel, the driving
behaviour may be modified. Replace the
faulty tyre as soon as possible, balance the
wheel and refit to vehicle. Follow the notes
on this page and 3157, 3173.
On vehicles with alloy wheels 3 the spare
wheel may have a steel rim.
The spare wheel can be fitted with a
smaller tyre
1)and a smaller rim than the
wheels fitted on the vehicle.
Tyre pressure (overpressure) The specified tyre pressures are valid for
cold tyres. The increased tyre pressure
resulting from extensive driving must not
be reduced. The tyre pressures specified on
the following pages apply to both summer
and winter tyres.
The spare wheel must always be inflated to
the tyre pressure for a full load – see table
on following pages.
Further information 3153 to 3157. 1)Country-specific version: The spare wheel is
only to be used as a temporary spare wheel.