
Black plate (277,1)
Model "S35-D" EDITED: 2008/ 7/ 24
CAUTION
Always use tires of the same type, size,
brand, construction (bias, bias-belted
or radial) , and tread pattern on all four
wheels. Failure to do so may result in a
circumference difference between tires
on the front and rear axles which will
cause excessive tire wear and may
damage the transmission, transfer case
and differential gears (AWD models) .Wheel balanceUnbalanced wheels may affect vehicle handling
and tire life. Even with regular use, wheels can
get out of balance. Therefore, they should be
balanced as required.
Wheel balance service should be per-
formed with the wheels off the vehicle.
Spin balancing the wheels on the vehicle
could lead to mechanical damage.
For additional information regarding tires, refer
to “Important Tire Safety Information” (US) or
“Tire Safety Information” (Canada) in the War-
ranty Information Booklet.Care of wheels.Wash the wheels when washing the vehicle
to maintain their appearance..Clean the inner side of the wheels when the
wheel is changed or the underside of the
vehicle is washed.
.Do not use abrasive cleaners when washing
the wheels.
.Inspect wheel rims regularly for dents or
corrosion. Such damage may cause loss of
pressure or poor seal at the tire bead.
.NISSAN recommends that the road wheels
be waxed to protect against road salt in
areas where it is used during winter.
Spare tireWhen a spare tire is mounted (TEMPORARY
USE ONLY or conventional) , the TPMS will not
function.
Observe the following precautions if the TEM-
PORARY USE ONLY spare tire must be used,
otherwise your vehicle could be damaged or
involved in an accident.
WARNING
.The TEMPORARY USE ONLY spare
tire should be used for emergency
use. It should be replaced with the
standard tire at the first opportunity
to avoid possible tire or differential
damage..Drive carefully while the TEMPOR-
ARY USE ONLY spare tire is in-
stalled. Avoid sharp turns and
abrupt braking while driving.
.Periodically check spare tire infla-
tion pressure. Always keep the
pressure of the TEMPORARY USE
ONLY spare tire at 60 psi (420 kPa,
4.2 bar) . Always keep the pressure
of the full size spare tire (if so
equipped) at the recommended
pressure for standard tires, as in-
dicated on the Tire and Loading
Information label.
.With the TEMPORARY USE ONLY
spare tire installed do not drive your
vehicle at speeds faster than 50
MPH (80 km/h) .
.When driving on roads covered with
snow or ice, the TEMPORARY USE
ONLY spare tire should be used on
the rear wheels and original tire
used on the front wheels (drive
wheels) . Use tire chains only on
the front (original) tires.
.Tire tread of the TEMPORARY USE
ONLY spare tire will wear at a faster
rate than the standard tire. Replace
Maintenance and do-it-yourself
8-39

Black plate (287,1)
Model "S35-D" EDITED: 2008/ 7/ 24
ENGINEModel QR25DE
Type Gasoline, 4-cycle, DOHC
Cylinder arrangement 4-cylinder, in-line
Bore6Stroke in (mm) 3.563.9 (89.06100.0)
Displacement cu in (cm
3) 151.82 (2,488)
Firing order 1-3-4-2
Idle speed rpm
No adjustment is necessary.
Ignition timing (B.T.D.C.) degree/rpm
Spark plug Standard DILKAR6A-11
Spark plug gap (Normal) in (mm) 0.043 (1.1)
Camshaft operation
Timing chain
This spark ignition system complies with the Canadian standard ICES-002.
WHEELS AND TIRES
Road wheelType Size Offset in (mm)
Steel 1666-1/2JJ 1.57 (40)
Aluminum 1767J 1.57 (40)
T-type 1664T
1.18 (30)TireType SizePressure PSI
(kPa) [Cold]
ConventionalP215/70R16
99H
33 (230)
P225/60R17
98H
T-typeT155/90D16
60 (420)
SPECIFICATIONS
Technical and consumer information
9-7

Black plate (301,1)
Model "S35-D" EDITED: 2008/ 7/ 24
TOWING SAFETY
Trailer hitchChoose a proper hitch for your vehicle and
trailer. A genuine NISSAN trailer hitch is
available from a NISSAN dealer. Make sure the
trailer hitch is securely attached to the vehicle to
help avoid personal injury or property damage
due to sway caused by crosswinds, rough road
surfaces or passing trucks.Hitch ballChoose a hitch ball of the proper size and
weight rating for your trailer:
.The required hitch ball size is stamped on
most trailer couplers. Most hitch balls also
have the size printed on top of the ball.
.Choose the proper class hitch ball based on
the trailer weight.
.The diameter of the threaded shank of the
hitch ball must be matched to the ball mount
hole diameter. The hitch ball shank should
be no more than 1/16@smaller than the hole
in the ball mount.
.The threaded shank of the hitch ball must be
long enough to be properly secured to the
ball mount. There should be at least 2
threads showing beyond the lock washer
and nut.
Sway control deviceSudden maneuvers, wind gusts and buffeting
caused by other vehicles can affect trailer
handling. Sway control devices may be used to
help control these affects. If you choose to use
one, contact a reputable trailer hitch supplier to
make sure the sway control device will work with
the vehicle, hitch, trailer and the trailer’s brake
system. Follow the instructions provided by the
manufacturer for installing and using the sway
control device.Class I hitchClass I trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 2,000 lb (909 kg) .
CAUTION
.The hitch should not be attached to
or affect the operation of the im-
pact-absorbing bumper.
.Do not use axle-mounted hitches.
.Do not modify the vehicle exhaust
system, brake system, etc. to install
a trailer hitch.
.To reduce the possibility of addi-
tional damage if your vehicle is
struck from the rear, where practi-
cal, remove the hitch and/or recei-ver when not in use. After the hitch
is removed, seal the bolt holes to
prevent exhaust fumes, water or
dust from entering the passenger
compartment.
.Regularly check that all trailer hitch
mounting bolts are securely
mounted.
Tire pressures.When towing a trailer, inflate the vehicle
tires to the recommended cold tire pressure
indicated on the Tire and Loading Informa-
tion label.
.Trailer tire condition, size, load rating and
proper inflation pressure should be in
accordance with the trailer and tire manu-
facturers’ specifications.Safety chainsAlways use a suitable chain between your
vehicle and the trailer. The safety chains should
be crossed and should be attached to the hitch,
not to the vehicle bumper or axle. The safety
chains can be attached to the bumper if the
hitch ball is mounted to the bumper. Be sure to
leave enough slack in the chains to permit
turning corners.Technical and consumer information
9-21

Black plate (6,1)
10-6
Tire and Loading Information label........... 9-10
Tire chains...................................... 8-36
Tire dressing..................................... 7-3
Tire pressure................................... 8-29
Tire pressure monitoring system
(TPMS)..................................... 5-3, 6-2
Tire rotation.................................... 8-37
Types of tires................................... 8-35
Uniform tire quality grading................... 9-25
Wheel/tire size................................... 9-7
Wheels and tires............................... 8-29
Tonneau cover (see cargo cover)................. 2-37
Top tether strap child restraints.................. 1-22
Towing
Flat towing...................................... 9-24
Tow truck towing............................... 6-12
Towing a trailer................................. 9-16
Towing load/specification chart............... 9-16
Towing safety.................................. 9-21
TPMS, Tire pressure monitoring system........... 5-3
TPMS, Tire pressure warning system.............. 6-2
Trailer towing....................................... 9-16
Transceiver, HomeLink
®Universal
Transceiver......................................... 2-47
Transmission
Continuously Variable Transmission (CVT)
fluid............................................. 8-11
Driving with CVT (Continuously Variable
Transmission)............................ 5-11, 5-13
Transmission selector lever lock release..... 5-17
Transmitter (See remote keyless entry system).... 3-6
Transmitter, With Intelligent Key system
(See Intelligent Key system)...................... 3-16
Traveling or registering your vehicle in another
country................................................ 9-8Trip computer........................................ 2-7
Turn signal switch.................................. 2-28
U
Underbody cleaning................................. 7-3
Uniform tire quality grading....................... 9-25
Utility hook.......................................... 2-39
V
Vanity mirror lights................................. 2-46
Vehicle
Dimensions and weights ........................ 9-8
Identification number (VIN)...................... 9-8
Loading information............................ 9-12
Recovery (freeing a stuck vehicle)............ 6-15
Security system................................ 2-19
Vehicle dynamic control (VDC) off switch . . . 2-31
Vehicle dynamic control (VDC) system...... 5-28
Ventilators............................................ 4-2
Voice command
(See Bluetooth
®Hands-Free Phone System) . . . 4-31
W
Warning labels, Air bag warning labels.......... 1-51
Warning light
Air bag warning light................... 1-51, 2-16
All-wheel drive (AWD) warning light......... 2-12
Anti-lock braking system (ABS) warning
light............................................. 2-12
AWD warning light............................ 5-24
Brake warning light............................ 2-12
Door open warning light....................... 2-13
Electric power steering warning light........ 2-13Intelligent Key system warning light.......... 2-14
Low fuel warning light ......................... 2-14
Low tire pressure warning light............... 2-14
Seat belt warning light ........................ 2-15
Warning lights...................................... 2-12
Warning, Hazard warning flasher switch......... 2-29
Warning, Tire pressure monitoring system
(TPMS)......................................... 5-3, 6-2
Warning, Warning/indicator lights and audible
reminders........................................... 2-11
Warranty, Emission control system warranty..... 9-26
Washer switch
Rear window wiper and washer switch...... 2-23
Windshield wiper and washer switch........ 2-22
Washing.............................................. 7-2
Waxing................................................ 7-2
Weights (See dimensions and weights)........... 9-8
Wheel/tire size....................................... 9-7
Wheels and tires................................... 8-29
Cleaning aluminum alloy wheels................ 7-3
Window washer fluid.............................. 8-12
Window(s)
Cleaning.......................................... 7-3
Power windows................................ 2-40
Windshield wiper and washer switch............ 2-22
Wiper
Rear window wiper and washer switch...... 2-23
Rear window wiper blade..................... 8-18
Windshield wiper and washer switch........ 2-22
Wiper blades................................... 8-16
X
Xenon headlights .................................. 2-25
Model "S35-D" EDITED: 2008/ 6/ 3