2009 NISSAN GT-R oil change

Black plate (5,1)
Model "R35-D" EDITED: 2008/ 5/ 20
mance of the LSD. Also use the same oil for the
front differential.The use of additives is
prohibited.BRAKE FLUIDGenuine NISSAN Brake Fluid R35 Special
DOT4
Genuine NISSAN Brake Fluid R35 Special
DOT4 is the factory fill brake fluid. The Vehicle
Dynamic Control (VDC) unit and other related
parts were specially designed for this brake
fluid. NISSAN cannot ensure the best perfor-
mance and proper operation of the vehicle if
other brake fluid is used.TIRES AND ROAD WHEELSGenuine GT-R tires and road wheels or
equivalent
Use only genuine GT-R tires and road wheels or
equivalent. Proper use of NISSAN recom-
mended tires provides the greatest potential
for maximum performance.
. Genuine GT-R tires and road wheels or an
equivalent help achieve maximum cornering
performance.
. Genuine GT-R tires and road wheels or an
equivalent help provide road holding in the
event of decreasing tire pressure and
punctures. .
Genuine GT-R tires and road wheels or an
equivalent help prevent the decrease of
straight-running stability caused by uneven
tire wear due to high rigidity wheels and
wide tires.
BRAKE PAD AND DISC ROTORGenuine GT-R brake pads and disc rotors
This vehicle is equipped with a high perfor-
mance braking system and includes cross-
drilled floating rotors and radial-mounted six-
piston monoblock calipers. This helps to achieve
excellent stopping performance and fade-resis-
tance. Replace all four sets of brake pads and
disc rotors at the same time to maintain
maximum brake performance.EXHAUST MUFFLERUse only the special GT-R muffler and
trunk carpet.
Never use parts other than genuine NISSAN
parts.
The GT-R has high exhaust gas temperatures. If
non-GT-R specification parts are used, it is
possible that the muffler will deform and cause
damage to the underbody. Also do not remove
the trunk carpet from the vehicle for any reason.
The carpet insulates the vehicle interior from the
heat of the muffler and from the noise of the
transmission.
EXTERIOR PARTS (spoiler, etc.)Do not modify exterior parts.
The GT-R was developed using a special wind
tunnel to help make sure the vehicle is
aerodynamically balanced. Additionally, the wind
tunnel was used to help make sure cool air flows
to the brakes, radiator and other components.
Additions of non-GT-R specific accessory ex-
terior parts can change the air flow over and
around the body. This can affect vehicle balance
and cooling of various systems.
For example, if the front bumper is modified,
there is a possibility that brake performance may
be reduced due to the decrease of the air flow to
the brake system.
GT-R Overview
GTR-3
,QIRUPDWLRQ3URYLGHGE\

Black plate (8,1)
Model "R35-D" EDITED: 2008/ 5/ 20
The following information applies if you engage
in performance driving such as driving your
GT-R for extended periods under the following
conditions.
.Higher-RPM (approaching redline) opera-
tion
. Frequent high pedal force braking from
moderate and higher speeds
. Frequent throttle activation
. Fast revving throughout the RPM range
In such cases, the following additional main-
tenance guidelines apply.
However, you should also carefully read
your 2009 NISSAN GT-R Warranty Informa-
tion Booklet for important information
concerning warranty coverage, limitations
and exclusions.
We recommend that maintenance be performed
at a GT-R certified NISSAN dealer. NISSAN will
only pay for GT-R Performance Optimization
Services performed at a GT-R certified NISSAN
dealer.FLUIDS. Before driving, check the fluid levels and
adjust as necessary using the specified fluid.
. Check the amount of fluid for the power steering.
. Be sure to change the fluids listed below
with the specified fluids every 1,800 miles
(3,000 km) .
ITEMS GT-R SPECIFIED FLUIDS
Engine oil Mobil 1, 0W-40*1
Transmission oil Genuine NISSAN Transmission
Oil R35 Special
Differential oil
(front and rear) Castrol SAF-XJ 75W-140
Brake fluid Genuine NISSAN Brake Fluid
R35 Special DOT4*2
*1: Mobil 1, 0W-40 (100% synthetic) is the factory fill oil. The VR38 engine with its plasma-sprayed
bores was developed using this oil. NISSAN
cannot ensure proper engine operation and dur-
ability if other 0W-40 synthetic oil is used. If Mobil
1, 0W-40 is not available, Mobil 1, 10W-40 (100%
synthetic) may be used; however, some perfor-
mance loss may be noticed.
*2: Genuine NISSAN Brake Fluid R35 Special DOT4 is the factory fill brake fluid. The Vehicle Dynamic
Control (VDC) unit and other related parts were
specially designed for this brake fluid and NISSAN
cannot ensure the best performance and proper
operation of the vehicle if other brake fluid is used.
INSPECTION AND ADJUSTMENTS
OF TIRES, SUSPENSION AND
BRAKES. Measure and adjust the wheel alignment.
. Check the tire pressure and the Tire
Pressure Monitoring System (TPMS) sen-
sor.
. Make tire pressure adjustments only when
the tires are cool. (
“WHEELS AND
TIRES” page 8-29)
. Secure road wheel balance weights with
aluminum tape or equivalent.
. Check the heat deterioration and wear of the
brakes. (As necessary, the brake pad and
the brake disc rotor must be replaced as a
set of four with new ones.)
REPLENISHING COOLANTCheck the coolant level in the pressurized
coolant reservoir. Adjust the level so that the
fluid is between the MAX and MIN markings. For
the coolant, use genuine NISSAN Long Life
coolant. (On delivery of new vehicle, the
reservoir is filled to the MIN level. Be sure to
replenish approximately 0.3 to 0.4 US quart (0.3
to 0.4 liter) of coolant.)
GTR-6
GT-R Overview
ADDITIONAL MAINTENANCE ITEMS
,QIRUPDWLRQ3URYLGHGE\

Black plate (12,1)
Model "R35-D" EDITED: 2008/ 5/ 20
TRANSMISSION OPERATION CHARACTERISTICS
MechanismOperation characteristics
Base Manual transmission
.
When the temperature of the transmission is high, the decreased friction from idling and driving at low speeds can cause rattling, shaking
and jarring noises. When the temperature of the transmission decreases, the noise will lessen.
.
Clattering noises may be heard while shifting.
Multiple disc wet clutch
.
When stopping the vehicle with the shift lever in the
&Ror&A↔&Mposition, be sure to firmly depress the brake pedal. The vehicle may
slowly move if the brake pedal is not depressed.
.
Never depress the brake and accelerator pedals at the same time. Depressing the brake and accelerator pedals at the same time could
cause:—
The engine to stall
—
The clutch to overheat
—
Transmission damage
.
To prevent stalling or transmission damage, start in first gear. The
&Mposition second gear can be used to start moving the vehicle only
when reduced torque is necessary on snowy roads or extremely slippery surfaces.
.
When the vehicle is stopped on a hill, do not hold the vehicle in place by depressing the accelerator pedal. Doing so may cause the clutch
to overheat and result in transmission damage. Use the brakes to prevent the vehicle from moving.
Electronic oil pressure
control The following conditions are caused due to changes in fluid viscosity as a result of temperature changes.
.
When the transmission fluid is extremely cold or extremely hot, the transmission may feel like it is slipping during shifts or there may be hard
shifts. This is normal. Transmission shifting should return to normal when the transmission fluid returns to normal operating temperatures.
.
When the transmission fluid temperature is extremely cold, the time required to run a system check may increase. During the system check,
the shift lever must stay in the
&Pposition. Move the shift lever after turning off the system check display. Also, it is normal to hear clicking
noises during the transmission systems check.
Changing modes
.
The higher shift speeds in the
&Mposition may result in shift shock and jerkiness when starting or shifting.
.
Quick shifting in the R mode with the transmission in the
&Mposition is available when the engine speed is high. However, the transmission
may shift more slowly when the engine speed is low.
Gear clearances Appropriate gaps are provided between gears to achieve smooth gear rotation and steady tooth surface lubrication under the high-load driving
condition. However, this causes a rattling noise.
GTR-10
GT-R Overview
,QIRUPDWLRQ3URYLGHGE\

Black plate (13,1)
Model "R35-D" EDITED: 2008/ 5/ 20
MechanismOperation characteristics
Ultralight flywheel
.
An ultralight flywheel is provided to achieve rapid engine response to the accelerator pedal operation and quick shifting response to the
paddle shifter operation. These are essential for a supercar. However, you may notice a large rattling noise from gears because engine
rotation fluctuations become larger while idling.
.
Due to changes in engine speed through the operation of the air conditioner, rattling, shaking or jarring noises may be heard when idling or
driving at low speeds.
.
Rattling noises may be heard when the engine is started or stopped.
Dry sump lubrication High-efficiency dry sump lubrication is provided to achieve low agitation resistance of lubricant oil and allows smooth transmission gear rotation
that contribute to obtain a perfect balance between outstanding driving performance and improved environmental performance. However, you
may notice some rattling noise due to engine rotation fluctuations.
GT-R Overview
GTR-11
,QIRUPDWLRQ3URYLGHGE\

Black plate (83,1)
Model "R35-D" EDITED: 2008/ 5/ 20
ENGINE OIL LEVEL DISPLAYWhen the ignition switch is pushed to the ON
position, the engine oil status before starting the
engine is indicated as illustrated.When the oil level is normal“OIL LEVEL OK” is displayed. Press the
displayed LEVEL switch
to check the oil
level.
NOTE:The engine oil level can be displayed after
the “OIL LEVEL OK” display turns off or
while the engine is started and running.
(
“Maintenance” page 2-19)
When the oil level is lowIf the message shown above is displayed, the
engine oil level is low.
Warm up the engine in a level location. After at
least 5 minutes have passed since engine stop,
use the engine oil level gauge to check the oil
level. (
“ENGINE OIL” page 8-12)
If the oil level is low, have additional engine oil
added, or the oil changed, at a GT-R certified
NISSAN dealer.Instruments and controls
2-11
,QIRUPDWLRQ3URYLGHGE\

Black plate (84,1)
Model "R35-D" EDITED: 2008/ 5/ 20
NOTICE
If the vehicle is in a location that is not
level, accurate measurement of the oil
level may not be possible. If “LOW OIL
LEVEL” is displayed, but the level
shown by the oil level gauge is normal,
move the vehicle to a level location and
stop the engine. After at least 5 minutes
have passed, open the driver’s door and
push the ignition switch back to ON. If
the “LOW OIL LEVEL” message appears
again, have engine oil added or the oil
changed.
When the oil level sensor malfunc-
tion occursIf the message shown above is displayed, the
engine oil level sensor may be malfunctioning.
Contact a GT-R certified NISSAN dealer im-
mediately.
TRANSMISSION SYSTEM CHECK
DISPLAYThis is displayed after the engine is started while
the transmission system is being checked. It
turns off after a few seconds.NOTE:.During the system check, the shift lever
cannot be moved out of the
&Pposition.
Operate the shift lever after the system
check indicator turns off.
. During winter or at other times when
the temperature is extremely low,
changes in the hydraulic response
characteristics may increase the
2-12
Instruments and controls
,QIRUPDWLRQ3URYLGHGE\

Black plate (91,1)
Model "R35-D" EDITED: 2008/ 5/ 20
MaintenanceThis function can be used to set the various
maintenance intervals and to check the engine
oil level. The reminders shown below are used to
notify the driver of the maintenance intervals.NOTE:Because these are displayed based on the
mileage driven, they do not indicate the
actual conditions of the vehicle. Use these
functions only as a reference.
Input the maintenance distance using the
following items:
.On each setting screen, push the NEXT
switch
to change the mileage. Push and hold the switch to increase the number
every 600 miles (1,000 km) .
. Set to “—” to set no reminders.
. To reset the accumulated mileage to zero,
go to the RESET screen, then push the
NEXT switch
and confirm with the
ENTER switch.
NOTE:. To restore the mileage to the original
figure after resetting, press the NEXT
switch
again.
. When the battery terminal is discon-
nected, the set mileage will be erased
and the settings will return to their
default settings.
Engine oil level:This can be used to check the pre-start oil level
while the engine is running. Select SETTING >
MAINTENANCE > OIL > ENGINE OIL >
LEVEL.
If the low level reminder appears, check the level
using the engine oil dipstick. (
“CHECKING
ENGINE OIL LEVEL” page 8-12)
Instruments and controls
2-19
,QIRUPDWLRQ3URYLGHGE\

Black plate (92,1)
Model "R35-D" EDITED: 2008/ 5/ 20
Engine oil:When the set mileage approaches, the reminder
will appear on the display and the remaining
distance is displayed at regular intervals. Select
SETTING > MAINTENANCE > OIL > ENGINE
OIL to set or reset the mileage for the engine oil
change.NOTE:The default setting is 6,000 miles (10,000
km) . The maximum mileage that can be set
is 6,000 miles (10,000 km) .
Engine oil filter:The reminder is displayed when the set mileage
is exceeded. Select SETTING > MAINTE-
NANCE > FILTER to set or reset the mileage
for the engine oil filter change.NOTE:The default setting is OFF. The maximum
mileage that can be set is 6,000 miles
(10,000 km) .
Transmission oil:The reminder is displayed when the set mileage
is exceeded. Select SETTING > MAINTE-
NANCE > OIL > T/M OIL to set or reset the
mileage for the transmission oil change.NOTE:The default setting is 18,500 miles (30,000
km) . The maximum mileage that can be set
is 18,500 miles (30,000 km) .
2-20
Instruments and controls
,QIRUPDWLRQ3URYLGHGE\