2009 NISSAN GT-R lock

Black plate (5,1)
Model "R35-D" EDITED: 2008/ 5/ 20
mance of the LSD. Also use the same oil for the
front differential.The use of additives is
prohibited.BRAKE FLUIDGenuine NISSAN Brake Fluid R35 Special
DOT4
Genuine NISSAN Brake Fluid R35 Special
DOT4 is the factory fill brake fluid. The Vehicle
Dynamic Control (VDC) unit and other related
parts were specially designed for this brake
fluid. NISSAN cannot ensure the best perfor-
mance and proper operation of the vehicle if
other brake fluid is used.TIRES AND ROAD WHEELSGenuine GT-R tires and road wheels or
equivalent
Use only genuine GT-R tires and road wheels or
equivalent. Proper use of NISSAN recom-
mended tires provides the greatest potential
for maximum performance.
. Genuine GT-R tires and road wheels or an
equivalent help achieve maximum cornering
performance.
. Genuine GT-R tires and road wheels or an
equivalent help provide road holding in the
event of decreasing tire pressure and
punctures. .
Genuine GT-R tires and road wheels or an
equivalent help prevent the decrease of
straight-running stability caused by uneven
tire wear due to high rigidity wheels and
wide tires.
BRAKE PAD AND DISC ROTORGenuine GT-R brake pads and disc rotors
This vehicle is equipped with a high perfor-
mance braking system and includes cross-
drilled floating rotors and radial-mounted six-
piston monoblock calipers. This helps to achieve
excellent stopping performance and fade-resis-
tance. Replace all four sets of brake pads and
disc rotors at the same time to maintain
maximum brake performance.EXHAUST MUFFLERUse only the special GT-R muffler and
trunk carpet.
Never use parts other than genuine NISSAN
parts.
The GT-R has high exhaust gas temperatures. If
non-GT-R specification parts are used, it is
possible that the muffler will deform and cause
damage to the underbody. Also do not remove
the trunk carpet from the vehicle for any reason.
The carpet insulates the vehicle interior from the
heat of the muffler and from the noise of the
transmission.
EXTERIOR PARTS (spoiler, etc.)Do not modify exterior parts.
The GT-R was developed using a special wind
tunnel to help make sure the vehicle is
aerodynamically balanced. Additionally, the wind
tunnel was used to help make sure cool air flows
to the brakes, radiator and other components.
Additions of non-GT-R specific accessory ex-
terior parts can change the air flow over and
around the body. This can affect vehicle balance
and cooling of various systems.
For example, if the front bumper is modified,
there is a possibility that brake performance may
be reduced due to the decrease of the air flow to
the brake system.
GT-R Overview
GTR-3
,QIRUPDWLRQ3URYLGHGE\

Black plate (20,1)
Model "R35-D" EDITED: 2008/ 5/ 20
1. Coat hooks (P.2-56)
2. Inside lock knob (P.3-5)
3. Interior light control switch (P.2-58)
4. Map lights (P.2-58)
5. Sun visors (P.3-26)
6. Sunglasses holder (P.2-54)7. Inside rearview mirror (P.2-60, P.3-26)
8. Center console box (P.2-56)
9. Cup holders (P.2-53)
10. Power window switches (P.2-56)
11. Window lock button (P.2-57)
12. Power door lock switch (P.3-5)0-6
Illustrated table of contents
PASSENGER COMPARTMENT
,QIRUPDWLRQ3URYLGHGE\

Black plate (28,1)
Model "R35-D" EDITED: 2008/ 5/ 20
WARNING
.Do not ride in a moving vehicle
when the seatback is reclined. This
can be dangerous. The shoulder belt
will not be against your body. In an
accident, you could be thrown into it
and receive neck or other serious
injuries. You could also slide under
the lap belt and receive serious
internal injuries.
. For the most effective protection
when the vehicle is in motion, the
seat should be upright. Always sit well back in the seat with both feet
on the floor and adjust the seat
properly. (
“PRECAUTIONS ON
SEAT BELT USAGE” page 1-5)
. After adjustment, gently rock in the
seat to make sure it is securely
locked.
. Do not leave children unattended
inside the vehicle. They could un-
knowingly activate switches or con-
trols. Unattended children could
become involved in serious acci-
dents.
FRONT SEATS
Front power seat adjustmentOperating tips
.The power seat motor has an auto-reset
overload protection circuit. If the motor
stops during operation, wait 30 seconds,
then reactivate the switch.
. Do not operate the power seat switch for a
long period of time when the engine is off.
This will discharge the battery.
1-2
Safety — Seats, seat belts and supplemental restraint system
SEATS
,QIRUPDWLRQ3URYLGHGE\

Black plate (30,1)
Model "R35-D" EDITED: 2008/ 5/ 20
Passenger’s seat slide:Pushing the passenger’s seat slide switch will
slide the passenger’s seat forward or backward
to the desired position.
Rear seat walk-inThis feature makes it easier to get in and out of
the rear seat. Use the following procedure when
getting in and out of the rear seat.
1. Lift up the lever and tilt the seatbackforward.
2. Use the seat adjustment switch
*A
or the
passenger’s seat slide switch
*C
to slide
the seat forward to a position where it will be
easier to enter or exit the rear seats. Fold the
shoulder belt guide for easier access to the
rear seat.
3. To return the seat to its original position, lift up the seatback and use the seat adjust- ment switch to return the seat to its original
position.
CAUTION
.
When returning the seat to its
original position, confirm that the
seat and seatback are locked prop-
erly.
. Be careful not to pinch your hand or
foot or bump your head when oper-
ating the walk-in seat.
NOTICE
Do not place any objects near the
seatback of the front seats. They may
be pinched and damaged.
1-4
Safety — Seats, seat belts and supplemental restraint system
,QIRUPDWLRQ3URYLGHGE\

Black plate (35,1)
Model "R35-D" EDITED: 2008/ 5/ 20
PREGNANT WOMENNISSAN recommends that pregnant women use
seat belts. The seat belt should be worn snug,
and always position the lap belt as low as
possible around the hips, not the waist, and
place the shoulder belt over your shoulder and
across your chest. Never run the lap/shoulder
belt over your abdominal area. Contact your
doctor for specific recommendations.INJURED PERSONSNISSAN recommends that injured persons use
seat belts, depending on the injury. Check with
your doctor for specific recommendations.THREE-POINT TYPE SEAT BELT
WITH RETRACTOR
WARNING
.Every person who drives or rides in
this vehicle should use a seat belt at
all times.
. Do not ride in a moving vehicle
when the seatback is reclined. This
can be dangerous. The shoulder belt
will not be against your body. In an
accident, you could be thrown into it
and receive neck or other serious
injuries. You could also slide under
the lap belt and receive serious internal injuries.
. For the most effective protection
when the vehicle is in motion, the
seat should be upright. Always sit
well back in the seat with both feet
on the floor and adjust the seat belt
properly.
Fastening the seat belts1. Adjust the seat. (
“SEATS” page 1-2)
2. Slowly pull the seat belt out of the retractor and insert the tongue into the buckle until
you hear and feel the latch engage.
.The retractor is designed to lock
during a sudden stop or on impact.
A slow pulling motion permits the
belt to move, and allows you some
freedom of movement in the seat.
. If the seat belt cannot be pulled
from its fully retracted position,
firmly pull the belt and release it.
Then smoothly pull the belt out of
Safety — Seats, seat belts and supplemental restraint system
1-9
,QIRUPDWLRQ3URYLGHGE\

Black plate (36,1)
Model "R35-D" EDITED: 2008/ 5/ 20
the retractor.
3. Position the lap belt portionlow and snug
on the hips as shown.
4. Pull the shoulder belt portion toward the retractor to take up extra slack. Be sure the
shoulder belt is routed over your shoulder
and across your chest.
The three-point type seat belts for the front
passenger and rear seats have two modes of
operation:
. Emergency Locking Retractor (ELR)
. Automatic Locking Retractor (ALR)
The Emergency Locking Retractor (ELR) mode
allows the seat belt to extend and retract to allow the driver and passengers some freedom
of movement in the seat. The ELR locks the seat
belt when the vehicle slows down rapidly or
during impacts.
The Automatic Locking Retractor (ALR) mode or
child restraint mode locks the seat belt for child
restraint installation.
When the ALR mode is activated the seat belt
cannot be extended again until the seat belt
tongue is detached from the buckle and fully
retracted. The seat belt returns to the ELR mode
after the seat belt is fully retracted.
(
“CHILD RESTRAINTS” page 1-13)
The ALR mode should be used only for
child restraint installation. During normal
seat belt use by an occupant, the ALR
mode should not be activated. If it is
activated it may cause uncomfortable seat
belt tension. It can also change the opera-
tion of the front passenger air bag.
(“Front passenger air bag and status
light” page 1-37)
WARNING
When fastening the seat belts, be
certain that seatbacks are completely
secured in the latched position. If they
are not completely secured, passengers
may be injured in an accident or sudden
1-10
Safety — Seats, seat belts and supplemental restraint system
,QIRUPDWLRQ3URYLGHGE\

Black plate (37,1)
Model "R35-D" EDITED: 2008/ 5/ 20
stop.
Unfastening the seat beltsTo unfasten the seat belt, push the button on the
buckle. The seat belt automatically retracts.Checking seat belt operationSeat belt retractors are designed to lock seat
belt movement by two separate methods:
.When the belt is pulled quickly from the
retractor.
. When the vehicle slows down rapidly. To increase your confidence in the seat belts,
check the operation as follows:
.
Grasp the shoulder belt and pull forward
quickly. The retractor should lock and
restrict further belt movement.
If the retractor does not lock during this check or
if you have any question about seat belt
operation, see a GT-R certified NISSAN dealer.
Safety — Seats, seat belts and supplemental restraint system
1-11
,QIRUPDWLRQ3URYLGHGE\

Black plate (38,1)
Model "R35-D" EDITED: 2008/ 5/ 20
Shoulder belt arm (for front seats)Before fastening the seat belt, pull the shoulder
belt arm forward until it clicks at the lock
position. The arm can also be folded down to
allow rear seat passengers easier access.
Pulling the arm forward will allow an easy access
to the belt.SEAT BELT EXTENDERSIf, because of body size or driving position, it is
not possible to properly fit the lap-shoulder belt
and fasten it, an extender is available that is
compatible with the installed seat belts. The
extender adds approximately 8 in (200 mm) of
length and may be used for either the driver or
front passenger seating position. See a GT-Rcertified NISSAN dealer for assistance if the
extender is required.
WARNING
.
Only NISSAN seat belt extenders,
made by the same company which
made the original equipment seat
belts, should be used with the
NISSAN seat belts.
. Adults and children who can use the
standard seat belt should not use an
extender. Such unnecessary use
could result in serious personal
injury in the event of an accident.
. Never use seat belt extenders to
install child restraints. If the child
restraint is not secured properly, the
child could be seriously injured in a
collision or a sudden stop.SEAT BELT MAINTENANCE.To clean the seat belt webbings, apply a
mild soap solution or any solution recom-
mended for cleaning upholstery or carpets.
Then, wipe with a cloth and allow the seat
belts to dry in the shade. Do not allow the
seat belts to retract until they are completely
dry.
. If dirt builds up in the shoulder belt guide
of the seat belt anchors, the seat
belts may retract slowly. Wipe the shoulder
belt guide with a clean, dry cloth.
. Periodically check to see that the seat
belt and the metal components such as
buckles, tongues, retractors, flexible wires
and anchors work properly. If loose parts,
deterioration, cuts or other damage on the
webbing is found, the entire seat belt
assembly should be replaced.
1-12
Safety — Seats, seat belts and supplemental restraint system
,QIRUPDWLRQ3URYLGHGE\