2009 MAZDA MODEL 6 lock

Black plate (386,1)
NOTETo replace the bulb, contact an Authorized
Mazda Dealer.
Reverse lights
1. Pull the center section of the plasticretainer and remove the retainers, then
partially peel back the trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assemblycounterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
License plate lights
1. Pull the center section of the plasticretainer and remove the retainers, then
partially peel back the trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order of removal.
8-44
Maintenance and Care
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page386
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (389,1)
3. Pull the fuse straight out with the fusepuller provided on the fuse block
located in the engine compartment.
4. Inspect the fuse and replace it if it'sblown.
Normal Blown
5. Insert a new fuse of the same amperage
rating, and make sure it fits tightly. If it
does not fit tightly, have an expert
install it. We recommend an
Authorized Mazda Dealer.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the AUDIO or CIGAR circuit.
CAUTION
Always replace a fuse with one of the
same rating. Otherwise you may
damage the electric system.
Replacing the fuses under the hood
If the headlights or other electrical
components do not work and the fuses in
the cabin are normal, inspect the fuse
block under the hood. If a fuse is blown, it
must be replaced. Follow these steps:
1. Turn off the ignition switch and all
other switches.
2. Remove the fuse block cover.
3. If any fuse but the MAIN fuse is blown, replace it with a new one of the
same amperage rating .
Normal
Blown
Maintenance and Care
Owner Maintenance
8-47
Mazda6_8Z64-EA-08H_Edition1 Page389
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (390,1)
4. Install the right side of the fuse blockcover first as shown the figure.
WARNING
Do not replace the main fuse by
yourself. Have an Authorized Mazda
Dealer perform the replacement: Replacing the fuse by yourself is
dangerous because the MAIN fuse is
a high current fuse. Incorrect
replacement could cause an electrical
shock or a short circuit resulting in a
fire.
8-48
Maintenance and Care
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page390
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (391,1)
qFuse Panel Description
Fuse block (Engine compartment)
DESCRIPTION FUSE
RATING PROTECTED COMPONENT
1 M.DEF 10 A Mirror defroster
í
2ST SIG 5 A Starter sig
3 ABS SOL 30 A ABS, DSCí
4 P.WIND (P) 25 A Power window
5 P.SEAT (P) 30 A Power seatí
6 SUN ROOF 15 A Moonroofí
7 TAIL 15 A BCM, Tail lamp
8 P.OUTLET (R) 15 A Accessory sockets
9 AUDIO 30 A Audio system (Bose
®Sound System-equipped model)
10 ABS MOTOR 60 A ABS, DSCí
11 P.WIND (D) 40 A Power window
12 DEFOG 40 A Rear window defroster
13 SEAT HEAT 20 A Seat heat
14 A/C 10 A Air conditioner
15 FOG 15 A Fog lights
í
16 BLOWER 2 15 A Blower motor
17FAN 60 A Cooling fan
Maintenance and Care
Owner Maintenance
8-49íSome models.
Mazda6_8Z64-EA-08H_Edition1 Page391
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (392,1)
DESCRIPTIONFUSE
RATING PROTECTED COMPONENT
18 P.SEAT (D) 30 A Power seat
í
19 BTN 30 A For protection of various circuits
20 IG KEY2 40 A Starting system
21 BLOWER 40 A Blower motor
22 FUEL PUMP 25 A Fuel pump
23 ENGINE2 15 A Engine control system
24 EGI INJ 15 A Injector
25 PCM 10 A Engine control system
26 ENGINE 10 A
*1Engine control system
20 A*2
27 IG 20 A For protection of various circuits
28 TCM 20 A TCMí
29ESCL 10 A Electronic steering lock
30 IG KEY1 40 A For protection of various circuits
31 MAIN 125 A For protection of all circuits
32 DRL 20 A DRL
í
33 HAZARD 10 A Hazard warning flashers
34 ENG+B 10 A PCM
35 STOP 10 A Brake lights
36 HORN 15 A Horn
37 HEAD HI RH 15 A Headlight-high beam (Right)
38 HEAD LO RH 10 A Headlight-low beam (Right)
39 HEAD HI LH 15 A Headlight-high beam (Left)
40 HEAD LO LH 10 A Headlight-low beam (Left)
*1 2.5-liter engine
*2 3.7-liter engine
8-50
Maintenance and Care
íSome models.
Owner Maintenance
Mazda6_8Z64-EA-08H_Edition1 Page392
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (393,1)
Fuse block (Passenger's side)
DESCRIPTIONFUSE
RATING PROTECTED COMPONENT
1 P.WIND 30 A Power window
2 METER IG 15 A For protection of various circuits
3 ILLUMI 7.5 A BCM, Illumination
4 MIRROR 5 A Power control mirror
5 SAS 5 A Air bag, ABS
6 ―― ―
7 INT, LOCK/SHIFT 5 A AT shift
í
8 ―― ―
9 HEGO 5 A Power control mirror
10 A/C 10 A Air conditioner
11 P.OUTLET/CIGAR 15 A Lighter
í
12 D.LOOK 25 A BCM, Door lock motor
13 ENGINE IG 15 A Engine control system
14 WIPER 25 A Windshield wiper and washer
15 ROOM 15 A Interior lights
16 SPARE ――
17 SPARE ――
18 SPARE ――
Maintenance and Care
Owner Maintenance
8-51íSome models.
Mazda6_8Z64-EA-08H_Edition1 Page393
Wednesday, June 25 2008 10:5 AM
Form No.8Z64-EA-08H

Black plate (454,1)
Personalization Features
The following“Personalization Features ”are possible. These settings can only be changed by an Authorized
Mazda Dealer.
Setting FunctionInitial Setting After Setting Change
Auto headlight on/off Adjusts headlight illumination on/off timing
based on surrounding lightness/darkness 2000
―4000 lx 1000 ―2000 lx
Auto headlight off Time required for headlights to turn off after
ignition is switched off 30 seconds 0/60/120 seconds
Turn indicator Sets beep sound volume level HighLow
Blind spot warning Deactivates warning beep function Activated Deactivated
Illumination entry Time required for interior lamp to turn off
automatically after all doors are closed
15 seconds 7.5/30/60 seconds
Deactivates function that allows interior lamp
to illuminate automatically when ignition is
switched off Activated Deactivated
Deactivates function that allows interior lamp
to illuminate automatically when doors are
unlocked Activated Deactivated
Time required for interior lamp to turn off
automatically
(prevents battery depletion when a door is
open/ajar) 30 minutes 10 minutes
Smart turn Activates function that allows turn signal lights
to flash three times with momentary turn switch
operation (when changing lanes)
Deactivated Activated
Keyless entry Selects unlocking method with the retractable
key
Press×2
Press×1
Time required for doors to relock automatically
after unlocking with transmitter 30 seconds 60/90 seconds
Deactivates function that allows horn to sound
automatically when doors are locked by
pressing transmitter two consecutive times Activated Deactivated
10-8
Personalization Features
Mazda6_8Z64-EA-08H_Edition1 Page454
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H

Black plate (455,1)
SettingFunctionInitial Setting After Setting Change
Advanced keyless
entry Activates function to automatically lock doors
when leaving vehicle
(with key being carried away)
Deactivated Activated
Deactivates advanced key remaining battery
level warning light in instrument cluster Activated Deactivated
Adjusts sound volume of answer-back beep
during keyless entry system operation Low High/Deactivated
Adjusts sound volume of warning beep for
advanced keyless entry system High
Low
Chooses whether permission is given to open
trunk when advanced keys are both inside trunk
or outside vehicle Permitted Not permitted
Deactivates function that allows power supply
to turn off automatically when ignition has been
switched to ACC for a long period of time Activated Deactivated
Selects a transition pattern in which ignition
position can be switched when pressing push
button start ON> Off ON> ACC> Off
Deactivates advanced key function Activated Deactivated
Selects door unlocking method with the door
handle sensor and/or the request switch. 1. Touch the
handle, and only
the driver's door
unlocks.2. Touch the handle,
and all doors unlock./3.
Press the request
switch once to unlock
driver's door. Press
again to unlock the
rest./4. Touch the
handle to unlock
driver's door, then
press the request
switch to unlock the
rest.
The following “Personalization Features ”can be changed by customer.
Setting FunctionInitial Setting After Setting Change
Welcome sound Deactivates welcome sound function 6-28 Activated Deactivated
Personalization Features
10-9
Mazda6_8Z64-EA-08H_Edition1 Page455
Wednesday, June 25 2008 10:6 AM
Form No.8Z64-EA-08H