Page 48 of 59

351
4-3. Do-it-yourself maintenance
4
Maintenance and care
30POWER30 APo w e r w i n d o w
31P/ S E AT30 APo w e r s e a t
■After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. (→P. 3 5 4 )
●If the replaced fuse blows again, have the vehicle inspected by your Lexus
dealer.
■If there is an overload in the circuits
The fuses are designed to blow before the entire wiring harness is damaged.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury.
●Never use a fuse of a higher amperage rating than indicated, or use any other
object in place of a fuse.
●Always use a genuine Lexus fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.
●Do not modify fuses or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your Lexus
dealer.
FuseAmpereCircuit
Page 51 of 59
354
4-3. Do-it-yourself maintenance
Light bulbs
You may replace the following bulbs yourself. For more information about
replacing other light bulbs, contact your Lexus dealer.
■Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. (→P. 4 3 1 )
■Front bulb locations
■Rear bulb locations
Headlight high beam
Headlight
low beam
(halogen
bulb)
Front turn signal lightFront side marker light
Parking light
Rear turn signal lightStop/tail light
Rear side marker light
Page 52 of 59
355
4-3. Do-it-yourself maintenance
4
Maintenance and care
Replacing light bulbs
■Headlight low beams (for vehicles without discharge bulbs)
Remove the engine compartment cover. (→P. 312)
Unplug the connector.
Remove the cover.
Release the lock.
STEP1
STEP2
STEP3
STEP4
Page 53 of 59
356
4-3. Do-it-yourself maintenance
Remove the light bulb.
■Headlight high beams
Remove the engine compartment cover. (→P. 312)
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.STEP5
STEP1
STEP2
STEP3
Page 54 of 59
357
4-3. Do-it-yourself maintenance
4
Maintenance and care
■Parking lights, front side marker lights and front turn signal lights
Remove the access hole cover.
Parking light and front side
marker light
Front turn signal light
Turn the bulb base counterclock-
wise.
Parking light and front side marker light
Remove the light bulb.
STEP1
STEP2
STEP3
Page 55 of 59
358
4-3. Do-it-yourself maintenance
Front turn signal light
Remove the light bulb.
■Stop/tail, rear turn signal and rear side marker lights
Open the trunk lid and remove the
access hole cover.
Stop/tail light
Rear turn signal light
Rear side marker light
Turn the bulb base counterclock-
wise.
STEP3
STEP1
STEP2
Page 56 of 59
359
4-3. Do-it-yourself maintenance
4
Maintenance and care
Stop/tail light
Remove the light bulb.
Rear turn signal light
Remove the light bulb.
Rear side marker light
Remove the light bulb.
STEP3
STEP3
STEP3
Page 57 of 59
360
4-3. Do-it-yourself maintenance
■Bulbs other than the above
If any of the bulbs listed below has burnt out, have your Lexus dealer
replace it.
●Headlight low beams (discharge bulbs)
●Front fog lights
●Tail lights
●High mounted stoplight
●License plate lights
●Back-up lights
■Condensation build-up on the inside of the lens
Contact your Lexus dealer for more information in the following situations. Tempo-
rary condensation build-up on the inside of the headlight lens does not indicate a
malfunction.
●Large drops of water are built up on the inside of the lens.
●Water has built up inside the headlight.
■Discharge headlights
If voltage to the discharge bulbs is insufficient, the bulbs may not come on, or may
go out temporarily. The discharge bulbs will come on when normal power is
restored.
■LED stop lights
The high mounted stoplight consists of a number of LEDs. If any of the LEDs burn
out, take your vehicle to your Lexus dealer to have the light replaced.