Page 194 of 258
IN AN EMERGENCY193
4
–
40
40
40
40
40
40
40
40
40
40
40
40
40
40
40F08
F09
F10
F11
F14
F15
F16
F17
F18
F19
F22
F22
F23
F24
F30
F85–
20
10
10
15
30
7.5
10
7.5
7.5
15
20
20
5
15
15
FUSE SUMMARY TABLE - Engine compartment control unit
CONSUMERS FUSE AMPERE DIAGRAM
Spare
Headlight washer pump
Horn
Electronic injection secondary loads
Main beam headlights
PTC1 additional heater
Engine Management Node
Electronic injection primary loads
Engine Management Node
Air conditioning compressor
Electronic injection primary loads (1.4 engine)
Electronic injection primary loads (1.8 and diesel engine)
Brake Node (valves)
Electric Steering Node
Fog/cornering lights
Fuel pump
Page 200 of 258

CARE AND MAINTENANCE199
5
SCHEDULED SERVICING PLAN
Petrol versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication;
Check and top up, if required, fluid levels (engine coolant, brake/hydraulic
clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
visually inspect the condition of the accessory drive belt
Visually inspect the condition of the toothed timing drive belt30 60 90 120 150 180
Page 201 of 258

200CARE AND MAINTENANCE
30 60 90 120 150 180
Thousands of kilometres
Check exhaust fumes/emissions
Check evaporation control system
Check engine management system operation (via diagnostic socket)
Replace auxiliary drive belt/s
Replace toothed timing drive belt (*)
Replace spark plugs
Replace air filter cartridge
Change engine oil and oil filter (or every 24 months)(**)
Change brake fluid (or every 2 years)
Change pollen filter (or every 15 months)
(*) Regardless of the km covered, the timing belt should be replaced every 4 years for particularly demanding use (cold climates,
driving in the city, idling for a long time) or in any case every 5 years.
(**) If the car is mainly used in cities or less than 10,000 km a year, change the engine oil and filter every 12 months.
For 1.4 Turbo Jet versions, in order to guarantee correct operation and prevent serious damage to the engine, it is essential to ob-
serve the following:
- only use spark plugs specifically certified for Turbo Jetengines; all spark plugs should be of the same type and brand (see the “En-
gine” paragraph);
- carefully observe the spark plug replacement intervals detailed in the Scheduled Service Plan;
- it is advisable to have this performed at a Lancia Dealership.
Page 202 of 258

CARE AND MAINTENANCE201
5
Diesel versions
Thousands of kilometres
Check tyre condition/wear and adjust pressure if required
Check lighting system operation (headlights, direction indicators, hazard lights,
passenger compartment lights, boot lights, instrument panel warning lights, etc.)
Check windscreen wiper/washer operation
Check the position/wear of the windscreen/rearscreen wiper blades
Check condition and wear of front disc brake pads and
brake pad wear indication
Check rear disc brake pad seal condition and wear
Visually inspect the condition of: bodywork, underbody
protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check cleanness of bonnet and boot locks and
linkage cleanness and lubrication
Check and top up, if required, fluid levels
(engine coolant, brake/hydraulic clutch fluid, windscreen washer fluid, battery fluid, etc)
Check the handbrake lever stroke and adjust it, if necessary
Check and if necessary adjust the auxiliary
drive belts (excluding engines equipped with automatic tensioners)
Check exhaust fumes/emissions
Visually inspect the condition of the auxiliary drive belt35 70 105 140 175
Page 203 of 258
35 70 105 140 175
202CARE AND MAINTENANCE
Thousands of kilometres
Check engine management system operation (via diagnostic socket)
Replace auxiliary drive belt
Replace toothed timing drive belt (*)
Replace fuel filter
Replace air filter cartridge
Change engine oil and oil filter (versions without DPF)(or every 24 months)
Change engine oil and oil filter (versions with DPF)(**)
Change brake fluid (or every 24 months)
Change pollen filter (or every 15 months)
(*) Regardless of the km covered, the timing belt should be replaced every 4 years for particularly demanding use (cold climates,
driving in the city, idling for a long time) or in any case every 5 years.
(**) The engine oil and oil filter should be changed when the warning light on the dashboard comes on (see “Instrument panel warn-
ing lights”) or every 2 years.
Page 204 of 258

CARE AND MAINTENANCE203
5
REGULAR INSPECTIONS
Every 1,000 km or before long journeys, check and top
up if required:
engine coolant fluid level;
brake fluid level;
windscreen washer fluid level;
tyre pressure and condition;
operation of lights (headlights, direction indicators,
hazard lights, etc.);
operation of the windscreen wiper/washer system, po-
sition and wear of windscreen/rearscreen wiper blades;
Every 3,000 km check the following and top-up, if re-
quired: engine oil level.
You are recommended to use FL Selenia products, de-
signed and produced specifically for Lancia cars (see table
“Capacities” in chapter “6”).
DEMANDING USE OF THE CAR
If you use the vehicle mainly under one of the following
especially heavy conditions:
trailer or caravan towing;
dusty roads;
repetitive short distances (less than 7-8 km) with ex-
ternal temperatures below zero;
frequently idling the engine or long distances at low
speed driving (e.g. door-to-door deliveries) or long term
inactivity;
urban routes;
Page 205 of 258
204CARE AND MAINTENANCE
Perform the following inspections more frequently than
shown on the Scheduled Service Plan:
check front disc brake pad condition and wear;
check cleanness of bonnet and boot locks and linkage
cleanness and lubrication;
visually inspect the condition of: engine, gearbox,
transmission, pipes and hoses (exhaust – fuel supply
- brakes) rubber elements (gaiters – hoses - bushes
etc.);check battery charge and fluid level (electrolyte); (see
“Battery - Charge and electrolyte level check” in this
chapter);
visually inspect the condition of auxiliary drivebelts;
check and if necessary replace the pollen filter; in par-
ticular it should be replaced if a decrease in the air flow
into the passenger compartment is detected;
check the air filter and replace, if required.
Page 209 of 258
208CARE AND MAINTENANCE
ENGINE OIL A-fig. 1-2-3
Check the oil level a few minutes (about 5) after the en-
gine has stopped, with the car parked on level ground. The
oil level should be between the MIN and MAX marks on
the dipstick. The range between the MIN and MAX lev-
els corresponds to approximately 1 litre of oil.
If the oil level is near or under the MIN line, add oil
through the filler to reach the MAX line.
The oil level should never exceed the MAX line.Engine oil consumption
The maximum engine oil consumption is usually 400
grams every 1000 km. When the car is new, the engine
needs to be run in, therefore the engine oil consumption
can only be considered stabilised after the first 5,000 -
6,000 km.
IMPORTANT The oil consumption depends on driving
style and the conditions under which the car is used.
IMPORTANT After adding or changing the oil, let the en-
gine turn over for a few seconds and wait a few minutes
after turning it off before you check the level.