2009 Lancia Delta brake fluid

204CARE AND MAINTENANCE
Perform the following inspections more frequently than
shown on the Scheduled Service Plan:
check front disc brake pad condition and wear;
check cleanness of bonnet and boot locks and linkage
cleanness and lubrication;
visually inspect the condition of: engine, gearbox,
transmission, pipes and hoses (exhaust – fuel supply
- brakes) rubber elements (gaiters – hoses - bushes
etc.);check battery charge and fluid level (electrolyte); (see
“Battery - Charge and electrolyte level check” in this
chapter);
visually inspect the condition of auxiliary drivebelts;
check and if necessary replace the pollen filter; in par-
ticular it should be replaced if a decrease in the air flow
into the passenger compartment is detected;
check the air filter and replace, if required.

210CARE AND MAINTENANCE
The engine cooling system is pressurized. If
required, replace the cap with an original
spare part so as not to compromise system ef-
ficiency. Do not remove the cap from the vessel when
the engine is hot: risk of burns.
WINDSCREEN/REAR WINDOW
WASHER FLUID C-fig. 1-2-3
To add fluid, remove the cap, pressing the special tab.
Pour a mixture of water and TUTELA PROFESSIONAL
SC35, in the following concentrations:
30% TUTELA PROFESSIONAL SC35 and 70% water in
summer.
50% TUTELA PROFESSIONAL SC35 and 50% water in
winter.
At temperatures below –20°C, use undiluted TUTELA
PROFESSIONAL SC35 fluid.
Check the level through the reservoir.
Close the cap by pressing its central section.
Do not travel with the windscreen washing
reservoir empty: the windscreen washer is
fundamental to improve visibility.
Some commercial windscreen washer additives are
flammable. The engine compartment contains hot
parts which could start a fire if they come into con-
tact.
BRAKE FLUID D-fig. 1-2-3
Undo the cap and check that the liquid contained in the
tank is at the maximum level. Fluid level in the reservoir
must not exceed the MAX mark. Use the brake fluid shown
in the “Fluids and lubricants” table (see chapter “6”).
NOTE Carefully clean the reservoir cap and the sur-
rounding surface.
When opening the cap, make sure that no dirt gets into
the reservoir.
For topping up always use a funnel with built-in filter
(mesh smaller than or equal to 0.12 mm).
IMPORTANT Brake fluid is hygroscopic (i.e. it absorbs
moisture). For this reason, if the car is mainly used in ar-
eas with a high degree of atmospheric humidity, the flu-
id should be replaced at more frequent intervals than spec-
ified in the “Scheduled Service Plan”.

CARE AND MAINTENANCE211
5
The brake fluid is poisonous and highly cor-
rosive. In case of accidental contact, wash the
parts with water and mild soap and rinse
with plenty of water. If swallowed immediately call
a doctor.
Prevent brake fluid which is highly corrosive
from coming into contact with painted parts.
Should this occur, immediately wash with
water.
The symbol πon the container indicates a
synthetic brake fluid, which is different from
a mineral fluid. Use of a mineral-based flu-
id will damage the special rubber seals of the brak-
ing system beyond repair.
The brake fluid is poisonous and highly cor-
rosive. In the event of accidental contact,
wash the parts with water and mild soap and
rinse with plenty of water. If swallowed immedi-
ately call a doctor.
The symbol πon the container indicates a
synthetic brake fluid, which is different from
a mineral fluid. Use of a mineral-based flu-
id will damage the special rubber seals of the brak-
ing system beyond repair.

218CARE AND MAINTENANCE
RUBBER HOSES
With regards to the maintenance of the brake system and
fuel system rubber hoses, carefully follow the “Sched-
uled Service Plan” in this section.
Ozone, high temperatures and prolonged lack of fluid in
the system may cause hardening and cracking of the hoses,
with possible leaks. Careful inspections are therefore nec-
essary.
WINDSCREEN/REARSCREEN
WIPERS
BLADES
Periodically clean the rubber part using special products;
TUTELA PROFESSIONAL SC35 is recommended.
Replace the blades if the rubber edge is deformed or worn.
In all cases, it is advisable to replace them approximate-
ly once a year.
A few simple precautions can reduce the possibility of
damage to the blades:
make sure that the rubber part is not stuck to the wind-
screen at sub-zero temperatures. Use an antifreeze
product to release it if required.
remove any snow from the window: this will avoid
overstressing the electrical motor in addition to pro-
tecting the blades;
do not operate the windscreen and the rear screen
wipers on dry glass.
Driving with worn wiper blades is a serious
hazard, because visibility is reduced in bad
weather.

TECHNICAL DATA225
6
Identification data ............................................................... 226
Engine codes - bodywork versions........................................ 228
Engine ................................................................................ 229
Fuel system .........................................................................231
Transmission ....................................................................... 232
Brakes.................................................................................. 232
Suspension .......................................................................... 233
Steering ............................................................................... 233
Wheels ................................................................................ 234
Dimensions ......................................................................... 238
Performance ........................................................................ 239
Weight ................................................................................ 240
Consumables ....................................................................... 242
Fluids and lubricants ........................................................... 244
Fuel consumption ................................................................ 246
CO
2 emissions ..................................................................... 248

1410
570
1077
903
1980
1300
80
601320
570
1002
888
1890
1300
80
60
240TECHNICAL DATA
WEIGHTS
Weights (kg) 1.4 Turbo Jet 1.6 Multijet
Unladen weight (with all fluids, fuel tank filled to
90% and without optional equipment)
Carrying capacity (*) including the driver:
Maximum permitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
Maximum load on roof
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen car weight increases, thus reducing the specified carrying
capacity.
(**) Loads must not be exceeded. The driver is responsible for arranging the loads in the boot and/or on the roof so that they com-
ply with these limits.

TECHNICAL DATA241
6
1430
570
1097
903
2000
1300
80
601430
570
1097
903
2000
1300
80
60
Weights (kg) 1.9 Twin Turbo Multijet 2.0 Multijet
Unladen weight (with all fluids, fuel tank filled to
90% and without optional equipment)
Carrying capacity (*) including the driver:
Maximum permitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
Maximum load on roof
Maximum load on tow hitch
(trailer with brakes):
(*) If special equipment is fitted (sunroof, tow hitch, etc.) the unladen car weight increases, thus reducing the specified carrying
capacity.
(**) Loads must not be exceeded. The driver is responsible for arranging the loads in the boot and/or on the roof so that they com-
ply with these limits.

57 ()–
8/10 –
7.1 –
4.3 () 3.60 ()
4.6 () 3.85 ()
1.87 1.7
– 0.8
6–57 –
8/10 –
5.9 –
2.75 2.4
2.9 3.3
2.4 ()2 ()
– 0.8
6–Unleaded petrol
not less than 95 R.O.N
(Specification EN228)
(
) Diesel fuel for motor vehicles
(Specification EN590)
Mixture of 50% distilled water and
50% PARAFLU UP ()
SELENIA K P.E.
SELENIA WR P.E. ()
TUTELA CAR TECHNYX
TUTELA CAR MATRYX ()
TUTELA TOP 4
Mixture of water and fluid
TUTELA PROFESSIONAL SC 35
242TECHNICAL DATA
CONSUMABLES
() When the vehicle is used under particularly harsh climate conditions, we recommend using a 60-40 mixture of PARAFLU
UP and distilled water.
1.4 Turbo Jet 1.6 Multijet Recommended fuels
litres kg litres kg and original lubricants
Fuel tank:
including a reserve of:
Engine cooling system:
Engine sump:Engine sump and filter:
Gearbox/differential casing:
Hydraulic brake circuit withABS system:
Windscreen/rear window
washer fluid reservoir: