2009 JEEP PATRIOT service reset

WARNING!
A hot engine cooling system is dangerous. You or
others could be badly burned by steam or boiling
coolant. You may want to call an authorized dealer-
ship for service if your vehicle overheats. If you
decide to look under the hood yourself, see Section 7
of this manual. Follow the warnings under the Cool-
ing System Pressure Cap paragraph.
18. Cruise Indicator — If Equipped
This indicator shows that the Speed Control
System is ON.
19. Cruise SET Indicator — If Equipped
This indicator shows that the Speed Control System is
SET.20. Shift Lever Indicator
This display indicator shows the automatic transmission
shift lever selection.
NOTE:You must apply the brakes before shifting from
PARK.
21. Odometer/Trip Odometer Reset Button
Press this button to change the display from odometer to
either of the two trip odometer settings. Trip A or Trip B
will appear when in the trip odometer mode. Push in and
hold the button for two seconds to reset the trip odometer
to 0 miles (0 km). The odometer must be in Trip mode to
reset.
22. Tire Pressure Monitoring Telltale Light
Each tire, including the spare (if provided),
should be checked monthly, when cold and
inflated to the inflation pressure recommended
by the vehicle manufacturer on the vehicle
placard or tire inflation pressure label. (If your vehicle
UNDERSTANDING YOUR INSTRUMENT PANEL 173
4

replacement, be sure to keep a record of the reading
before and after the service so that the correct mileage can
be determined.
CHAngE OIL Message
Your vehicle is equipped with an engine oil change
indicator system. The “CHAngE OIL” message will flash
in the instrument cluster odometer for approximately
12 seconds after a single chime has sounded to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate
dependent upon your personal driving style. Unless
reset, this message will continue to display each time you
turn the ignition switch to the ON/RUN position. To turn
off the message temporarily, press and release the Trip
Odometer button on the instrument cluster. To reset the
oil change indicator system (after performing the sched-
uled maintenance) refer to the following procedure.1. Turn the ignition switch to the ON position.Do not
start the engine.
2. Fully depress the accelerator pedal slowly three
times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE:If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
25. OFF ROAD Indicator — If Equipped
The symbol illuminates (is armed) when the 4WD lock
switch is activated and the transmission range indicator
is in LOW or REVERSE position.
26. Malfunction Indicator Light (MIL)
The Malfunction Indicator Light (MIL) is part of
an Onboard Diagnostic system called OBD II that
monitors emissions, engine, and automatic trans-
mission control systems. The light will illuminate when
176 UNDERSTANDING YOUR INSTRUMENT PANEL

ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated Onboard
Diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transaxle control systems. When these systems are oper-
ating properly, your vehicle will provide excellent per-
formance and fuel economy, as well as engine emissions
well within current government regulations.
If any of these systems require service, the OBD II system
will turn on the Malfunction Indicator Light (MIL). It will
also store diagnostic codes and other information to
assist your service technician in making repairs. Al-
though your vehicle will usually be drivable and not
need towing, see your authorized dealer for service as
soon as possible.CAUTION!
•Prolonged driving with the MIL on could cause
further damage to the emission control system. It
could also affect fuel economy and drivability. The
vehicle must be serviced before any emissions
tests can be performed.
•If the MIL is flashing while the engine is running,
severe catalytic converter damage and power loss
will soon occur. Immediate service is required.
Loose Fuel Filler Cap Message
After fuel is added, the vehicle diagnostic system can
determine if the fuel filler cap is possibly loose or
improperly installed. A “gASCAP” message will be dis-
played in the instrument cluster. Tighten the gas cap until
aclickingsound is heard. This is an indication that the
gas cap is properly tightened. Press the trip odometer
RESET button to turn off the message. If the problem
366 MAINTAINING YOUR VEHICLE

Maintenance Schedule.................... 408
Malfunction Indicator Light
(Check Engine).......................176,367
Manual, Service......................... 431
Manual Transaxle..................256,258,386
Downshifting......................... 260
Fluid Level Check...................387,388
Frequency of Fluid Change............387,388
Lubricant Selection...............386,387,388
Map/Reading Lights..................... 129
Master Cylinder (Brakes).................. 384
Mirrors................................ 75
Automatic Dimming..................... 76
Electric Powered....................... 79
Exterior Folding........................ 78
Outside.............................. 77
Rearview............................. 75
Vanity............................... 80
Modifications/Alterations, Vehicle............. 8Monitor, Tire Pressure System............... 319
Mopar Parts.........................368,430
Multi-Function Control Lever............... 123
New Vehicle Break-In Period................ 68
Occupant Restraints....................... 36
Octane Rating, Gasoline (Fuel).............. 328
Odometer............................. 175
Trip .............................173,175
Oil Change Indicator..................... 180
Oil Change Indicator, Reset................. 180
Oil, Engine.........................369,404
Capacity............................ 404
Change Interval....................... 370
Checking............................ 369
Disposal............................ 371
Filter............................... 372
Identification Logo..................... 371
INDEX 445
10

Trailer and Tongue Weight............... 341
Wiring.............................. 345
Trailer Towing Guide..................... 340
Trailer Weight.......................... 340
Transaxle............................. 260
Automatic....................12,256,260,386
Autostick............................ 264
Manual........................14,256,258
Operation........................... 260
Overdrive........................... 264
Selection of Lubricant................... 386
Transmitter Battery Service
(Remote Keyless Entry).................... 25
Transmitter, Garage Door Opener (HomeLink) . . 136
Transmitter Programming
(Remote Keyless Entry).................... 24
Transporting Pets........................ 68
Tread Wear Indicators.................... 315
Trip Odometer.......................... 175Trip Odometer Reset Button................ 173
Turn Signals......................126,168,400
UCI Connector......................... 229
UConnect(Hands-Free Phone).............. 81
Understanding Your Instrument Panel......... 165
Uniform Tire Quality Grades................ 432
Universal Consumer Interface (UCI) Connector . . . 229
Universal Transmitter..................... 136
Unleaded Gasoline....................... 328
Vanity Mirrors........................... 80
Variance, Compass....................... 186
Vehicle Certification Label................. 335
Vehicle Identification Number (VIN)............ 7
Vehicle Loading...................305,335,336
Vehicle Modifications/Alterations.............. 8
Vehicle Storage......................... 397
Vehicle Theft Alarm (Security Alarm).......... 19
INDEX 451
10