Transmitter, Remote Keyless Entry (RKE)........ 21
Tread Wear Indicators.................... 340
Turn Signals...................136,185,452,454
UCI Connector......................... 247
uconnect (Hands-Free Phone)................ 82
Underhood Fuses.....................444,447
Uniform Tire Quality Grades................ 494
Universal Consumer Interface (UCI) Connector . . . 247
Universal Transmitter..................... 154
Upholstery Care........................ 439
Vanity Mirrors........................... 81
Variance, Compass....................... 201
Vehicle Certification Label................. 367
Vehicle Identification Number (VIN)............ 8
Vehicle Loading......................331,367
Vehicle Modifications/Alterations.............. 9
Vehicle Storage.......................272,448Video Entertainment System™
(Rear Seat Video System).................. 257
Viscosity, Engine Oil...................... 416
Voice Recognition System (VR).............. 110
Warning Flasher, Hazard.................. 390
Warning, Roll Over........................ 5
Warnings and Cautions..................... 8
Warranty Information..................... 492
Washers, Windshield..................139,421
Washing Vehicle......................... 437
Waxing and Polishing..................... 437
Wheel and Wheel Trim.................... 439
Wheel and Wheel Trim Care................ 439
Wheel Mounting........................ 397
Wind Buffeting.......................33,162
Window Fogging........................ 271
Windows.............................. 31
Power............................... 31
516 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
