2009 HONDA RIDGELINE wheel

[x] Cancel search: wheel

Page 303 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Always use saf ety chains when you 
tow a trailer. Make sure the chains
are secured to the trailer and hitch,
and that they cross under the tongue
and can catch the trailer if it
becomes unhitched. Le

Page 309 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Always drive slowly and have 
someone guide you when backing up.
Grip the of the steering wheel,
then turn the wheel to the left to get
the trailer to move to the lef t. Turn
the wheel to the right to

Page 310 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Your vehicle has been designed 
primarily f or use on pavement. But
its higher ground clearance and f our-
wheel drive VTM-4 system allow you
to occasionally travel on unpaved
roads and surf aces. You

Page 312 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Forbettertractiononallsurfaces, 
accelerate slowly and gradually build
up speed. If you try to start too fast
on wet soil, mud, snow, or ice, you
might not have enough traction to
get underway, and yo

Page 313 of 427

HONDA RIDGELINE 2009 1.G Owners Manual The banks and surf ace under the 
water provide good traction. The
water may hide hazards such as
rocks, holes, or mud.
Bef ore driving through water, stop,
get out if necessary, and make sure
that:
I

Page 315 of 427

HONDA RIDGELINE 2009 1.G Owners Manual This section explains why it is 
important to keep your vehicle well
maintained and how to f ollow basic
maintenance saf ety precautions. 
This section also includes 
instructions on how to read the
m

Page 339 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Pour the f luid slowly and caref ully so 
you do not spill any. Clean up any
spill immediately; it could damage
components in the engine
compartment. 
A low power steering f luid level can 
indicate a

Page 342 of 427

HONDA RIDGELINE 2009 1.G Owners Manual Remove the socket from the 
headlight assembly by turning it
one-quarter turn counterclockwise. 
Pull the bulb straight out of its 
socket. Push the new bulb straight
into the socket until it bottoms.