2009 HONDA CIVIC SEDAN radiator

[x] Cancel search: radiator

Page 55 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) These labels are in the locations 
shown. They warn you of potential
hazards that could cause serious 
injury or death. Read these labels 
caref ully. 
If a label comes of f or becomes hard 
to read (

Page 256 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Look at the coolant level in the 
radiator reserve tank. Make sure it is
between the MAX and MIN lines. If 
it is below the MIN line, seeon page f or
inf ormation on adding the proper 
coolant. Refer

Page 299 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) µµµ
µ
µ
µ
Ì Engine oil level Check every 
time you fill the fuel tank. See
page . 
Engine coolant level Check the 
radiator reserve tank every time
you f ill the f uel tank. See page .

Page 301 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Î
Î
Fluid Locations
Except Si model
298
RADIATOR CAPAUTOMATIC 
TRANSMISSION
FLUID DIPSTICK
(Yellow loop) 
ENGINE COOLANT 
RESERVOIR 
CLUTCH FLUID 
(Manual
Transmission only)
(Light gray cap)
WASHE

Page 302 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Fluid Locations
Maint enance
Si model
299
RADIATOR CAP
WASHER FLUID 
(Blue cap)
ENGINE COOLANT
RESERVOIR 
CLUTCH FLUID 
(Light gray cap)
ENGINE OIL DIPSTICK
(Orange handle)
BRAKE FLUID
(Black cap)
ENG

Page 308 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) If Honda antif reeze/coolant is not 
available, you may use another
major-brand non-silicate coolant as a 
temporaryreplacement.Makesureit 
is a high-quality coolant
recommended f or aluminum engines.

Page 309 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Pour coolant into the reserve tank. 
Fill it to half way between the MAX
and MIN marks. Put the cap back 
on the reserve tank.
Do not add any rust inhibitors or 
other additives to your vehicle’s
co

Page 311 of 396

HONDA CIVIC SEDAN 2009  Owners Manual (in English) Check the f luid level with the engine 
at normal operating temperature.If the level is below the lower 
mark, add f luid into the dipstick
hole to bring it to the level
between the upper and lower
ma
Page:   1-8 9-16 next >