2009 HONDA CIVIC COUPE width

Î
ÎÎÎ
Î
Î Î
Î
Î
Î
Î
Î
Î
Î
Î
Î
Specif ications
376
Dimensions Engine
Weights
Seating Capacities 174.8 in (4,440 mm)
68.9 in (1,751 mm)
53.5 in (1,358 mm)
104.3 in (2,650 mm)
59.0 in (1,499 mm)
59.9 in (1,522 mm)
Length
Width
Height
Wheelbase
Track
Type
BorexStroke
Displacement
Compression ratio
Spark plugs
Spark plugsWater cooled 4-stroke
SOHC VTEC , DOHC i-VTEC 4-cylinder gasoline engine
3.19 x 3.44 in (81.0 x 87.3 mm) 3.39x3.39in(86x86mm) 110 cu-in (1,799 cm
)
122 cu-in (1,998 cm)
10.5
11.0
NGK:
DENSO: IZFR6K-11S
SKJ20DR-M11S
IFR7G-11KS
SK22PR-M11S
Gross vehicle weight rating See the certification label attached to the driver’s doorjamb.
Total
Front
Rear 3
2
5
60.2 in (1,528 mm)
Front
Rear
NGK:
DENSO:
1:
2: DX, Canadian DX-G, LX, EX, EX-L
Si
1:
2:
LX, Canadian DX-G (M/T), EX, EX-L
DX, Canadian DX-G (A/T)
1
2 12
1
2 1
2
1
2
1
2
\f—\f—\fy

\fy
(+\fy\f
y
2009 Civic Coupe

The tires on your vehicle meet all
U.S. Federal Saf ety Requirements.
All tires are also graded f or
treadwear, traction, and temperature
perf ormance according to
Department of Transportation
(DOT) standards. The f ollowing
explains these gradings.
Quality grades can be f ound where
applicable on the tire sidewall
between tread shoulder and
maximum section width. For
example:The treadwear grade is a compara-
tive rating based on the wear rate of
the tire when tested under controlled
conditions on a specif ied government
test course. For example, a tire
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative perf ormance of
tires depends upon the actual condi-
tions of their use, however, and may
depart signif icantly f rom the norm
due to variations in driving habits,
service practices and dif f erences in
road characteristics and climate.The traction grades, f rom highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specif ied government test surf aces
of asphalt and concrete. A tire
marked C may have poor traction
perf ormance.
All passenger car tires must conf orm
to Federal Saf ety Requirements in
addition to these grades. Warning: The traction grade
assignedtothistireisbasedon
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
Unif orm T ire Quality Grading
T readwear 200
Traction AA
Temperature A T readwear T raction
DOT Tire Quality Grading (U.S. Vehicles)
Technical Inf ormation
379
\f—\f—\fy

y
(+\fy\fy
2009 Civic Coupe

µ
µ
µ
µµ
µ µ
µ
µ
The tires that came on your vehicle
have a number of markings. Those
you should be aware of are described
below.
Manuf acturer’s
identification mark.
This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.
The tire identif ication number (TIN)
is a group of numbers and letters
that look like the f ollowing example.
TIN is located on the sidewall of the
tire. Load index (a numerical code
associated with the maximum
load the tire can carry).
Whenever tires are replaced, they
should be replaced with tires of the
same size. Following is an example
of tire size with an explanation of
what each component means.
Vehicletype(Pindicates
passenger vehicle).
Tire width in millimeters.
Aspect ratio (the tire’s section
height as a percentage of its
width).
Tire construction code (R
indicates radial).
Rim diameter in inches. Speed symbol (an
alphabetical code indicating
the maximum speed rating).
P
R DOT
B97R
205
55
16 89
H
CONT INUED
T ire Ident if icat ion Number (T IN)
Tire Size
Tire Labeling
Technical Inf ormation
381
(3)
(4)
Tire Labeling Example
(1)
(2) (1)
(1) Tire Size
(2) Tire Identification Number (TIN)
(3) Maximum Tire Pressure
(4) Maximum Tire Load
DOT B97R FW6X 2202
P205/55R16 89H
\f—\f—\fy


y
(+\fy\fy
2009 Civic Coupe