19
Power Running Boards
(if equipped)
The power running boards extend from
beneath the vehicle when any side door
is open. The vehicle must be stationary
for the running boards to operate. To
disable the running boards, press the
(Running Boards) disable button
on the instrument panel. Press the
button
again to turn the running boards
back on.
See Section 2 of your Owner Manual.
position to turn off the Automatic
Headlamp System and all exterior lights,
excluding the DRLs. Turn the knob to
this position again to turn on the system.
AUTO (Automatic):Automatically turns
on the DRLs in the daytime and the
Automatic Headlamp System at night or
when necessary.
(Parking Lamps):Manually turns
on parking lamps and taillamps.
(Headlamps):Manually turns on
the headlamps and other exterior lamps.
(Fog Lamps)(if equipped): Press
this button to turn the fog lamps on
or off.
Interior Lamp Controls
(Instrument Panel Brightness):
Turn this pop-out knob to adjust the
brightness of the instrument panel lights.
(Dome Lamp Override):Press
this button in to turn the dome
lamps off when the doors are open.
Press the button again to have the
dome lamps turn on automatically when
a door is opened.
See Section 3 of your Owner Manual.
Use the Remote Keyless Entry (RKE)
transmitter or the power door lock
switches to unlock the liftgate.
Liftgate:Press the touchpad (A) on
the back of the handle in the center of
the liftgate; then pull up the liftgate to
open it.
Liftglass:Press the touchpad (B) on the
liftgate, located above the right side of
the license plate, or use the RKE trans-
mitter to unlatch the liftglass.
Power Liftgate (if equipped)
There are several ways to open and
close the power liftgate:
• Press and hold the power liftgate but-
ton on the RKE transmitter until the
liftgate starts moving.
• Press the touchpad on the liftgate
handle to open.
• Press the button on the bottom of the
liftgate to close.
• Press the (Power Liftgate) switch
on the overhead console inside the
vehicle.
To turn off the power liftgate function,
press the OFF (Power Liftgate Off)
switch on the overhead console.
See Section 2 of your Owner Manual.
Liftgate and Liftglass Operation
AB
Getting to Know Your Yukon/Yukon Denali22
StabiliTrak is an
advanced comput-
er-controlled vehicle
stability and traction
enhancement sys-
tem that assists
with directional control of the vehicle in
difficult driving conditions. It turns on
automatically every time you start your
vehicle.To limit wheelspin and help
maintain directional control, you should
always leave the system on. However, if
your vehicle becomes stuck and rocking
the vehicle is required, the system
should be turned off.
To turn off the traction control part of the
system, press the (StabiliTrak) but-
ton located below the climate controls
on the instrument panel.
To turn off the traction control and stabil-
ity enhancement systems, press and
hold the button for five seconds.
StabiliTrak®– Stability Control
System (if equipped)
The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the (Low Tire
Pressure) warning light, which will remain
on until you correct the tire pressure. You
may also have a CHECK TIRE PRES-
SURE message appear on the DIC
(if equipped).
Correcting the Tire Pressure
When the low tire pressure warning light
illuminates, you must inflate the tire to
the proper tire pressure (just as you
must refuel the vehicle when the low
fuel warning light illuminates). The Tire
and Loading Information label shows the
correct tire pressure for the tires when
they’re cold. “Cold” means your vehicle
has been sitting for at least three hours
or driven no more than one mile.
You can temporarily remove the DIC mes-
sage by acknowledging it with your DIC
controls. However, at the next vehicle
start-up, the DIC message will reappear if
the tire pressure has not been corrected.
During cooler conditions, the low tire
pressure warning light may appear when
the vehicle is first started and then turn
off as you start to drive. This could be
an early indicator that your tire pres-
sures are getting low and the tires need
to be inflated to the proper pressure.
See Section 5 of your Owner Manual.
Tire Pressure Monitor
Note:The Tire Pressure Monitor can alert
you about low tire pressure, but it doesn’t
replace normal monthly tire maintenance.
When the system is turned off, the
StabiliTrak light will illuminate.
See Section 4 of your Owner Manual.
To use this feature, move the shift lever
to the Manual (M) position and select a
lower or higher driving gear using the
+ / – button on the shift lever. The dis-
play on the instrument panel cluster will
show the current gear selection.
Press the – (minus) side of the button to
downshift. When slowing to a stop, the
vehicle will automatically downshift.
Press the + (plus) side of the button to
upshift. As vehicle speed increases, you
will need to manually upshift.
If current vehicle speed is too high or
too low for the requested gear, the shift
will not occur.
See Section 2 of your Owner Manual.