Partially lower the tailgate
1. With the tailgate fully open, lift it up
slightly.
2. Remove the retaining cable from
each side of the tailgate by pulling the
clip away from the bolt head while
pushing the cable bracket forward.
When the larger part of the hole on
the bracket is over the bolt, slide the
bracket off.
3. Slide the
lower end fit-
ting onto the
top bolt on
each side of
the tailgate.
Partially
lower the
tailgate.
Tailgate lock (if equipped)
The tailgate also includes a lock that
can be used when the tailgate is in a
normal, upright position.
See Section 2 of your Owner Manual.
15
Two-Tier Loading and
Optional Bed Extender
You can create an upper load platform
by positioning four 2x6 wooden planks
across the width of the pickup box.
Insert the planks into the pickup box
depressions (below), allowing for at
least a 3/4-inch (2-cm) bearing surface
on each end of the plank.
Ensure that the upper-tier load is
securely tied down, with its center of
gravity in a zone over the rear axle.
See Section 4 of your Owner Manual.
Cargo Tie-Downs and Bed Rails
To secure loads, use the cargo tie-down
loops inside the cargo bed area. If your
truck is equipped with bed rails, do not
attempt to use them to secure loads,
as they are for appearance only. Using
the bed rails as a load anchor not only
can damage them but may cause the
load to loosen, possibly causing injury.
See Section 4 of your Owner Manual.
Note:An accessory bed extender,
available from your dealer, provides
even more flexibility for longer loads.
Note:The tailgate cannot be closed in
this position. The top end fitting of the
bracket must be anchored on the bot-
tom bolt to close the tailgate.
Cargo bed depressions for two-tier loading
