2009 FORD F750 engine

[x] Cancel search: engine

Page 237 of 276

FORD F750 2009 12.G Owners Manual GENERAL MAINTENANCE INFORMATION
The general maintenance services listed in this section are required
because they are considered essential to the life and performance of
your vehicle. Refer to the “

Page 239 of 276

FORD F750 2009 12.G Owners Manual FACTORY AUTHORIZED SYSTEMS CHECKS
In the event that your vehicle experiences a component related concern,
please contact your Ford dealership. The Ford Motor Company Trained
Technicians who work at Fo

Page 240 of 276

FORD F750 2009 12.G Owners Manual Avoid driving your vehicle if it does not operate properly. If the engine
diesels (more than five seconds of engine run-on after shut-off), misfires,
surges, stalls or backfires, see your dealer. Be a

Page 241 of 276

FORD F750 2009 12.G Owners Manual Among those acts presumed to constitute tampering are the following
acts listed:
Vehicle System Acts
Acoustical Shielding Removal of noise shields, hood
blanket, tunnel liner or acoustical
absorptive

Page 242 of 276

FORD F750 2009 12.G Owners Manual MAINTENANCE
Instructions for maintenance and service of the noise control system
have been included in the required maintenance services and in the
general maintenance section. To further help minimiz

Page 244 of 276

FORD F750 2009 12.G Owners Manual SCHEDULED MAINTENANCE GUIDE
MAINTENANCE SERVICES AND RECORD RETENTION
The maintenance record form which follows is for your convenience. In addition to recording the services performed, you should
ret

Page 245 of 276

FORD F750 2009 12.G Owners Manual Daily owner checks
EngineCheck the air filter restriction gauge.
Check the engine oil.
Inspect the coolant level
Brake systemCheck the air brake system reservoir
automatic drain valve operation.
Drain

Page 246 of 276

FORD F750 2009 12.G Owners Manual Check every oil change
Engine systemCheck the engine cooling system -
hoses, clamps and protection*.
Inspect the drive belts.
Exhaust systemInspect the entire exhaust system
(including the inlet pipe(