2009 FORD E SERIES bulb

2. Remove the four screws from the
top and bottom front of the
headlamp assembly and carefully
remove the lamp/bezel.
3. Remove the four screws and the
retaining ring.
4. Disconnect the electrical
connector from the lamp and
remove the lamp.
To install the new lamp, follow the
removal procedures in reverse order.
Replacing front parking lamp/turn signal bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly, refer toReplacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
3. Rotate the bulb socket counterclockwise and remove.
4. Carefully pull the bulb straight out of the socket.
To complete installation, follow the removal procedures in reverse order.
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Lights
53

Replacing side marker bulbs
1. Make sure the headlamp control is in the off position.
2. Remove the headlamp assembly. Refer toReplacing headlamp bulbs
in this section.
Aerodynamic
Sealed beam
3. Rotate the bulb socket counterclockwise and remove.
4. Carefully pull the bulb straight out of the socket.
To complete installation, follow the removal procedures in reverse order.
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Lights
54

Replacing high-mount brakelamp bulbs
On vehicles without a rear headliner, the interior cargo lamp (if
equipped) will have to be removed from under the high-mount
brakelamp assembly located inside the vehicle. Then, do the following:
1. Remove the two screws from the
high-mount brakelamp assembly and
lift the lamp from the vehicle.
2. Remove the bulb socket from the
lamp assembly by turning
counterclockwise.
3. Carefully pull the bulb straight
out of the socket.
To install the new bulb, follow the removal procedure in reverse order.
Replacing license plate lamp bulbs
1. Turn the headlamp switch to the
off position.
2. Remove the two screws and the
license plate lamp assembly from
the rear door.
3. Remove bulb socket from lamp
assembly by turning
counterclockwise.
4. Pull the bulb out from socket and
push in the new bulb.
To install the new bulb, follow the removal procedures in reverse order.
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Lights
55

Replacing stop/turn/tail/side marker/backup lamp bulbs
The stop/turn/tail/side marker/backup lamp bulbs are located in the tail
lamp assembly. Follow the same steps to replace any of the bulbs:
1. Turn the headlamp switch to the
off position and then remove the
four screws and the lamp assembly
from vehicle.
2. Rotate bulb socket
counterclockwise and remove from
lamp assembly.
3. Carefully pull the bulb straight
out of the socket and push in the
new bulb.
To install the lamp, follow the removal procedures in reverse order.
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Lights
56

Switching Off AdvanceTracwith RSC
If the vehicle is stuck in snow, mud or sand, and seems to lose engine
power, switching off certain features of the AdvanceTracwith RSC
system may be beneficial because the wheels are allowed to spin. This
will restore full engine power and will enhance momentum through the
obstacle. To switch off the AdvanceTracwith RSCsystem partially,
press the AdvanceTracwith RSCOffbutton below 20 mph
(32 km/h). Full features of the AdvanceTracwith RSCsystem can be
restored by pressing the AdvanceTracwith RSCOffbutton again or
if the vehicle is above 20 mph (32 km/h) or by turning off and restarting
the engine.
If you switch off the AdvanceTracwith RSCsystem below 20 mph
(32 km/h), the sliding caricon
will illuminate steadily. Pressing the
AdvanceTracwith RSCOffbutton again or if the vehicle is above
20 mph (32 km/h) will turn off thesliding car
icon. The switch will
not allow partial AdvanceTracwith RSCsystem disabling above
20 mph (32 km/h).
In R (Reverse), ABS and the Engine and Brake Traction Control features
will continue to function; however, ESC and RSCare disabled.
AdvanceTracwith RSCFeatures
Button
functions“Sliding
car”
icon
RSCESCTraction
Control
Default at
start-upIlluminated
during bulb
checkEnabled Enabled Enabled
Button pressed
momentarilyIlluminated
solidEnabled EnabledDisabled
below
20 mph
(32 km/h)
Button pressed
again after
deactivation or
driving above
20 mph
(32 km/h)Not
illuminatedEnabled Enabled Enabled
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Driving
202

4. Driving through deep water—the electrical system may be wet.
These temporary malfunctions can be corrected by filling the fuel tank
with good quality fuel, properly tightening the fuel cap or letting the
electrical system dry out. After three driving cycles without these or any
other temporary malfunctions present, theService engine soon
indicator should stay off the next time the engine is started. A driving
cycle consists of a cold engine startup followed by mixed city/highway
driving. No additional vehicle service is required.
If theService engine soon
indicator remains on, have your vehicle
serviced at the first available opportunity. Although some malfunctions
detected by the OBD-II may not have symptoms that are apparent,
continued driving with theService engine soon
indicator on can
result in increased emissions, lower fuel economy, reduced engine and
transmission smoothness, and lead to more costly repairs.
Readiness for Inspection/Maintenance (I/M) testing
Some state/provincial and local governments may have
Inspection/Maintenance (I/M) programs to inspect the emission control
equipment on your vehicle. Failure to pass this inspection could prevent
you from getting a vehicle registration. Your vehicle may not pass the I/M
test if theService engine soon
indicator is on or not working
properly (bulb is burned out), or if the OBD-II system has determined
that some of the emission control systems have not been properly
checked. In this case, the vehicle is considered not ready for I/M testing.
If theService engine soon
indicator is on or the bulb does not
work, the vehicle may need to be serviced. Refer to the On board
diagnostics (OBD-II) description in this chapter.
If the vehicle’s engine or transmission has just been serviced, or the
battery has recently run down or been replaced, the OBD-II system may
indicate that the vehicle is not ready for I/M testing. To determine if the
vehicle is ready for I/M testing, turn the ignition key to the on position
for 15 seconds without cranking the engine. If theService engine
soon
indicator blinks eight times, it means that the vehicle is not
ready for I/M testing; if theService engine soon
indicator stays on
solid, it means that the vehicle is ready for I/M testing.
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Maintenance and Specifications
293

A
Accessory delay ..........................63
AdvanceTrac ..............................198
Air cleaner filter ...............300–302
Airbag supplemental restraint
system ................................107–108
and child safety seats ............109
description ..............................108
disposal ....................................112
driver airbag ............................110
indicator light .........................112
operation .................................110
passenger airbag .....................110
passenger deactivation
switch ......................................113
Ambulance packages ....................8
Antifreeze
(see Engine coolant) ................275
Anti-lock brake system
(see Brakes) ......................195–196
Anti-theft system ........................86
arming the system ....................87
Audio system
(see Radio) ......................20, 22, 27
Automatic transmission
driving an automatic
overdrive .................207, 209, 212
fluid, adding ............................296
fluid, checking ........................296
fluid, refill capacities ..............303
fluid, specification ..................303
Auxiliary Input Jack ...................34
Auxiliary power point .................61
Axle
lubricant specifications ..........303
refill capacities ........................303
traction lok ..............................203B
Battery .......................................272
acid, treating emergencies .....272
jumping a disabled battery ....242
maintenance-free ....................272
replacement, specifications ...302
servicing ..................................272
Belt-Minder.............................103
Booster seats .............................132
Brakes ........................................195
anti-lock ...........................195–196
anti-lock brake system (ABS)
warning light ...........................196
fluid, checking and adding ....295
fluid, refill capacities ..............303
fluid, specifications .................303
lubricant specifications ..........303
parking ....................................196
shift interlock ..........................205
trailer .......................................184
Bulbs ............................................50
C
Capacities for refilling fluids ....303
Cell phone use ..............................9
Changing a tire .........................232
Child safety seats ......................121
in front seat ............................121
in rear seat ..............................121
LATCH .....................................124
recommendations ...................119
tether anchorage hardware ...127
Child safety seats - booster
seats ...........................................132
Cleaning your vehicle
engine compartment ..............260
exterior ....................................263
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Index
316

Event data recording ....................6
Exhaust fumes ..........................193
F
Fail safe cooling ........................280
Flexible Fuel Vehicle (FFV) ....281
Fluid capacities .........................303
Four-Wheel Drive vehicles
preparing to drive your
vehicle .....................................203
Fuel ............................................281
calculating fuel economy .......288
cap ...........................................284
capacity ...................................303
choosing the right fuel ...........286
comparisons with EPA fuel
economy estimates .................291
detergent in fuel .....................286
filling your vehicle with
fuel ...........................281, 284, 288
filter, specifications ........281, 302
fuel pump shut-off switch .....223
improving fuel economy ........288
octane rating ...................286, 310
quality ......................................287
running out of fuel .................287
safety information relating to
automotive fuels .....................281
Fuel - flex fuel vehicle
(FFV) .................................281, 286
Fuses ..........................................225
G
Garage door opener ....................59
Gas cap (see Fuel cap) ............284
Gas mileage
(see Fuel economy) .................288Gauges .........................................17
H
Hazard flashers .........................222
Head restraints ...........................90
Headlamps ...................................45
aiming ........................................48
bulb specifications ....................51
daytime running lights .............45
flash to pass ..............................46
high beam .................................45
replacing bulbs .........................52
turning on and off ....................45
Heating
heater only system .............42, 44
heating and air conditioning
system .......................................43
Hood ..........................................266
I
Ignition ...............................190, 310
Illuminated visor mirror .............58
Infant seats
(see Safety seats) .....................121
Inspection/maintenance (I/M)
testing ........................................293
Instrument panel
cleaning ...................................262
cluster ........................................12
lighting up panel and
interior .......................................46
J
Jack ............................................232
positioning ...............................232
storage .....................................232
Jump-starting your vehicle ......242
2009 Econoline(eco)
Owners Guide, 1st Printing
USA(fus)
Index
318