2009 FIAT ULYSSE coolant

IN AN EMERGENCY
176
FUSEBOX IN THE ENGINE COMPARTMENT fig. 39
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
17
1810A
15A
10A
10A
10A
15A
20A
20A
15A
15A
10A
10A
15A
10A
30A
30A
40AReverse light switch, Xenon lights, electric fan controls, engine coolant level,
heated diesel filter, preheating spark plugs,
speed control system, air debit gauge
Fuel pump, exhaust gas recirculation and turbo-compressor control system
ABS, ESP
Keyed service power supply, for main electronic control unit
Particulate filtering system
Front fog lights
Headlight washers
Relay power supply for main electronic control unit, electric fan relay controls ,
diesel pressure adjusting solenoid valve and exhaust gas
recirculation
Left dipped beam headlight, headlight beam corrector
Right dipped beam headlight
Left main beam headlight
Right main beam headlight
Horn
Windscreen wiper pump - rear window wiper
Lambda sensor, injectors, spark plugs, canister solenoid valve,
injection pump solenoid valve
Windscreen wiper
Additional fans
153-183 ULYSSE ING:153-183 ULYSSE ING 13-11-2009 10:07 Pagina 176

SERVICE SCHEDULE
30 60 90 120 150 180
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●●●●●
●●●
●
●●●●●●
CAR MAINTENANCE
185
Thousands of kilometres
Check tyre conditions/wear and adjust pressure if required
Check light system operation
(headlights, direction indicators, hazard lights, boot lights, passenger
compartment lights, glovebox lights, warning lights, horn)
Check windscreen wiper/washer operation, adjust nozzles if required
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear and pad wear
indicator operation
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts, underbody protection, pipes
and hoses (exhaust - fuel - brakes), rubber parts (boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness and lubrication
Check and top up, if required, fluid levels (brakes/hydraulic clutch,
windscreen/rear window washer, battery, engine coolant, etc.)
Check and adjust handbrake lever stroke, if required
Sight inspect accessory drive belt conditions
Check accessory drive belt tension (for engines without automatic belt tightener)
Sight inspect timing belt conditions
Check exhaust emissions/smoke
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 185

CAR MAINTENANCE
187
Every 1,000 km or before long jour-
neys, check and top up if required:
– engine coolant fluid level;
– brake fluid level;
– windscreen washer fluid level;
– yre pressure and conditions;– light system operation (headlights,
direction indicators, hazard lights,
etc.);
– windscreen wiper/washer opera-
tion and windscreen/rear window
blade position/wear;Every 3,000 km check and top up if
required: engine oil level.
You are recommended to use
PETRONAS LUBRICANTS, products,
designed and produced specifically for
Fiat vehicles (see table “Capacities” in
section “Technical specifications”).
ROUTINE MAINTENANCE
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 187

CAR MAINTENANCE
190
1.Windscreen/rear window and
headlight (for versions/markets, where
provided) washer fluid -2.Engine
coolant - 3.Power steering fluid -
4.Engine oil - 5.Brake and hydraulic
clutch fluid.
fig. 1 - Versions 2.0 JTD 120 HP - 136 HPF0B0442b
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 190

CAR MAINTENANCE
191
1.Windscreen/rear window and
headlight (for versions/markets, where
provided) washer fluid -2.Engine
coolant - 3.Power steering fluid -
4.Engine oil - 5.Brake and hydraulic
clutch fluid.
fig. 2 - Versions 2.2 JTDF0B0600b
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 191

CAR MAINTENANCE
194
Do not remove the
reservoir cap when the
engine is hot: you risk
scalding yourself. ENGINE COOLANT fig. 5-6Check coolant level when the engine
is cold. The level should be included
between the MINand MAXrefer-
ence line on the reservoir.If the level is low, loosen the header
tank cap Aand slowly pour a mixture
of the fluid specified in the ”Lubricant
and fluid specifications” table in sec-
tion “Technical Specifications”,
through the filler neck until nearing the
MAXmark.
The antifreeze mixture contained in
the cooling circuit guarantees protec-
tion down to –40°C.
fig. 5 - Versions 2.0 JTD 120 HP - 136 HP
F0B0444b
fig. 6 - Versions 2.2 JTD
F0B0602b
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 194

RIGHT-HAND DRIVE VERSIONS
235
1.Side vents
2.Passenger air bag
3.Sound system/Infotelematic Connect system (where
fitted)
4.Sound system/Infotelematic Connect system display
(where fitted)
5.Revolution counter
6.Speedometer
7.Fuel gauge with low fuel warning light and engine
coolant temperature gauge with warning light showing
when the temperature is too high
8.Central vents
9.Gear lever
10.Left-hand stalk: headlight control
11.Horn
12.Instrument panel: odometer display and warning lights
13.Right-hand stalk, windscreen washer, rear window
washer and trip computer14.ASR system on/off.
15.Headlight beam adjuster (Xeno light versions excluded)
16.Sound system controls on steering wheel
17.Ignition switch
18.Driver air bag
19.Document compartment
20.Cruise control control lever
21.Ashtray and glove compartment
22.Console
23.Glove compartment/Infotelematic Connect system re-
mote controls (where fitted)
24.Cigar lighter
25.Hazard lights
26.Climate system automatic controls
27.Glove compartment
234-239 ULYSSE ING:234-239 ULYSSE ING 5-11-2009 12:11 Pagina 235

RIGHT-HAND DRIVE VERSIONS
237
A - Rev counter
B- Speedometer
C- Fuel gauge with reserve tank
warning light
D- Coolant temperature gauge with
warning light showing when the tem-
perature is too high
fig. 6F0B0056b
234-239 ULYSSE ING:234-239 ULYSSE ING 5-11-2009 12:11 Pagina 237