2009 FIAT ULYSSE check engine light

DRIVING YOUR CAR
147
CHEAP RUNNING THAT RESPECTS
THE ENVIRONMENT
LOOKING AFTER EMISSION
CONTROL DEVICES
The correct use of pollution control
devices not only ensures respect for
the environment but also has an effect
on the car’s performance. Keeping
these devices in good condition is
therefore a fundamental rule for dri-
ving that is easy on your pocket and
on the environment too.
The first step to take is to follow the
Service Schedule to the letter.
Only use diesel for motor vehicles
(EN590 specification). Environmental protection has been
one of the guiding principles in the
production of the Ulysse. It is no ac-
cident that its pollution control equip-
ment is much more effective than that
required by current legislation.
Nonetheless, the environment can-
not get by without a concerted effort
from everyone.
By following a few simple rules the
motorist can avoid harming the envi-
ronment and often cut down fuel con-
sumption at the same time.
On this subject, a number of useful
tips have been given below to supple-
ment those marked by symbol
#, at
various points of the manual.
You are asked to read both the for-
mer and latter carefully.If you have trouble starting, do not
turn the ignition key for long periods.
Be especially careful to avoid bump
starting the vehicle by pushing, towing
or rolling downhill: these are all ma-
noeuvres that can damage the catalyt-
ic exhaust.
For emergency starts only use an
auxiliary battery.
If the engine begins to “lose its
smoothness” when travelling, contin-
ue your journey but reduce the de-
mands you are making on the engine
and have the vehicle checked at a Fi-
at Dealership.
When the instrument panel fuel re-
serve warning light comes on, fill up as
soon as possible. A fuel level that is
too low can cause an uneven supply of
fuel with the inevitable increase in ex-
haust temperature; this would seri-
ously damage the catalytic converter.
136-152 ULYSSE ING 10-03-2009 11:40 Pagina 147

DRIVING YOUR CAR
151
STORING THE CAR
The following precautions should be
taken if the car will not be used for
several months:
– park the vehicle in covered, dry and
if possible well-ventilated premises;
– engage a gear (Pfor versions with
automatic electronic gear);
– make sure the handbrake is not en-
gaged;
– clean and protect the painted parts
using protective wax;
– sprinkle talcum powder on the rub-
ber windscreen and rear window
wiper blades and lift them off the glass;
– slightly open the windows;
– inflate the tyres to 0.5 bar above
the normal specified pressure and
check it at intervals;– switch off the electronic car alarm;
– disconnect the terminals (–) from
the battery poles (negative pole first)
and check the battery charge. When
the vehicle is in storage, this check
should be carried out once a month.
If no-load voltage is less than 12.5V,
recharge the battery;
– do not drain the engine cooling sys-
tem;
– cover the vehicle with a cloth or
perforated plastic sheet. Do not use
sheets of non-perforated plastic as
they do not allow moisture on the car
body to evaporate.RESTARTING THE CAR
AFTER STORAGE
Before restarting the vehicle after a
long storage, make the following op-
erations:
– do not take dust off the bodywork
without water;
– check if there are fluid leakages (oil,
brake and clutch fluid, engine coolant,
etc.);
– have the engine oil and the filter re-
placed;
– check the level of: brake and clutch
fluid, engine coolant;
136-152 ULYSSE ING 10-03-2009 11:40 Pagina 151

IN AN EMERGENCY
155
An incorrectly posi-
tioned jack may cause the
vehicle to fall. Do not use
the jack to lift loads exceeding
that indicated on the label at-
tached to the jack itself.Do not lubricate the bolt
threads before fitting
them back: they could
come loose.
Never start the engine when the
vehicle is jacked up.
If you are towing a trailer, re-
move the trailer before jacking
up the vehicle.Never tamper with the
inflation valve. Never
place tools between the
rim and the tyre.
Check the tyre and space-saver
spare wheel pressure regularly.
The tyre inflation pressure is
shown in the “Technical specifi-
cations” chapter.
The jack should only be
used to change a wheel
on the vehicle for which it
was designed. It should not be put
to other uses or employed to
raise other models. Under no cir-
cumstances should it be used
when carrying out repairs under
the vehicle.
Check the inflation pres-
sure of the tyres and the
spare wheel regularly. If
you change the type of wheels (al-
loy rims instead of steel rims) you
will have to change the entire set
of fastening bolts with another
set of suitably sized bolts.
You should keep the bolts in
case you decide to use the origi-
nal type of wheel later on.Signal the presence of
the stopped car according
to the laws in force: haz-
ard lights, reflecting triangle, etc.
Any passengers on board should
leave the car, especially if it is
heavily laden. Passengers should
stay away from oncoming traffic
while the wheel is being changed.
If the wheel is being changed on
a steep or badly surfaced road,
place wedges or other suitable
material under the wheels to
stop the car.
GENERAL INSTRUCTIONS
Observe the instructions on this and
the following pages to use the jack and
space-saver spare wheel correctly.
153-183 ULYSSE ING:153-183 ULYSSE ING 13-11-2009 10:07 Pagina 155

SERVICE SCHEDULE
30 60 90 120 150 180
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●●●●●
●●●●●●
●●●●●●
●●●
●●●●●●
●●●
●
●●●●●●
CAR MAINTENANCE
185
Thousands of kilometres
Check tyre conditions/wear and adjust pressure if required
Check light system operation
(headlights, direction indicators, hazard lights, boot lights, passenger
compartment lights, glovebox lights, warning lights, horn)
Check windscreen wiper/washer operation, adjust nozzles if required
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear and pad wear
indicator operation
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts, underbody protection, pipes
and hoses (exhaust - fuel - brakes), rubber parts (boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness and lubrication
Check and top up, if required, fluid levels (brakes/hydraulic clutch,
windscreen/rear window washer, battery, engine coolant, etc.)
Check and adjust handbrake lever stroke, if required
Sight inspect accessory drive belt conditions
Check accessory drive belt tension (for engines without automatic belt tightener)
Sight inspect timing belt conditions
Check exhaust emissions/smoke
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 185

CAR MAINTENANCE
187
Every 1,000 km or before long jour-
neys, check and top up if required:
– engine coolant fluid level;
– brake fluid level;
– windscreen washer fluid level;
– yre pressure and conditions;– light system operation (headlights,
direction indicators, hazard lights,
etc.);
– windscreen wiper/washer opera-
tion and windscreen/rear window
blade position/wear;Every 3,000 km check and top up if
required: engine oil level.
You are recommended to use
PETRONAS LUBRICANTS, products,
designed and produced specifically for
Fiat vehicles (see table “Capacities” in
section “Technical specifications”).
ROUTINE MAINTENANCE
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 187

Top up only with the
same fluid contained in
the cooling circuit.
PARAFLU
UP(red) cannot be
mixed with PARAFLU11(blue) or
with other fluids. Should this take
place, do not start the engine and
contact Fiat Dealership.
CAR MAINTENANCE
195
WINDSCREEN - REAR
WINDOW - HEADLIGHT
WASHER FLUID fig. 7-8
(for versions/markets, where provided)
Remove cap Aand check the fluid
level.
If it is necessary to top up the fluid,
pour in a mixture of water and
TUTELA PROFESSIONAL SC 35
fluid in the following proportions:
– 30% of TUTELA PROFES-
SIONAL SC 35and 70% of water in
summer; The cooling system is
pressurised. If necessary,
replace the cap only with
another genuine one, otherwise
system efficiency could be com-
promised.– 50% of TUTELA PROFES-
SIONAL SC 35and 50% of water in
winter;
– use undiluted TUTELA PRO-
FESSIONAL SC 35for tempera-
tures below –20°C.
fig. 7 - Versions 2.0 JTD 120 HP - 136 HP
F0B0445b
fig. 8 - Versions 2.2 JTD
F0B0603b
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 195

CAR MAINTENANCE
203
USEFUL ADVICE FOR
LENGTHENING THE LIFE
OF YOUR BATTERY
To preserve the battery charge and
its functions, observe the following in-
structions:
– when you park the car, ensure the
doors, tailgate and bonnet are closed
properly. The ceiling lights must be off;
– the battery cables must be well fas-
tened;
– do not keep accessories (e.g.:
sound system, hazard lights, etc.)
switched on for a long time when the
engine is not running;
– before performing any operation
on the electrical system, disconnect
the battery negative cable.IMPORTANTA battery which is
kept at a charge of less than 50% for
any length of time will be damaged by
sulphation leading to a reduction in
cranking power and a higher risk of
the battery electrolyte freezing (this
may even occur at –10°C). If the car
is inactive for a long period of time, re-
fer to “Storing the car”, in “Getting to
know your car” section.If after buying the car, you want to
install electric accessories which re-
quire permanent electric supply, con-
tact a Fiat Dealership, whose qual-
ified personnel, in addition to sug-
gesting the most suitable devices be-
longing to the Lineaccessori Fiat, will
evaluate the overall electric absorp-
tion, checking whether the vehicle’s
electric system is capable of with-
standing the load required, or whether
it should be integrated with a more
powerful battery.
184-213 ULYSSE ING:184-213 ULYSSE ING 13-11-2009 10:13 Pagina 203

INDEX
241
- maintenance indicator............ 54
- scheduled servicing ................ 184
- service
schedule ............................ 185-186
Ceiling lights
(central and rear) ..................... 103
- bulb replacement ................... 168
Central door locking system ..... 22
Central glass/can holder ............. 97
Chassis marking ........................... 216
Cheap running that respects
the environment ....................... 145
Checking fluid levels ................... 189
- brake and hydraulic
clutch fluid ................................ 197
- engine coolant.......................... 195
- engine oil ................................... 193
- power steering fluid ............... 196
- windscreen/rear window/
headlight washer fluid ............ 195
Child restraint systems .............. 42
- passenger seat compliance
with regulations on child’s
seat use...................................... 46
- presetting for mounting
“Isofix Type” child' seat ......... 47
Child safety lock
- electrical .................................... 23- mechanical ................................ 23
Child surveillance (mirrors)....... 35
Cigar lighter ................................. 101
Climate control system ............. 62
- air vents ............................ 63-64
Clutch
- technical specifications........... 221
CO
2emissions in exhaust ......... 233
CODE card
(Fiat CODE system) ................ 11
Compartments under front
seats .............................................. 98
CONNECT ................................... 56
Containing running costs
and pollution .............................. 145
Cruise Control ............................. 88
Dashboard ................................. 48
Diesel fuel filter
(draining the condense) .. 190-200
Dimensions ................................... 226
Dipped beam headlights
- control ....................................... 79
- halogen bulb replacement ..... 163
- Xenon light replacement ....... 164
Direction indicators
- control ...................................... 82- replacing front bulbs ............. 162
- replacing side bulbs ............... 165
- types ........................................... 161
Document compartment............ 98
Door lights ................................... 104
Doors super lock ......................... 22
Driving your car ........................... 136
EBD (Electronic braking
force distributor) ...................... 118
Elastic bands .................................. 100
Electric windows ......................... 105
- anti-crushing system ............... 105
- driver’s door controls ........... 105
- passenger’s door controls .... 106
- sliding door controls .............. 106
Electrical sockets .......................... 104
Electro-chromatic mirror........... 34
Electronic alarm .......................... 14
- deactivation without the
remote control ....................... 17
- programming the system....... 17
- request for additional
remote controls ...................... 17
- switching the volumetric
protection off ........................... 17
240-252 ULYSSE ING:240-252 ULYSSE ING 5-11-2009 12:13 Pagina 241