7
FIAT PUNTO NATURAL POWER
3) Excess flow,it intervenes if the piping
is broken limiting the flow of methane to
values that are not dangerous.
The flow restricter valve is located to al-
low it to operate even if the solenoid valve
casing is broken due to an impact.
4) Manual tap,it is located upstream of
the solenoid valve.
SOLENOID VALVES/
SAFETY DEVICES
The solenoid valves Fig. 5and Fig. 6are
bolted directly onto the methane canis-
ters with the main function on interrupt-
ing the flow of methane to the supply cir-
cuit.
The solenoid valves are open when:
❒the switching button is in the methane
position;
❒the pressure in the canister is sufficient
for operation;
❒the engine is running;
❒the inertia switch has not been trig-
gered.
The solenoid valve assembly is equipped
with the following safety devices:
1) Fuse pad,in the case of overheating
(temperature above 110 °C), it totally
eliminates the danger of excess pressure
making the methane in the canister flow
out as quickly as possible in a controlled
manner.
2) Mechanical excess pressure device
(Burt Disk),in the case of excess pres-
sure (above 330 bar), it ensures that the
methane escapes as quickly as possible in
a controlled manner.It separates the canister from the methane
system to allow maintenance operations.
The taps are accessible from outside the
car and are located, in the case of the
lengthwise centre canister, at the rear of
the canister and, in the case of the trans-
verse rear canister, towards the right
wheel side.
To close the taps D-Fig. 7: turn the knob
in the direction (1) shown by the arrow
(clockwise
OFF)
To open the taps D-Fig. 7: turn the knob
in the direction (2) shown by the arrow
(anti-clockwise
ON)
5) Single-acting valve,this prevents the
methane from flowing back to the filler.
fig. 5F0M0454m
fig. 6F0M0455m
fig. 7
D
1
2
F0M0456m
603_97_333 Punto FL Nat P GB 1ed 6-08-2009 10:50 Pagina 7
20
FIAT PUNTO NATURAL POWER
CAPACITIES
Petrol
Petrol . . . . . . . . . . . . . . . . . litres 45
- including a reserve of . . . . litres 5-7
Methane
– Methane (*). . . . . . . . . kg (approx) 13
(*) The amount of methane depends on
the outside temperature, the supply pres-
sure, the quality of the gas and the type
of refuelling system. The total volume of
the canisters is about 84 litres.
IMPORTANT It should be remembered
that when using a fuel such as methane the
range is very variable because as well as
the driving conditions and car maintenance
it also depends on the temperature of the
gas in the canister.
The methane actually heats up during the
refuelling and cools down whilst driving,
undergoing variations in pressure that re-
duce the quantity that can be used.
It should also be pointed out that whilst
the vehicle is being run in (up to around
3000 km) the fuel consumption may be
higher than the figures given.
ENGINE OIL
The engine oil used is SELENIA K P.E.
(Contractual Technical Reference
N° F603.C07): SAE 5W-40 ACEA C3
grade synthetic base lubricant, FIAT
9.55535-S2 certification.
CO2EMISSIONS
The CO2emission figures in the table be-
low refer to combined fuel consumption.
CO
2emissions according to Euro-
pean Directive in force (g/km)
Methane . . . . . . . . . . . . . . . . . . . . . 115
Petrol . . . . . . . . . . . . . . . . . . . . . . . 149
603_97_333 Punto FL Nat P GB 1ed 6-08-2009 10:51 Pagina 20
