2009 FIAT PANDA spare wheel

4
FIAT PANDA ADVENTURE
OUTFIT
This version is available in the following
versions:
2-seater version
❒No rear seat;
❒fixed tubular wall separating the load
area from the passenger compartment;
❒load platform extended to the dividing
wall;
❒rear side windows (load compartment)
fixed and darkened and darkened rear
window;
❒spare wheel same size as wheels sup-
plied (space-saver spare wheel for ver-
sions/markets, where provided);
❒4 load-holding hooks.
4-seater version
❒Rear seat for only two seats with three
point seatbelts and reel;
❒fixed tubular wall separating the luggage
area from the passenger compartment
(for versions/markets, where provid-
ed);
❒spare wheel same size as wheels sup-
plied.
SEAT BELTS
In the four-seater versions, the rear seats
include two three-point seatbelts with
reel, as shown in fig. 2.
fig. 1F0G0244mfig. 2F0G0245m
LUGGAGE SHELF
(for versions/markets,
where provided)
To make use of the luggage compartment
easier, the shelf can be removed. To re-
move, release the two pins A-fig. 1(one
each side) from their respective positions,
pulling the shelf towards the outside.
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 4

5
FIAT PANDA ADVENTURE
ABS SYSTEM
The ABS system with this version is sup-
plied as standard, and consists of:
❒EBD (Electronic Braking force Distrib-
ution), which distributes the braking ac-
tion between front and rear wheels;
❒MSR (Motor Schleppmomenten
Regelung - Regulation of engine braking
torque), which intervenes in the event
of a sudden change of gear whilst down-
shifting (preventing the wheels from
locking during deceleration when the
accelerator is released), restoring
torque to the engine, thereby avoiding
excessive drag of the driving wheels
which can lead to a loss of vehicle sta-
bility and control, particularly in poor
grip conditions.
REPLACING A WHEEL
General instructions
The vehicle is originally supplied with a
spare wheel of the same size as those fit-
ted (space-saver spare wheel for ver-
sions/markets, where provided).
Wheel changing and correct use of the jack
and spare wheel (space-saver spare wheel
for versions/markets, where provided) call
for some precautions reported in the Use
and Maintenance manual to which this sup-
plement is attached.To change a wheel proceed as follows:
❒stop the car in a position so that it is
not a danger for on-coming traffic and
where you can replace the wheel safe-
ly. The ground must be flat and com-
pact;
❒Turn the engine off and pull up the
handbrake.
❒Engage first gear or reverse;
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 5

6
FIAT PANDA ADVENTURE
❒take the tool bag fig. 3positioned un-
der the driver’s seat (4-seater version)
or between the dividing wall and pas-
senger seat fig. 4(2-seater version, ac-
cessible from the right rear door) and
take it next to the wheel to be changed;
❒loosen the fastening device B-fig. 5;
❒take the spare wheel (space-saver
spare wheel for versions/markets,
where provided) A;
❒turn the jack crank to open it partial-
ly;
❒position the jack close to the wheel to
be changed, at the sign Oreported on
the longeron fig. 6;
❒ensure that the groove Fof the jack is
well fitted onto the tab Gof the
longeron;
fig. 3F0G0607m
fig. 4F0G0278m
fig. 5F0G0608m
❒warn anybody nearby that the car is
about to be lifted. They must stay clear
and not touch the car until it is back
on the ground;
❒fit the handle H-fig. 6 into the jack de-
vice Iand lift the car until the wheel to
be changed is several centimetres off
the ground; Turn the crank, take care
that rotation takes place freely, with no
risk of grazing hands due to friction
with the ground. The moving parts of
the jack (screws and joints) can also
cause injury: do not touch them. If you
come into contact with lubricating
grease, clean yourself thoroughly;
❒remove the hub cab, fully unscrew the
bolts L-fig. 7 and remove the wheel;
fig. 7F0G0233m
fig. 6F0G0610m
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 6

7
FIAT PANDA ADVENTURE
❒turn the jack handle to lower the car
and remove the jack;
❒fully tighten the bolts, passing alterna-
tively from a bolt to the opposite one,
following the order shown in fig. 9.
When you have finished
❒replace the partially open jack and
equipment used in the tool bag;
❒re-organise the tool bag, complete
with tools, replacing it in its original
position.
WARNING The spare wheel must be
placed in the boot, under the carpet, as
shown in fig. 10.
WARNING Do not use inner tubes with
Tubeless tyres. Check pressure of tyres
and spare wheel on a regular basis.
fig. 10F0G0615m
❒ensure that the spare wheel (space-
saver spare wheel for versions/
markets, where provided) support
surfaces are clean and free of impu-
rities that could later cause the bolts
to loosen;
❒mount the spare wheel (space-saver
spare wheel for versions/markets,
where provided), ensuring that the
pins N-fig. 8are aligned with one of
the holes Oon the wheel;
❒screw the 4 fixing bolts;
fig. 8F0G0204m
fig. 9F0G0206m
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 7

Version Rims Tyres Spare wheel
Rim Tyre
(*) Space-saver spare wheel for versions/markets, where provided
13
FIAT PANDA ADVENTURE
Please do not drive for long dis-
tances with the wheels not at
the prescribed pressure (wheels
partially or totally flat), as this
may damage the viscous joint.
RIMS AND TYRES
The tyres on this version have been designed to yield the best possible balance between road performance and performance on non-
asphalted and/or snow and icy ground. These tyres are marked by a high capacity to run on off-road conditions and good driving
both on snowy/icy ground and on wet/dry ground.
5,5J X 14
165/70 R14 81T M+S5,5J X 14
4.00B X 14 (*)165/70 R14 81T M+S
135/80 R14 84P (*) Fiat Panda
Adventure
Versions Medium load Full load
Front rear front rear
1.22,3 2,3 2,3 2,5
1.3 Multijet2,3 2,3 2,3 2,5
INFLATION PRESSURE (bar)
2-SEATER
Versions Medium load Full load
Front rear front rear
1.22,2 2,0 2,3 2,3
1.3 Multijet2,3 2,1 2,3 2,3
4-SEATER
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 13

17
FIAT PANDA ADVENTURE
4 posti2-seater
petrol Multijet versions
980 1075
445 445
750 825
745 745
1425 1520
800 900
400 400
60 60
50 50petrol Multijet versions
990 1085
445 445
750 825
745 745
1435 1530
800 900
400 400
60 60
50 50
WEIGHTS
Weights (kg)
Kerb weight (with supplies, spare wheel, tools and accessories):
Payload (*) including the driver:
Maximum permitted loads (**)
– front axle:
– rear axle:
– total:
Towable loads
- braked trailer:
- non braked trailer:
Maximum load on tow hitch(trailer with brakes):
Maximum load on roof (***):
(*) If special equipment is fitted (sun roof, trailer towing equipment, etc.) the unladen weight will increase and consequently the
payload will decrease in relation to the maximum permitted loads.
(**) Loads not be exceeded. The user is responsible for arranging goods in the luggage compartment and/on load carrying plat-
form
within the maximum permitted loads.
(***) Lineaccessori Fiat range roof racks, maximum capacity: 50 kg.
603_97_569 PANDA ADV Euro5 GB 9-12-2009 8:06 Pagina 17