4
FIAT PANDA 4 x 4
❒signalling with light on constantly: this
indicates that there is a problem with
the 4 x 4 drive; go to a Fiat Dealership
as soon as possible (where provided,
the display will show a dedicated mes-
sage). In addition, on versions with ESP,
if the ELD is on, the LED in the button
will go out.HEADLIGHT WASHER
(for versions/markets, where provided)
The headlight washing system consists of
two nozzles for washing the external
headlight lens. This function can be acti-
vated using the windscreen washer stalk
only if dipped beams or main beams are
on. Operating the stalk to wash the wind-
screen will automatically start the head-
light washer.
This version features a windscreen wash-
er fluid reservoir with improved capaci-
ty, i.e.: 4.5 litres.
IF A TYRE
IS PUNCTURED
General instructions
The vehicle may come (for versions/mar-
kets where provided) with either a space-
saver wheel or Fix & Go quick tyre repair
kit.
Wheel changing and correct use of the jack
and space-saver spare wheel call for some
precautions as listed in the Owner Hand-
book this Supplement is attached to. In the
Owner Handbook you will also find how
to use the Fix & Go kit (quick tyre repair
kit).
To change a wheel proceed as follows:
❒stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequately
firm;
❒turn the engine off and pull up the hand-
brake;
❒engage first gear or reverse;
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 4
7
FIAT PANDA 4 x 4
IF AN EXTERIOR LIGHT
BURNS OUT
(Fiat Panda 4 x 4 CROSS
version)
IMPORTANT To change an external light
on Fiat Panda 4 x 4 and Fiat Panda 4 x 4
Climbing versions, refer to the Owner
Handbook this Supplement is attached to.
For the type of bulb and power rating re-
fer to paragraph “When needing to change
a bulb” in section “In an emergency” in the
attached Owner Handbook.
FRONT LIGHT UNITS
To change the dipped beam bulb, proceed
as follows:
❒remove the cover A-fig. 12;
❒disconnect the connector C-fig. 13;
❒release the bulb holder catch A;
❒remove the bulb Band fit the new bulb.To change the front sidelight bulb, pro-
ceed as follows:
❒remove the cover A-fig. 12;
❒remove the bulb holder A-fig. 14;
❒remove the bulb B;
❒fit the new bulb.To change the front fog light bulb, proceed
as follows:
❒remove the cover A-fig. 12;
❒disconnect the connector D-fig. 15;
❒turn slightly the bulb holder B and re-
move it;
❒remove the bulb C and fit the new bulb.
To change the main beam bulb, proceed
as follows:
fig. 12F0G0617m
fig. 13F0G0618m
fig. 14F0G0619m
fig. 15F0G0628m
603_97_560 PANDA 4X4 Euro 5 GB 11-12-2009 9:31 Pagina 7
