2009 DODGE VIPER key

[x] Cancel search: key

Page 32 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual Auto Down Feature
Both windows have an Auto Down feature. Press the
WINDOW switch to the second detent, release, and the
window will go down automatically. Press the switch a
second time in either dir

Page 33 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual NOTE:The liftgate release switch will be ignored under
the following conditions:
•When the ignition is in RUN and the parking brake is
not set.
•When vehicle speed is not 0 mph (0 km/h).
•When a

Page 34 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual TRUNK LOCK AND RELEASE — CONVERTIBLE
MODELS ONLY
You can unlatch the trunk lid by pressing the TRUNK
button on the Remote Keyless Entry (RKE) transmitter
for at least one second. The park lights and

Page 48 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual �Interconnecting Wiring
�Seat Track Position Sensors
How the Airbag System Works
•
TheOccupant Restraint Controller (ORC)determines
if a frontal collision is severe enough to require the
airbags to

Page 88 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual High Beam/Low Beam Select Switch
Pull the multifunction lever toward you to switch the
headlights to high beam. Pull the lever a second time to
switch the headlights back to low beam.
Flash-to-Pass
Yo

Page 89 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual •A door is unlocked using the outside driver’s door key
cylinder.
The interior lights will turn on and remain on for about
four seconds and then fade to off if a door is opened
using the inside do

Page 104 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual This light also illuminates at vehicle start-up to indicate
that the ABS self-check is in process. If the light remains
on after start-up, or turns on and remains on at road
speeds, it may indicate a

Page 107 of 299

DODGE VIPER 2009 ZB II / 2.G Owners Manual •If the light turns on steady while the engine is running,
safely bring the vehicle to a complete stop as soon as
possible, cycle the ignition key, and then restart the
engine. The light should turn