Page 404 of 459
Cavity Cartridge
FuseMini-
FuseDescription
M35 10 Amp
RedHeated Mirrors
M36 20 Amp
YellowPower Outlet #3
(BATT)
M37 10 Amp
RedAnti-Lock Brake Sys-
tem (ABS), Electronic
Stability Program
(ESP), Stop Lamp
Switch (STP LP SW),
Fuel Pump Rly Hi
Control
M38 25 Amp
NaturalLock/Unlock Motors
(LOCK/UNLOCK
MTRS)
CAUTION!
•When installing the integrated power module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the integrated power
module, and possibly result in a electrical system
failure.
•When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
402 MAINTAINING YOUR VEHICLE
Page 445 of 459

Flashers
Hazard Warning....................... 354
Turn Signal..................176,404,405,406
Flooded Engine Starting................... 260
Floor Console.......................... 159
Fluid, Brake........................... 410
Fluid Capacities......................... 408
Fluid Leaks............................. 77
Fluid Level Checks...................... 391
Automatic Transmission................. 389
Engine Oil........................... 373
Power Steering........................ 283
Fluids, Lubricants and Genuine Parts.......... 409
Fog Light Service........................ 405
Fog Lights..........................131,405
Folding Rear Seat........................ 125
Four Wheel Drive....................... 275
Operation........................... 275
Systems............................. 275Four Wheel Drive Operation................ 275
Four-Way Hazard Flasher.................. 354
Front Axle (Differential)................... 391
Fuel................................. 326
Filler Cap (Gas Cap).................... 331
Gasoline............................ 326
Gauge.............................. 174
Light............................... 175
Materials Added....................... 329
Octane Rating...................326,327,409
Requirements......................... 408
Tank Capacity........................ 408
Fuel System Caution..................... 330
Fuses................................ 396
Garage Door Opener (HomeLink) ........... 144
Gas Cap (Fuel Filler Cap)............331,333,370
Gas Gauge (Fuel Gauge)................... 174
Gasoline (Fuel)......................... 326
INDEX 443
10
Page 447 of 459

Infant Restraint........................65,66
Inflation Pressure Tires.................... 306
Information Center, Vehicle................. 191
Inside Rearview Mirror.................... 83
Instrument Cluster....................173,174
Instrument Panel and Controls.............. 172
Instrument Panel Lens Cleaning............. 396
Integrated Power Module (Fuses)............ 396
Interior Appearance Care.................. 395
Interior Lights.......................... 132
Intermittent Wipers (Delay Wipers)........... 133
Introduction............................. 4
Inverter, Power......................... 156
Jack Location........................... 356
Jack Operation.......................356,358
Jacking Instructions...................... 358
Key, Programming........................ 16Key, Replacement........................ 15
Key, Sentry (Immobilizer)................... 14
Key-In Reminder......................... 13
Keyless Entry System...................... 19
Keys................................. 12
Lap/Shoulder Belts....................... 38
LATCH (Lower Anchors and Tether
for CHildren).........................69,71
Lead Free Gasoline...................... 326
Leaks, Fluid............................ 77
Life of Tires............................ 311
Liftgate................................ 36
Lights..............................77,129
Airbag............................63,181
Alarm............................77,176
Anti-Lock........................... 180
Back-Up............................ 406
Brake Assist Warning................... 295
INDEX 445
10
Page 457 of 459

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
Page 458 of 459

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped. The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.