2009 DODGE DURANGO key

[x] Cancel search: key

Page 148 of 498

DODGE DURANGO 2009 2.G Owners Manual Interior Lights
The brightness of the instrument panel lighting can be
regulated by rotating the dimmer control up (brighter) or
down (dimmer). When the headlights are on you can
supplement the bright

Page 166 of 498

DODGE DURANGO 2009 2.G Owners Manual CAUTION! (Continued)
•To avoid vehicle damage, the vehicle must be
driven slowly when using the Rear Camera system
to be able to stop in time when an obstacle is seen.
It is recommended that the dri

Page 167 of 498

DODGE DURANGO 2009 2.G Owners Manual 4. When the vehicle is shifted into REVERSE, an image of
the rear of the vehicle will appear with a caution note to
check entire surroundingsdisplayed across the top of
the screen. After five second

Page 173 of 498

DODGE DURANGO 2009 2.G Owners Manual •“AUTO DOOR LOCK > ON” – When ON is selected,
all doors will lock automatically when the vehicle
reaches a speed of 15 mph (24 km/h). To make your
selection, press and release the RESET button

Page 174 of 498

DODGE DURANGO 2009 2.G Owners Manual •“FLASH LAMPS W/LOCK >ON” – When ON is
selected, the front and rear turn signals will flash when
the doors are locked or unlocked with the RKE Trans-
mitter. This feature may be selected with

Page 185 of 498

DODGE DURANGO 2009 2.G Owners Manual movement and the sunroof will remain in a partial open
condition until the switch is pushed forward again. To
close fully, hold the switch in the forward position until
the glass movement has stopped.

Page 207 of 498

DODGE DURANGO 2009 2.G Owners Manual 8. Speedometer
The speedometer shows the speed of the vehicle.
9. Charging System Light
This light shows the status of the electrical charg-
ing system. The light should come on when the
ignition swit

Page 210 of 498

DODGE DURANGO 2009 2.G Owners Manual cluster. To reset the oil change indicator system (after
performing the scheduled maintenance) refer to the fol-
lowing procedure.
1. Turn the ignition switch to the ON position(Do not
start the engin