2009 DODGE CALIBER lights

Voice Recognition System (VR) —
If Equipped .......................... 112
▫ Voice Recognition System (VR) Operation . . . 112
▫ Commands ........................ 114
▫ VoiceTraining ...................... 117
 Seats .............................. 117
▫ Front Seat Adjustment ................. 117
▫ Manual Seat Height Adjustment — If
Equipped .......................... 118
▫ Manual Lumbar — If Equipped .......... 119
▫ Driver’s Seatback Recline ............... 119
▫ Adjustable Head Restraints ............. 120
▫ Heated Seats — If Equipped ............ 120
▫ Fold-Flat Front Passenger Seat ........... 122▫
Folding Rear Seat .................... 123
▫ Reclining Rear Seat — If Equipped ........ 124
 To Open And Close The Hood ............ 124
 Lights ............................. 126
▫ Multifunction Lever .................. 126
▫ Headlights, Parking Lights And Instrument
Panel Lights ........................ 126
▫ Lights-On Reminder .................. 127
▫ Fog Lights — If Equipped .............. 128
▫ Turn Signals ........................ 128
▫ High Beam/Low Beam Select Switch ...... 129
▫ Flash-To-Pass ....................... 130
▫ Map/Reading Lights .................. 130
76 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

▫Daytime Running Lights (DRL) — If
Equipped .......................... 131
 Windshield Wipers And Washers .......... 131
▫ Windshield Wiper Operation ............ 131
▫ Intermittent Wiper System .............. 132
▫ Windshield Washers .................. 132
▫ Mist Feature ........................ 133
 Tilt Steering Column ................... 134
 Electronic Speed Control — If Equipped ..... 134
▫ To Activate ......................... 135
▫ To Set At A Desired Speed .............. 136
▫ To Deactivate ....................... 136
▫ To Resume Speed .................... 136 ▫
To Vary The Speed Setting .............. 136
▫ Manual Transaxle .................... 137
▫ To Accelerate For Passing .............. 137
 Garage Door Opener — If Equipped ........ 138
▫ Programming HomeLink .............. 139
▫ Gate Operator/Canadian Programming .... 142
▫ Using HomeLink ................... 142
▫ Reprogramming A Single HomeLink
Button ............................ 143
▫ Security ........................... 143
▫ Troubleshooting Tips .................. 143
▫ General Information .................. 144
 Power Sunroof — If Equipped ............ 144
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 77
3

After turning the ignition ON, you can choose from High,
Low, or Off heat settings. Amber indicator lights in each
switch indicate the level of heat in use. Two indicator
lights will illuminate for High, one for Low, and none for
Off.Press the switch once to select High-level heat-
ing. Press the switch a second time to select
Low-level heating. Press the switch a third time
to shut the heating elements Off.
If High-level heating is selected, the system automatically
switches to Low-level heating and turns one indicator
light off after 30 minutes of continuous operation. It will
turn the heater and the remaining indicator light off after
an additional 30 minutes of continuous operation. If
Low-level heating is selected, the system automatically
turns the heater and the indicator light off after 30 min-
utes of continuous operation. NOTE:
Once a heat setting is selected, heat will be felt
within two to five minutes.
WARNING!
•Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabetes,
spinal cord injury, medication, alcohol use, ex-
haustion or other physical condition must exercise
care when using the seat heater. It may cause burns
even at low temperatures, especially if used for
long periods of time.
•Do not place anything on the seat that insulates
against heat, such as a blanket or cushion. This
may cause the seat heater to overheat.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121
3

CAUTION!
To prevent possible damage, do not slam the hood to
close it. Lower the hood until it is open approxi-
mately 8 in (20 cm) and then drop it. This should
secure both latches. Never drive your vehicle unless
the hood is fully closed, with both latches engaged.
WARNING!
If the hood is not fully latched it could fly up when
the vehicle is moving and block your forward vision.
You could have a collision. Be sure all hood latches
are fully latched before driving.
LIGHTS
Multifunction Lever
The multifunction lever controls the operation of the
headlights, parking lights, turn signals, headlight beam
selection, instrument panel light dimming, interior lights,
the passing lights, and fog lights. The multifunction lever
is located on the left side of the steering column.
Headlights, Parking Lights and Instrument Panel
Lights
Turn the end of the multifunction lever to the first detent
for parking light operation. Turn the multifunction lever
to the second detent for headlight operation.
126 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To change the brightness of the instrument panel lights,
rotate the center portion of the multifunction lever up or
down.Lights-on Reminder
If the headlights or parking lights are on after the ignition
is turned OFF, a chime will sound to alert the driver
when the driver’s door is opened.
Headlight ControlDimmer Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127
3

Fog Lights — If Equipped
The front fog light switch is on the multifunction
lever. To activate the front fog lights, turn on the
parking lights or the low beam headlights and pull
out the end of the multifunction lever. NOTE:
The fog lights will only operate with the head-
lights on low beam. Selecting high beam headlights will
turn off the fog lights.
Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.
You can signal a lane change by moving the multifunc-
tion lever partially up or down without moving beyond
the detent.
Fog Light Control
128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

If either light remains on and does not flash, or there is a
very fast flash rate, check for a defective outside light
bulb. If an indicator fails to light when the multifunction
lever is moved, it would suggest that the fuse or indicator
bulb is defective.
High Beam/Low Beam Select Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you to switch the headlights back to low beam.
Turn Signal Control
High Beam Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 129
3

Flash-to-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the headlights to turn on at high beam and
remain on until the multifunction lever is released.
NOTE:If the multifunction lever is held in the flash-to-
pass position for more than 30 seconds, the high beams
will shut off. If this occurs, wait 30 seconds for the next
flash-to-pass operation.
Map/Reading Lights
These lights are mounted between the sun visors above
the rearview mirror. Each light is turned on by pressing
the button. Press the button a second time to turn the
light off. The lights also come on when a door is opened
or the dimmer control is turned fully upward, past the
second detent. NOTE:
The lights will remain on until the switch is
pressed a second time, so be sure they have been turned
off before leaving the vehicle. The lights will turn off
automatically 10 minutes after the ignition is turned OFF
if the door is left open or light is switched on.
Map/Reading Lights
130 UNDERSTANDING THE FEATURES OF YOUR VEHICLE