2009 Citroen C6 DAG wheel

26
II
S T E E R I N G L O C K – I G N I T I O N – S T A R T E R
S: STEERING LOCK
To unlock the steering, gently move the steering wheel while turning the key, without exerting undue force.
When you remove the key, turn your steering wheel to lock the steering. The key can only be removed when in position S.
M: DRIVE POSITION
The steering is unlocked (by turning the key in position M, if necessary move the steering wheel).
STARTING AND STOPPING THE ENGINE
See "Driving".
ECONOMY MODE
In order not to discharge the bat-tery while the engine is stopped, your vehicle goes automatically into economy mode after a maxi-mum of 30 minutes. Economy mode is indicated by a message on the screen.
The electrical components relating to comfort and also the headlamps (not sidelamps or hazard warning lamps) cut out automatically. To reactivate them, it is necessary to start the engine.
Depending on your vehicle ver-sion, the following warning lamps are tested:
If one of these warning lamps does not light up, this indicates a mal-function.
D: STARTING
Release the key as soon as the engine starts. Never turn it while the engine is running.
NEVER REMOVE THE IGNITION KEY BEFORE THE ENGINE HAS COME TO A COMPLETE STOP.
IT IS ESSENTIAL ALWAYS TO DRIVE WITH THE ENGINE RUNNING, SO AS TO RETAIN STEERING AND BRAKING ASSISTANCE (risk of the steering lock engaging and loss of safety features).
Do not hang a heavy object on the key; it could pull the key out of alignment in the switch and could cause a malfun ction.
When stationary, having removed the key, carefully turn the steering wheel if you wish to lock the steering.

46
II
T R I P C O M P U T E R
Tyre defl ation alert
The SERVICE warning lamp comes on and a vehicle outline is displayed.
The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel( s) will be fl ashing. Check the tyre pressures as soon as possible.
Colour screen CNaviDrive colour display
Tyre very defl ated
Tyre defl ated
Stop immediately, avoiding any sudden actions with the steeri ng wheel or the brakes.
Change the wheel with the affected tyre (whether punctured or very defl ated), then have the tyre repaired and all the pressures checked at the earliest opportunity.
The wheel with a damaged tyre (either in the boot or under repair) can no longer be detected (information given by the vehicle outline or by a message) nor is the spare wheel able to be detected.
Puncture
The "STOP" and tyre(s) punctured warning lamps light up, and a vehicle ou tline is displayed. The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be fl ashing.
Colour screen CNaviDrive colour display

47
II
T R I P C O M P U T E R
Wheel not detected
The SERVICE warning lamp comes on and a vehicle outline is displayed.
The wheel(s) concerned can be identifi ed from the vehicle outline, on which it (they) will be missing. If you have not changed a wheel, such information indicates that the system is malfunctioning.
Contact a CITROËN dealer to have the faulty sensor(s) replaced.
Colour screen CNaviDrive colour display
The defl ation detection system is a driving aid, but which does not absolve the driver from the need to be vigilant and responsible.
This system does not remove the need to check the tyres on a regula r basis (see "Vehicle identifi cation"), to make sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.
Do not forget to check the pressure in the spare wheel.
Any repair or replacement of a tyre on a wheel that is equipped with a sensor must be carried out by a CITROËN dealer.Any repair or replacement repair or
The system may suffer from temporary interference caused by radio transmissions on neighbouring frequencies.

46
II
T R I P C O M P U T E R
Tyre defl ation alert
The SERVICE warning lamp comes on and a vehicle outline is displayed.
The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel( s) will be fl ashing. Check the tyre pressures as soon as possible.
Colour screen CNaviDrive colour display
Tyre very defl ated
Tyre defl ated
Stop immediately, avoiding any sudden actions with the steeri ng wheel or the brakes.
Change the wheel with the affected tyre (whether punctured or very defl ated), then have the tyre repaired and all the pressures checked at the earliest opportunity.
The wheel with a damaged tyre (either in the boot or under repair) can no longer be detected (information given by the vehicle outline or by a message) nor is the spare wheel able to be detected.
Puncture
The "STOP" and tyre(s) punctured warning lamps light up, and a vehicle ou tline is displayed. The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be fl ashing.
Colour screen CNaviDrive colour display

47
II
T R I P C O M P U T E R
Wheel not detected
The SERVICE warning lamp comes on and a vehicle outline is displayed.
The wheel(s) concerned can be identifi ed from the vehicle outline, on which it (they) will be missing. If you have not changed a wheel, such information indicates that the system is malfunctioning.
Contact a CITROËN dealer to have the faulty sensor(s) replaced.
Colour screen CNaviDrive colour display
The defl ation detection system is a driving aid, but which does not absolve the driver from the need to be vigilant and responsible.
This system does not remove the need to check the tyres on a regula r basis (see "Vehicle identifi cation"), to make sure that the vehicle is behaving correctly and to avoid premature tyre wear arising from driving too fast etc.
Do not forget to check the pressure in the spare wheel.
Any repair or replacement of a tyre on a wheel that is equipped with a sensor must be carried out by a CITROËN dealer.Any repair or replacement repair or
The system may suffer from temporary interference caused by radio transmissions on neighbouring frequencies.

55
II
S T E E R I N G C O L U M N A D J U S T M E N T –
S E A T B E L T H E I G H T A D J U S T M E N T
MANUAL ADJUSTMENT OF THE STEERING WHEEL FOR HEIGHT AND REACH
While the vehicle is stationary, unlock the steering wheel by push-ing the lever forward.
Adjust the height and the reach of the steering wheel, then lock the position by pulling the lever upwards.
ELECTRICAL ADJUSTMENT OF THE STEERING WHEEL FOR HEIGHT OR REACH
While the vehicle is stationary, adjust the height or the reach of the steering wheel by moving the control:forward or rearward to adjust the reachup or down to adjust the height.
The steering wheel adjustment is memorised with the driving posi-tion (See "Memorisation").

58
II
21
M
M E M O R I S A T I O N
DRIVING POSITIONS MEMORISED VIA BUTTONS 1 AND 2
To memorise a driving position:a. Place the igntion key in "Drive" position (second position).b. Make your adjustments of the seat, the steering wheel, the rear view mirrors and the Head-up Display.c. Press successively on button M then on button 1(fi rst driving position) or 2(second driving position).
The memorisation is confi rmed by a sound signal.Note: The memorisation of a new driving position cancels and replaces the previous one.
The memorisation function allows to make the following dashboard adjustments:Driver's seat
Steering wheel
Exterior rear view mirrorsHead-up display.
See "Steering column adjustment", "Rear view mirrors" and "Head-up Display".
You have the possibility to memo-rise two driving positions using buttons 1 and 2.

84
III
A U T O M A T I C A I R C O N D I T I O N I N G
AIR CONDITIONING
This system automatically adjusts the temperature, the fl ow of air and the distribution of air inside the cabin, depending on your desired comfort level.
Provided you retain automatic mode (by pressing button "AUTO") and all the air vents are open, you will main-tain an optimum comfort level, also removing humidity and misting, whatever the ambient climatic conditions.
The temperature inside the cabin cannot be lower than the temperature outside if the air conditioning is not operating.
To be effective, the air conditioning should only be used with the windows closed. If after a lengthy stop in bright sunlight the interior temperature is excessive, air the passenger compartment by opening the windows for a few moments, then close them again.
To keep the air conditioning compressor well sealed, it is essential to operate the air conditioning at least once every month.
The air conditioning operates by using power from the engine. This results in a slight increase in fuel con-sumption.
Sensors
The automatic regulation of the air conditioning inside the cabin makes use of a number of sensors, relieving you of the need to make adjustments, other than the desired cabin temperature.
Take care not to obstruct sensor A.
Air inlet
Check that the exterior grille for the air inlet, at the bottom of the windscreen, is clean and free of dead leaves, snow, etc.
If washing the vehicle with a high pressure jet, avoid targeting the air inlet zone.
Air circulation
For your comfort we advise you to maintain a proper distribution of air within the cabin, both at the front and at the rear.
The air vents to the face have thumbwheels so that you can adjust the flow of air, and grilles to orient the direction.
There are air vents on the fl oor underneath the front seats and on the rear control panel, for enhanced heat-ing of the rear seat positions.
Do not obstruct the air outlets located in the boot area.
Dust/pollen fi lter
There is a fi lter for excluding pollen and dust.
This filter has to be changed according to the vehi cle maintenance schedule. See "Maintenance and Warranty Guide".