3
COMFORT
Additional adjustments
Head restraint height adjustment
To raise the head restraint, pull it for-
wards and upwards at the same time.
To remove the head restraint, press the
lug A and pull the head restraint upwards.
To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back.
To lower the head restraint, press
the lug A and the head restraint at
the same time. Heated seats control
With the engine running, the front seats
can be heated separately.
Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:
0
: Off.
1
: Low.
2
: Medium.
3
: High.
T h e h e a d r e s t r a i n t i s fi t t e d w i t h
a frame with notches which pre-
vents it from lowering; this is a
safety device in case of impact.
The adjustment is correct
when the upper edge of the
head restraint is level with the
top of the head.
Never drive with the head re-
straints removed; they must be
in place and adjusted correctly.
11
PRACTICAL INFORMATION
AUDIO PRE-EQUIPMENT
Your vehicle is equipped with certain
f a c t o r y - fi t t e d a u d i o e q u i p m e n t :
- a dual-function aerial at the rear of the roof,
- a coaxial aerial cable,
- basic interference suppression,
- cabling for speakers in the front doors and tweeters in the dash-
board,
- cabling for speakers in the rear doors,
- two 8-way connectors. Fitting an audio unit
T h e a u d i o u n i t i s fi t t e d i n p l a c e o f o n e
of the storage boxes located below the
heating and air conditioning control
panel.
Fitting speakers
I t i s p o s s i b l e t o fi t :
- 165 mm diameter speakers in the
front doors,
- 130 mm diameter speakers in the rear doors,
- 22.5 mm diameter tweeters in the top of the dashboard. Connectors
8-way connector
(A)
A 1 : -
A 2 : -
A 3 : -
A 4 : -
A 5 : -
A 6 : ( + v e ) I g n i t i o n p o s i t i v e ( i n t h i s c a s e ,
the audio equipment only op-
e r a t e s w h e n t h e i g n i t i o n i s o n )
A 7 : ( + v e ) P e r m a n e n t
A 8 : E a r t h
Never use a separate wire to
c o n n e c t t h e ( + ) o f y o u r a u d i o
equipment (risk of discharging of
t h e b a t t e r y ) .
8-way connector (B)
B 1 : ( + ) R e a r r i g h t s p e a k e r
B 2 : ( - ) R e a r r i g h t s p e a k e r
B 3 : ( + ) F r o n t r i g h t s p e a k e r a n d t w e e t e r
B 4 : ( - ) F r o n t r i g h t s p e a k e r a n d t w e e t e r
B 5 : ( + ) F r o n t l e f t s p e a k e r a n d t w e e t e r
B 6 : ( - ) F r o n t l e f t s p e a k e r a n d t w e e t e r
B 7 : ( + ) R e a r l e f t s p e a k e r
B 8 : ( - ) R e a r l e f t s p e a k e r Before installing a radio unit or
speakers in your vehicle, contact
a CITROËN dealer to obtain a
suitable wiring harness.
Unclip the storage box on each side
using a screwdriver and pull out.
You will then have access to an aerial co-
axial cable and two 8-way connectors.
Then refer to the instructions provided
with your audio unit.
