2009 CITROEN C CROSSER DAG brake light
[x] Cancel search: brake lightPage 6 of 216
9
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1. Audio equipment controls.
2. Telephone controls.
3. Steering wheel adjustment control.
4. Lights and direction indicators
controls.
Headlamp wash control.
5. Instrument panel.
6. Driver’s air bag.
Horn.
7. Cruise control switches.
8. Gear lever.
9. Handbrake.
10. Bonnet release.
11. Enclosed storage compartment.
F u s e b o x .
12. Headlamp height adjustment.
Deactivation of the ASC system.
Deactivation of the audible parking
assistance.
13. Cup holder.
14. Side adjustable and closing vent.
15. Information button.
16. Window de-icing and demisting
vent.
17. Windscreen de-icing vent.
Page 18 of 216
I N S T R U M E N T S a n d C O N T R O L S
I
21
Indicator lights is on Cause Observations
Diesel
pre-heating F i x e d
This comes on when the
ignition switch is at ON. Wait until this light has switched off before
starting.
The duration for which this is displayed is
d e t e r m i n e d b y t h e e x t e r i o r c l i m a t i c c o n d i t i o n s .
Warning lights is on Cause Observations
Handbrake /
B r a k e fl u i d level F i x e d This comes on for a
few seconds when the
ignition is turned to “ON”
then switches off.
It is accompanied by a message on the
instrument panel display.
The handbrake is
applied or has not been
released fully. It is accompanied by a message on the
instrument panel display. Release the handbrake
to switch off the warning light.
T h e b r a k e fl u i d l e v e l i s
too low. It is accompanied by a message on the
i n s t r u m e n t p a n e l d i s p l a y . T o p u p w i t h b r a k e fl u i d
and contact a CITROËN dealer.
Emission
control system F i x e d o r
fl a s h i n g This comes on or
fl a s h e s i f t h e s y s t e m
fails. Consult a CITROËN dealer.
It should switch off a few seconds after starting
the engine.
Battery charge
F i x e d This comes on if a
charging circuit fault
occurs. It should switch off when the engine is started.
It is accompanied by a message on the
instrument panel display. Check the battery
terminals (refer to the “Battery” section).
Page 21 of 216
I N S T R U M E N T S a n d C O N T R O L S
I
24
Warning messages (ignition at “ON”)
Message is on
Associated
warning light
Cause Solution - action Observations
ABS
F i x e d
Anti-lock braking
system (ABS)
fault. Consult a CITROËN
dealer. The vehicle retains
conventional braking
without assistance
but you are advised
to stop.
Braking
system F i x e d
and The level of
b r a k e fl u i d i n t h e
reservoir is too
low.
Stop and top up,
otherwise contact a
CITROËN dealer. If the message
remains on after
topping up, contact a
CITROËN dealer.
Braking system
fault. Consult a CITROËN
dealer.
It is essential
to stop.
Handbrake on
F i x e d
You have moved
off with the
handbrake still
applied.
Release the handbrake.
Coolant
temperature Flashing -
High engine
temperature. If the message
fl a s h e s ,
wait for the engine to
cool before topping up
the level, if necessary.
It is essential to
stop your vehicle in
a safe place.
Flashing If the message
fl a s h e s
and the service
warning light comes
on , contact a CITROËN
dealer without delay.
Seat belt
F i x e d
The driver has
not fastened or
has unfastened
his seat belt.
Fasten your seat belt. An intermittent
audible signal is
heard above 5 mph
(8 km/h).
Page 99 of 216
S A F E T Y
100
BRAKING ASSISTANCE
SYSTEMS
Group of supplementary systems which
help you to obtain optimum braking
in complete safety in emergency
situations:
- the anti-lock braking system (ABS),
- the electronic brake force distribution (EBFD).
When braking in an emergen-
c y , p r e s s v e r y fi r m l y w i t h o u t r e -
leasing the pressure. The two warning lights comes on at
the same time and the two warnings
are displayed alternately on the
instrument panel display.
When replacing wheels (tyres and
rims), ensure that they conform to the
manufacturer’s recommendations.
Operating fault
If this warning light comes on,
accompanied by the indication on the
instrument panel display, it indicates
a malfunction of the anti-lock braking
system which could result in a loss of
control of the vehicle when braking.
Consult a CITROËN dealer.
If these two warning lights come
on, linked with the warnings on the
instrument panel display, they indicate a
malfunction of the electronic brake force
distribution which could result in a loss of
control of the vehicle on braking.
You MUST stop as soon as it is safe
to do so.
Consult a CITROËN dealer.
Anti-lock braking system
and electronic brake force
distribution
Linked systems which improve the sta-
bility and manoeuvrability of your vehi-
cle when braking, in particular on poor
or slippery surfaces. The warning light comes on for a few
seconds when the ignition is switched
on (ON position). If it does not switch
off or does not come on, contact a
CITROËN dealer.
When the vehicle is stationary
When the vehicle is moving
If this warning light comes
on continuously it indicates
a malfunction of the anti-lock
braking system which could
result in a loss of control of the vehicle
on braking.
You MUST stop as soon as it is safe
to do so.
Consult a CITROËN dealer.
Activation
The anti-lock braking system is active if
the vehicle speed is higher than 6 mph
(10 km/h). It is deactivated when the ve-
hicle speed falls below 3 mph (5 km/h).
The anti-lock braking system comes
into operation automatically when there
is a risk of wheel lock.
Normal operation of the ABS may make
itself felt by slight vibration of the brake
pedal.
Page 114 of 216
D R I V I N G
VII
114
Programming
Press button 1 .
Set the programmed speed by ac-
celerating to the required speed,
then press button 2 “COAST
SET” .
CRUISE CONTROL
The controls of this system are grouped
together on the steering wheel.
1.
“ON/OFF” button: activation / deac-
tivation of the cruise control mode.
2.
“COAST SET” button: storing of a
driving speed and decreasing of the
cruising speed.
3.
“ACC RES” button: increasing of
the cruising speed and recalling of
the stored speed.
4.
“CANCEL” button: switching off of
the cruise control. When you press button
1 , “CRUISE”
indicator light comes on on the instru-
ment panel.
Steering wheel controls Display on the instrument pan
el
The cruise control cannot, in any cir-
cumstances, take the place of the
need to comply with speed limits or
of the vigilance and responsibility of
the driver.
System which permits automatic main-
taining of the vehicle speed at the value
programmed by the driver, without any
action on the accelerator pedal.
The
cruise control is switched on
manually: the vehicle speed must be
25 mph (40 km/h) minimum and sec-
ond gear must be engaged in the case
o f a m a n u a l g e a r b o x .
The cruise control is switched off
manually, by an action on the brake or
clutch pedal or if the ASC system is trig-
gered.
T h e p r o g r a m m e d s p e e d c a n b e e x -
ceeded temporarily by pressing the ac-
celerator pedal.
To return to the programmed speed,
simply release the accelerator pedal.
Switching off the ignition cancels any
programmed speed value.
Page 136 of 216
P R A C T I C A L I N F O R M A T I O N
IX
134
Rear lights
1.
Third brake light (diodes).
2.
Brake lights / Side lights
(21/5 - W21W - 5 W).
3.
Direction indicators
(WY21W - 21 W).
4.
Reversing lights (W21W - 21 W).
5.
Number plate lights (W5W - 5W).
6.
Fog lamps (W21W - 21 W). Changing the brake lights / side
lights and direction indicators
These two bulbs are changed from
outside with the tailgate open:
Open the tailgate (refer to the
“Access” section),
R e m o v e t h e t w o l i g h t fi x i n g b o l t s A ,
E x t r a c t t h e l i g h t f r o m o u t s i d e ,
Turn the pin C to the left and remove it.
Pull the bulb D and change it .
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n
reverse order.
Turn the pin B to the left and remove it.
Pull the bulb and change it. W h e n r e fi t t i n g t h e l i g h t , a l i g n t h e
two pins
E with the openings on the
vehicle.
Amber coloured bulbs, such as the
direction indicators, must be replaced
w i t h b u l b s o f i d e n t i c a l s p e c i fi c a t i o n
and colour.
Changing the third brake light
(diodes)
All work on the diode lights must be
carried out by a CITROËN dealer.
Page 141 of 216
P R A C T I C A L I N F O R M A T I O N
IX
139
Fascia fuses
T h e f u s e b o x e s a r e p l a c e d i n t h e l o w e r
part of the fascia behind the enclosed
storage compartment (left-hand side).
Access to the fuses
Open the cover A ,
P u l l i t t o w a r d s y o u t o e x t r a c t i t ,
Change the fuse (refer to the
corresponding paragraph).
Fuse N° Rating Functions
1 *
30 A Heating.
2 15 A Brake lights, third brake light, built-in systems
interface.
3 10 A Rear fog lamps.
4 30 A Windscreen wipers and wash-wipe.
5 10 A Diagnostic socket.
6 20 A C e n t r a l l o c k i n g , e x t e r i o r m i r r o r s .
7 15 A Audio equipment, telematics, multifunction display,
hands-free kit, rear DVD player.
8 7.5 A Remote control key, air conditioning control unit,
instrument panel, controls bar, steering wheel
controls.
9 15 A Multifunction display, instrument panel.
10 15 A Built-in systems interface.
11 15 A Rear wiper.
12 7.5 A Instrument panel, 4 wheel drive control unit,
air conditioning control panel, ABS control
unit, multifunction display, automatic headlamp
adjustment, heated seats, air bags control unit,
steering wheel angle sensor, sunroof, rear screen
demisting, remote control.
13 - Not used.
14 10 A Ignition switch.
15 20 A Sunroof.
16 10 A E x t e r i o r m i r r o r s , a u d i o e q u i p m e n t , t e l e m a t i c s , r e a r
DVD player.