2009 AUDI A4 CABRIOLET relay

Trailer lights
Trailer lights must meet all regulations. Be sure to check with your autho rized Audi dealer for correct wiring , switches and relays .
Mirrors
If you are unable to see the traffic behind you using the regular
outside mirrors, then you
must install extended mirrors. It is impor ­
tant that you always have clear vision to the rear .
& WARNING
After removing the trailer hitch, do not store it in your vehicle. In
case of sudden braking, the hitch could fly forward and injure you
or your passengers .
.1
Operating instructions
Maximum trailer weight
A trailer for your vehicle is limited to a typical class 1 or class 2
trailer .
Trailer load distribution
Be sure the load in the trailer is held securely in place to guard
against shifting, be it forward, backward or sideways.
Never allow a passenger to ride in a trailer~&, in "Driving instruc­
tions".
Tire pressure
When towing a trailer, inflate the tires of your vehicle to the cold tire
pressure listed under "Full load" on the sticker on the right door­
jamb. Inflate trailer tires to trailer and tire manufacturers' specifica­
tions.
Controls and equip­ ment Safety first Vehicle operation
Trailer towing
Lights
The
headlight settings should be checked with the trailer attached
before driving off. Adjust as necessary so that you can see the road
ahead but not blind on -coming traffic.
Check proper working of vehicle and trailer lights .
Safety chains
Be sure trailer safety chains are properly connected from the trailer
to the hitch on the vehicle. Leave enough slack in the chains to
permit turning corners. When you install safety chains, make sure
they will not drag on the road when you are driving.
The chains should cross under the trailer tongue to prevent it from
dropping in case of separation from the hitch .•
Driving instructions
Driving with a trailer always requires extra care and
consideration.
To obtain the best possible handling of vehicle and trailer,
please note the following:
Do not tow a loaded trailer when your car itself is not
loaded.
- Be especially careful when passing other vehicles.
Observe speed limits.
Do not drive at the maximum permissible speed.
- Always apply brakes early.
Monitor the temperature gauge.
Vehicle care Do-it-yourself service Technical data

_____________________________________________ C_h_ e_ c_k _in ---= g'--- a_n _d_ f_il _li _n ....:g=-------"'
•
If t he electrolyte level is be low the "min" level, have an authorized
w or ksho p fil l the ba tte ry ce ll wit h
distilled water.
0 Note
Do not over fill th e batt ery, ot he rwi se ba ttery acid will overflow
through the vent opening. This can damage the paint and cause
cor rosion .•
Battery charging
Starting the e ngin e requi res a well charge d ba ttery.
- Always read and heed all WARNINGS~ & in "Working
o n th e b attery" on
page 263 and ~ ,& .
- S witch off the ignitio n an d all elec trical co nsu mers .
- Make sur e th e are a is well ventilat ed whe n y ou c harge
t h e ba ttery .
- Co nn ect cha rger cables. Charger cables must always be
connected POSITIVE
G) to POSITIVE G) and NEGATIVE Q
to NEGATIVE Q .
- Sw itch o n the cha rge r.
- Make s ure the c har ging rate is not ove r 6 amps.
- Tur n o ff the cha rger ~ ,& .
- Disco nnect t he charg er ca bles .
- Conne ct both batter y ca bles to the b attery if n ecessa ry-
first plu s, th en minus .
It is not necessary to re move t he bat tery from th e eng in e compart ­
ment, and it is also not necessa ry to disconnect the cab les. Norma
lly, a battery should be charged at no more than 10 percent
o f its rate d capaci ty.
For example, a char ging current of 4 .5 amps wou ld be used on a
battery rated at 45 Ah . Rated capacity of the battery in you r vehicle
i s list ed o n the batt ery housi ng.
T he battery caps should
not be opened when charging a battery.
& WARNING
Charging a battery can be dangerous .
• Always follow the operating instructions provided by the
battery charger manufacturer when charging your battery .
• Never charge a frozen battery . It may e xplode because of gas
trapped in the ice . Allow a frozen battery to thaw out first .
• Do not reuse batter ies which were frozen . The battery housing
may have cracked and weakened when the battery froze .
• Charge the battery in a well ventilated area . Keep away from
open flame or electrical spark. Do not smoke. Hydrogen gas gener ­
ated by the battery is explosive .
• To reduce the danger of explo sion, never connect or di sconnect
c harger cables while the charger is operating.
• Fast charging a battery is dangerous and should only be
attempted by a competent techni cian with the proper equipment .
• Battery acid that may spill during charging should be washed
off with a solution of warm water and baking soda to neutralize
the acid .
0 Note
Never use a fas t char ger as a booster to start the eng ine. Th is wi ll
seriously damage sensitive electronic components, such as control
units, relays, rad io, etc., as w ell as th e battery c harg er. •
Ve hic le care

______________________________________________ E_ m_ e_r -=g :...e _ n_ c __a. y_ s_it _u_ a_ ti_o _ n_ s _ __,11111
& WARNING (continued)
• Before you check anything in the engine compartment, always
read and heed all WARNINGS~ page 242, "Engine compartment".
0 Note
• Applying a higher voltage booster battery will cause expensive
damage to sensitive electronic components, such as control units,
relays, radio, etc .
• There must be no electrical contact between the vehicles as
otherwise current could already start to flow as soon as the positive
(+) terminals are connected.
[ i] Tips
The discharged battery must be properly connected to the vehicle's
electrical system. •
Use of jumper cables
Make sure to connect the jumper cable clamps in exactly
the order described below!
Fig. 225 Jump·
starting with the
battery of another
vehicle : A -discharged
vehicle battery, B -
booster battery
Vehicle with discharged battery:
- Turn off lights and accessories, move lever of automatic
transmission to
N (Neutral) or P (Park) and set parking
brake.
Connect POSITIVE (+) to POSITIVE (+) (red)
1. Connect clamp of plus cable to positive(+) terminal G)
~ fig. 225 of discharged vehicle battery@.
2. Connect clamp on opposite end of cable to positive(+)
terminal
® of booster battery@.
Connect NEGATIVE (-) to NEGATIVE (-) (black)
3. Connect clamp of minus cable (black) to negative( -)
terminal
0 of booster battery@.
4. Connect clamp on opposite end of negative cable to the
negative( -) terminal © of the discharged vehicle battery
@.
- Check that all screw plugs on the battery cells are
screwed in firmly. If not, tighten plugs prior to
connecting clamp on negative battery terminal.
Starting the engine
- Start the engine of the vehicle with the booster battery.
Run the engine at a moderate speed.
- Start engine with discharged vehicle battery in the usual
manner.
- If the engine fails to start: do not keep the starter
cranking for longer than 10 seconds. Wait for about 30
seconds and then try again. .,,.
~ehicle care Do-it-yourse lf service Technical data