2009 Alfa Romeo GT tyre pressure

CAR MAINTENANCE
217
SCHEDULED MAINTENANCE PROGRAMME
20 40 60 80 100 120 140 160 180Thousands of km
Check tyre conditions/wear and adjust pressure if necessary
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, boot, passenger compartment, glovebox lights, warning lights, etc..)
Check operation of windscreen washer system, adjust spray jets
Check position/wear of windscreen/rearscreen wiper blades
Check operation of front disk brake pad wear indicator
Check wear conditions of rear disk brake pads
Sight check the conditions of: body exterior, underbody protection, stiff pipes
and hoses (exhaust - fuel supply - brakes), rubber parts
(boots - sleeves - bushes etc..)
Check cleanness of locks, bonnet and boot and lever cleanness, and lubrication
Sight inspect accessory drive belt conditions
Check handbrake lever stroke adjustment
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (JTD versions)
Top up fluid levels (engine coolant, brakes, windscreen washer, battery, etc..)
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●
●●●●
●●●●
●●●●●●●●●
●●●●●●●●●

CAR MAINTENANCE
219
ADDITIONAL
OPERATIONS
Every 1000 kmor before long journeys,
check and if necessary top up:
– engine coolant fluid level
– brake/hydraulic clutch control fluid level
– power steering fluid level
– windscreen washer and headlamp wash-
er fluid level
– tyre pressure and conditions.
Every 3000 kmcheck and if necessary
top up the engine oil level.
The use of FL Seleniaproducts is rec-
ommended which have been designed and
made expressly for Alfa Romeo cars (see
“Refuelling” in the “Technical Specifica-
tions” chapter).
ANNUAL INSPECTION
PROGRAMME
For cars with an annual mileage
of below 20,000 km (for example
about 10,000 km) the following
yearly inspection programme is ad-
vised:
– Check tyre conditions/wear and if nec-
essary adjust the pressure (including spare
wheel)
– Check operation of lighting system
(headlights, direction indicators, hazard
warning lights, boot, passenger compart-
ment, glovebox lights, warning lights, etc.)
– Check operation of windscreen wiper
system, spray jet adjustment
– Check windscreen blade position/wear
– Check front disk brake pad conditions
and wear
– Check cleanness of bonnet and boot
locks, and lever cleanness and lubrication.– Sight check for conditions of: engine,
gearbox, transmission, pipes (exhaust - fu-
el supply - brakes), rubber parts (boots -
sleeves - bushes etc..), brake and fuel sup-
ply system hoses
– Check battery charge
– Sight check for conditions of various dri-
ve belts
– Check and if necessary top up fluid lev-
els (engine coolant, brakes, windscreen
washer, battery etc. )
– Change engine oil and oil filter
– Change pollen filter.

CAR MAINTENANCE
233
Incorrect pressure causes abnormal tyre
wear:
(A): normal pressure: tread evenly worn.
(B): low pressure: tread particularly worn
at the edges.
(C): high pressure: tread particularly worn
in the centre.
Tyres should be changed when the tread
thickness is reduced to 1.6 mm.
In any case follow local regulations.
You are also reminded that services with
high current absorption switched on by the
user, such as for example: baby bottle warm-
ers, vacuum cleaner, mobile phone, mini
fridge, etc., quicken the battery drain-
ing processif they are turned on with the
engine off or running at idle speed.
IMPORTANTWhen installing addition-
al systems on the car, bear in mind that im-
proper branches on connections of the car
wiring are dangerous, particularly if safety
devices are involved.
WHEELS AND TYRES
TYRE PRESSURE
Check the tyre pressure of every wheel, in-
cluding the spare, every two weeks and be-
fore a long journey. The pressure should be
checked with the tyre rested and cold.
It is normal for the pressure to increase
when the car is in use; for the correct tyre
inflation pressure, see “Wheels” in the
“Technical Specifications” chapter.
Battery
60 Ah
70 AhMaximum permissible
loadless absorption
36 mA
42 mA
The maximum absorption of all the ac-
cessories (standard and fitted afterwards)
should be 0,6 mA x Ah (of the battery), as
shown in the following table:
fig. 16
A0A0225b

CAR MAINTENANCE
234
Alloy rim painting involv-
ing temperatures exceed-
ing 150 °C should be
avoided since wheel mechanical
characteristics could be impaired. Do not cross switch the
tyres, moving them from
the right of the car to the
left and vice versa.Excessive low pressure
causes overheating of the
tyre with the possibility of
serious damage to it.Remember that car road
holding also depends on
correct tyre inflation pres-
sure.
RUBBER HOSES
As far as the brake system and fuel sup-
ply rubber hoses are concerned, carefully fol-
low the Scheduled Maintenance Pro-
gramme. Indeed, ozone, high temperatures
and the prolonged lack of fluid in the sys-
tem may cause hardening and cracking of
the hoses, with possible leaks. Careful con-
trol is therefore necessary.
IMPORTANT NOTES
– Where possible, avoid sudden braking,
tyre squealing starts, violent bumps against
kerbs, potholes or obstacles of various kinds.
Prolonged driving on rough roads may dam-
age the tyres;
– Routinely check the tyres for cuts on the
sides, swellings or uneven tread wear. If nec-
essary contact Alfa Romeo Authorised Ser-
vices;
– Avoid overloading the car when travel-
ling: this may cause serious damage to the
wheels and tyres;
– If a tyre is punctured, stop immediate-
ly and change it to avoid damage to the tyre
itself, the rim, suspensions and steering sys-
tem;
– Tyres age even if they are not used
much. Cracks in the tread rubber are a sign
of aging. In any case, if the tyres have been
on the car for over 6 years, they should be
checked by specialised personnel, to see if
they can still be used. Also remember to
check the compact spare wheel;
– In case of replacement, always fit new
tyres, avoiding those of dubious origin;

TECHNICAL SPECIFICATIONS
249
COLD TYRE INFLATION PRESSURE
With the tyre hot the inflating pressure should be +0.3 bar compared with the specified rating
With winter tyres the inflation pressure should be +0,2 bar compared with the specified rating
PERFORMANCE
1.8 T. SPARK2.0 JTS 2.0JTS 3.2 V6JTD16V
Selespeed
Maximum speed in km/h 200 216 216 243 209 Tyres
195/60 R15bar
205/60 R15bar
205/55 R16bar
205/55 ZR16bar
215/45 R17bar
225/45 ZR17bar
225/40 ZR18bar
Compact spare wheel
125/80 R15bar
reduced load
front rear
2.2 2.2
2.3 2.3
2.3 2.3
2.3 2.3
2.4 2.3
2.5 2.4
2.5 2.4
4.2full load
front rear
2.5 2.5
2.6 2.6
2.6 2.6
2.6 2.6
2.7 2.6
2.8 2.7
2.8 2.7
4.2

ALPHABETICAL INDEX
263
- rear centre lap belt .................. 27
- use of belts ............................ 26
Seats
- front ..................................... 16
- rear ...................................... 19
Selespeed gearbox ...................... 110
Sidelights
- changing front bulbs ................ 197
- changing rear bulbs ................. 199
- switching on .......................... 45
Snow chains ............................... 177
Speedometer .............................. 56
Steering lock .............................. 15
Steering system .......................... 245
Steering wheel ........................... 22
Sun visors .................................. 126
Suspensions ............................... 245
Symbols .................................... 5-6
Technical specifications........ 240
Towing the car ............................ 213
Towing trailers ............................ 174
Transmission ............................... 243
Tyres
- correct reading ....................... 246 - Fix&Go automatic ................... 186
- inflating pressure .................... 249
- replacement ........................... 181
- snow chains ........................... 177
- types of tyres and rims ............ 247
- winter ................................... 177
VDC system ............................. 136
Vehicle inactivity ......................... 178
Warning lights and messages ..... 72
Weights ..................................... 251
Wheel geometry ......................... 246
Wheels and tyres ................... 233-246
Windscreen washer
- intelligent washing function ...... 47
- operation ............................... 47
- spray jets .............................. 235
Windscreen wiper
- blade replacement .................. 235
- operation ............................... 47
- rain sensor ............................. 48
- spray jets .............................. 235

COLD TYRE INFLATION PRESSURES
ENGINE OIL REPLACEMENT
Oil sump and filter (1.8 T. SPARK - 2.0 JTS) ........................ litres 4.4
Oil sump and filter (3.2
V6) .............................................. litres 5.9
Oil sump and filter (JTD
16V) ............................................. litres 4.5
Do not discard used oil in the environment.
REFUELLING
Fuel tank capacity............................................................ litres 63
Reserve .......................................................................... litres 7
Only refuel petrol engines with unleaded petrol with octane rating (RON)
not less than 95.
Only refuel diesel engines with diesel fuel for motor vehicles (Specifica-
tion EN590).
CUSTOMER SERVICESTECHNICAL SERVICES - SERVICE ENGINEERING
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Fiat Group Automobiles S.p.A.
Print No. 60431933 - 1
stEdition - 05/2008All rights reserved. Reproduction, even in part is prohibited without written permission
from Fiat Group Automobiles S.p.A.
SERVICE
Tyres
195/60 R15bar
205/60 R15bar
205/55 R16bar
205/55 ZR16bar
215/45 R17bar
225/45 ZR17bar
225/40 ZR18bar
Compact spare wheel (*)125/80 R15barreduced load
front rear
2.2 2.2
2.3 2.3
2.3 2.3
2.3 2.3
2.4 2.3
2.5 2.4
2.5 2.4
4.2full load
front rear
2.5 2.5
2.6 2.6
2.6 2.6
2.6 2.6
2.7 2.6
2.8 2.7
2.8 2.7
4.2
With the tyre hot the inflating pressure should be +0.3 bar compared with the specified rating
With winter tyres the inflation pressure should be +0.2 bar compared with the specified rating
(*) The compact spare wheel cannot be used on 3.2
V6version