2009 Alfa Romeo 8C oil change

194
8
A
MAXMIN
ENGINE OIL
The level must be checked when the engine is
warm, following the procedure below:
- start the vehicle and warm it up until the
temperature stabilises;
- turn off the engine, remove the fi ller cap
A
and wait 5 minutes to allow the oil to fl ow
into the sump;
- measure the level and top up if necessary.
The oil level must be between the MIN and MAX
notches on the dipstick.
The interval between MIN and MAX corresponds
to approximately 1.5 litres of oil.
WARNING: Do not exceed the MAX level!
If the oil level is close to or below the MIN notch,
add oil through the filler neck
A positioned next
to the dipstick until reaching the MAX notch. The
oil level must never exceed the MAX reference
notch.
WARNING: Do not top up with oil having
characteristics other than those of the oil already
used in the engine.After topping up or replacing the oil, check its
level once again.
WARNING: The engine oil used and the oil filter
changed contain substances that are dangerous
for the environment. To replace the oil and
filters, we advise you to contact an Authorised
Service Centre of the Manufacturer’s
Network where all the necessary equipment is
available to dispose of the used oil and filters in
compliance with applicable legislation and in an
environment-friendly manner.

195
8
MAXMIN
B
MAINTENANCE
GEARBOX OIL
Have the oil level checked at an Authorised
Service Centre of the Manufacturer’s
Network.WARNING: Do not top up with oil having
characteristics other than those of the oil already
used in the engine.
WARNING: Waste transmission oil contains
substances that are dangerous for the
environment. To have the oil changed, we advise
you to contact an Authorised Service Centre
of the Manufacturer’s Network, where all the
necessary equipment is available to dispose
of the used oil and filters in compliance with
applicable legislation and in an environment-
friendly manner.
ENGINE COOLANT
CAUTION
When the engine is very hot, do
not remove the cap from the pan: risk
of burns!
The fluid level must be checked with the engine
cold and must be between the MIN and MAX
reference notches visible on the tank.
If the level is too low, slowly pour the
recommended fluid through the pan filler neck
until the level is near to the MAX reference
notch.WINDSCREEN/
HEADLIGHT WASHER
FLUID
For topping-up, open the cover
B, extract the
filler neck extension and pour in a mixture of
water and detergent in the proportion indicated
on the package.
WARNING: If the temperature is below 20°C,
use pure detergent fluid.
WARNING: Do not drive with the windscreen
washer tank empty: the action of the washer is
essential for improving visibility.

196
8
MAX
MA
X MAX
MIN MIN
POWER STEERING FLUIDWARNING: Make sure that the power steering
fluid does not come in touch with the engine hot
parts as it is flammable.Check that the fluid level, with the vehicle on a
level ground and the engine cold, is in position
with the MAX notch shown on the dipstick.
For inspection, unscrew the cap, clean the
dipstick, tighten the cap back on tight, remove it
again and check the level.
When the oil is hot the level may also exceed the
MAX notch.If necessary, top up with fluid making sure that it
has the same characteristics as the one already
used in the system.
BRAKE FLUID
Check that the fluid level in the tank is at the
maximum level. If the level goes below the
minimum, with the ignition key in position MAR,
the relative warning light
will illuminate on
the instrument panel.
If fluid is needed for topping up, use only the
type classified as DOT4.
WARNING: The brake fluid is hygroscopic (i.e.
it absorbs humidity). For this reason, if the
vehicle is used mainly in areas with a high rate
of atmospheric humidity, the fluid should be
changed more frequently than indicated in the
Maintenance Schedule.
WARNING: Do not let the brake fluid, which
is highly corrosive, come into contact with the
paintwork. If this should happen, wash the
paintwork immediately with water.
WARNING: The symbol
on the container
identifies the synthetic type of brake fluid,
distinguishing it from the mineral type. Using
mineral fluids irreparably damages the special
rubber linings of the braking system.