2009 Acura TL turn signal

XM radio receives signals f rom two
satellites to produce clear, high-
quality digital reception. It of f ers
many channels in several categories.
Along with a large selection of
dif f erent types of music, XM radio
also allows you to view channel and
category selections in the audio
display.
Your vehicle is capable of receiving
XM Radio anywhere in the United
States and Canada, except Hawaii,
Alaska,andPuertoRico.XM
is a
registered trademark of XM Satellite
Radio
,Inc.
To listen to XM radio, set the power
mode to ACCESSORY or ON. Push
the button to select the XM
radio. The last channel you listened
to will show in the audio screen (if
selected) and the center display.
Adjust the volume by turning the
VOL/ knob. Yourvehiclehastheenginestart/
stop button instead of an ignition
switch. For more inf ormation to
select the power mode, see page .
Each time you push the interface
selector up, the band will change to
XM1 or XM2. Push the AUDIO
button to display XM inf ormation on
the screen. You can operate the XM
radio system with the interf ace dial.
178
CONT INUED
Operating the XM Radio
Playing the XMRadio (Models with navigation system)
Features
293
\f—\f—y


y
) \f\fy\fy
2009 TL

ÛÝ´
µ ´µ ´µ
´
µ
Three controls f or the audio system
are mounted in the steering wheel
hub. These let you control basic
f unctions without removing your
hand f rom the wheel.
The VOL button adjusts the volume
up ( ) or down ( ). Press the top
or bottom of the button, hold it until
the desired volume is reached, then
release it. The MODE button changes the
mode. Pressing the button
repeatedly selects FM1, FM2, AM,
XM radio, disc (if a disc is loaded),
HDD (on models with navigation
system), Bluetooth
Audio (if
paired), AUX (if an appropriate audio
unit is connected).
If an iPod or a USB f lash memory
device is plugged into the system,
you can also select AUX.
If you are listening to the radio, use
the CH button to change stations.
Each time you press the top ( ) of
the button, the system goes to the
next preset station on the band you
are listening to. Press the bottom
( ) to go back to the previous
preset station. If you press and hold
the CH button ( ) or ( ), the
system goes into the skip (seek)
mode. It stops when it f inds a station
with a strong signal. To activate the seek function, press
and hold the top ( ) or bottom ( )
of the CH button until you hear a
beep. The system searches up or
down f rom the current f requency to
find a station with a strong signal.
If you are playing a disc, the system
skips to the beginning of the next
track (f ile in MP3 or WMA f ormat)
each time you press the top ( ) of
the CH button. Press the bottom
( ) to return to the beginning of the
current track/f ile. Press it twice to
return to the previous track/f ile.
Remote Audio Controls
374
MODE BUTTON
VOL BUTTON CH BUTTON
\f—
—y
\f
y
) \f\fy\fy
2009 TL

»¼
To change f rom the currently linkedphone to another paired phone, do this:
To f ind out the status of the phone being
used, do this:
To list all paired phones, do this:
Press and release the Talk button.
Af ter the beep, say ‘‘Phone setup.’’
HFL responds ‘‘Phone setup
options are pair, edit, delete, list,
status, next phone, and set pairing
code. Press the Talk button and
say a command.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Phone setup.’’
HFL responds ‘‘Phone setup
options are pair, edit, delete, list,
status, next phone, and set pairing
code. Press the Talk button and
say a command.’’
Press and release the Talk button.
Af ter the beep, say ‘‘List.’’
HFL responds by listing the name
of each paired phone. When all
phones paired to the system have
been read, HFL responds ‘‘The
entire list has been read.’’ Press and release the Talk button.
After the beep, say ‘‘Status.’’ For
example, HFL responds ‘‘John’s
phone is linked. Battery strength
is three bars. Signal strength is
f ive bars, and the phone is
roaming.’’
Some Phones may not send the
status information to the HFL
system. Press and release the Talk button.
Af ter the beep, say ‘‘Next phone.’’
HFL responds ‘‘Searching f or the
next phone.’’
The system then disconnects the
linkedphoneandsearchesfor
another paired phone. If the
system f inds it, f or example, HFL
responds ‘‘Paul’s phone is linked.’’
If no other phones are f ound or
paired, the f irst phone remains
linked. For example, HFL responds
‘‘No other paired phones were
f ound/have been paired. Returning
to John’s phone .’’
Press and release the Talk button.
Af ter the beep, say ‘‘Phone setup.’’
HFL responds ‘‘Phone setup
options are pair, edit, delete, list,
status, next phone, and set pairing
code. Press the Talk button and
say a command.’’
2.
1.
1.
2.
1.
2.
BluetoothHandsFreeL ink(Models without navigation system)
402
\f—\f—y
y
) \f\fy\f\fy
2009 TL

HFL system f unctions can be
accessed using the interf ace dial.
The interf ace dial has two parts, a
dial and a selector.The selector can be pushed lef t,
right, up, down, and in. Use the
selector to scroll through lists, to
select menus, and to highlight menu
items. When you make a selection,
push the center of the selector
(ENTER)togotothatselection.
The CANCEL button clears the
current screen and returns to the
previous display.If you receive a call and you are on
the Cellular Phone screen, the
f ollowing screen is displayed:
The dial turns lef t and right. Use it to
make selections f rom a list or menu
on the screen.
The INFO button takes you to the
inf ormation menu, where you can
select the Cellular Phone screen.
You can also press the PICK-UP
buttononthesteeringwheeltogo
directly to the Cellular Phone screen. If this is not displayed, press the
INFO button, select Cellular Phone,
then press ENTER to display the
Cellular Phone screen. You can also
pressthePICK-UPbuttononthe
steering wheel to go directly to the
Cellular Phone screen.
Interf ace Dial
HFL Display
BluetoothHandsFreeL ink(Models with navigation system)
422
ENTER
SELECTOR INFO BUTTON
CANCEL
BUTTON
CALLER NAME
PHONE DIALING
ROAM STATUS
BLUETOOTH INDICATOR
DIAL BATTERY LEVEL
STATUS
SIGNAL STRENGTH
\f—
—y
\f
\f\fy
) \f\fy\fy
2009 TL

Your vehicle is equipped with a tire
pressure monitoring system (TPMS)
that turns on every time you start the
engine and monitors the pressure in
your tires while driving.If you think you can saf ely drive a
short distance to a service station,
proceed slowly to the station, then
inflate the tire to the recommended
pressure shown on the driver’s
doorjamb.
If the tire is f lat, or if the tire
pressure is too low to continue
driving, replace the tire with the
compact spare tire (see page ).
Driving on a signif icantly under-
inf lated tire causes the tire to
overheat and can lead to tire failure.
Under-inf lation also reduces f uel
efficiency and tire tread life, and may
af f ect the vehicle’s handling and
stopping ability.
Becausetirepressurevariesby
temperature and other conditions,
the low tire pressure/TPMS
indicator may come on unexpectedly.
When the low tire pressure/TPMS
indicator is on, one or more of your
tires is signif icantly underinf lated.
Youshouldstopandcheckyourtires
as soon as possible, and inflate them
to the proper pressure as indicated
on the vehicle’s tire inf ormation
placard.
Each tire has its own pressure
sensor. If the air pressure of a tire
becomes signif icantly low, the
sensor in that tire immediately sends
a signal that causes the low tire
pressure/TPMS indicator in the
instrument panel to come on. If this
happens, you will see which tire is
losing pressure on the multi-
inf ormation display along with a
‘‘CHECK TIRE PRESSURE’’
message. It is possible that the pressures
shown on the multi-inf ormation
display and the pressures you
manually measure are slightly
dif f erent.
If the dif f erence is signif icant or you
cannot make the low tire pressure/
TPMS indicator and message on the
multi-inf ormation display go out af ter
inf lating the tires to the specif ied
values, have your dealer check the
system as soon as possible. 583
Low Tire Pressure/
TPMS Indicator
Tire Pressure Monitoring System (TPMS)
526
\f—\f—y
\fy
) \f\fy\f
y
2009 TL

CONT INUED
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.Start the engine. If you are
replacing a driver’s side bulb, turn
the steering wheel all the way to
theright.If youarereplacinga
passenger’s side bulb, turn the
steering wheel to the lef t. Turn of f
the engine.
Remove the bulb by pulling it
straight out of its socket. Install the new bulb in the socket
by pushing it straight in the socket
until it bottoms.
Insert the socket into the
headlight assembly. Turn it
clockwise to lock it in place.
Test the lights to make sure the
new bulb is working.
Set the spoiler and inner f ender
cover in the original position.
Install the bolts and holding clips,
andlocktheminplacebypushing
on their center.
4.
5. 6.
7.
8.
1.
9.
Lights
Replacing a Front T urn Signal/
Parking L ight Bulb
Maint enance
559
SOCKET
BULB
\f—\f—y


\fy
) \f\fy\fy
2009 TL

If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.
Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Testthenewbulbtomakesureit
works.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Put the holding clip into the hole
on the side of the trunk lining.
Reinstall the screw.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker. 6.
7.
8.
9.
5.
4.
Lights, Cleaning the Seat Belts
Cleaning the Seat Belts
564
OPENING
BULB SOCKET
\f—\f—y



y
) \f\fy\fy
2009 TL

Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
CONT INUED
Specif ications
Technical Inf ormation
615
Engine (2WD)
Lights
Fuses Battery
Alignment Engine (SH-AWD)3.50 x 3.66 in (89.0 x 93.0 mm)
Water cooled 4-stroke
SOHC VTEC 6-cylinder (V6), gasoline engine
12 V
1.1 W 3.4 W
5W 16 W 55 W (H11)
21 W
12 V
12 V
12 V
12 V
12 V 211.7 cu-in (3,471 cm
)
11.2 : 1
ILZKR7B11
12 V 60 W (HB3)
12 V 24/2.2 CP
12 V 3 CP 12 V 35 W (D2S)
3CP
3CP
12 V 12 V Type
BorexStroke
Displacement
Compression ratio
Spark plugs
Headlight (Low beam )
Headlight (High beam/DRL)
Front turn signal/parking
lights
Front side marker lights
Front fog lights
Rear turn signal lights
Back-up lights
Rear side marker lights
License plate light
Trunk light
Door courtesy lights
Vanity mirror lights
See page603or the fuse box
cover.
Interior
Under-hood Capacity
12 V 12 V72 AH/20 HR
60 AH/5 HR
On vehicles with high voltage discharge type low beam headlights,
replacement of a bulb should be performed by your dealer.
Toe-in
Camber
Caster 3.8°1°
0.5°
0.08 in (2.0 mm) 0.00 in (0.0 mm)
Type
BorexStroke
Displacement
Compression ratio
Spark plugs
SXU22HCR11S11.2 : 1
223.5 cu-in (3,664 cm
)
3.54 x 3.78 in (90.0 x 96.0 mm) Water cooled 4-stroke
SOHC IN/EX VTEC 6-cylinder (V6), gasoline engineSXU22HCR11
ILZKR7B-11S
See pages604and605or the fuse
label attached to the inside of the
fuse box door on each side of the
dashboard. Front
Rear
Front
Rear
FrontDENSO:
(Amber)
NGK:
(Amber)
: NGK: DENSO:
——y


y
) yy
2009 TL