2009.5 Peugeot 3008 Dag boot
[x] Cancel search: bootPage 132 of 290
133
Emergency unlocking
For safety reasons, after this
manoeuvre it is essential to
contact a PEUGEOT dealer
urgently.
Following an emergency unlocking,
immobilisation of the vehicle is no
longer guaranteed once the manual
emergency unlocking has been de-
ployed and the manual control does
not allow the re-application of your
parking brake.
Take no action, either on control A , or
stopping starting the engine while the
unlocking device is engaged.
Take care not to allow moisture or
dust in the proximity of the plug.
Immobilise the vehicle, with the en-
g i n e r u n n i n g , b y e n g a g i n g fi r s t g e a r
(manual gearbox), position P (auto-
matic gearbox) or M or R (6-speed
electronic gearbox).
Switch off the engine but leave the
ignition on. If it is impossible to im-
mobilise the vehicle, do not action
the control and urgently contact a
PEUGEOT dealer.
Fetch the two vehicle blocks and
the unlocking device, located under
the boot carpet (see "Changing a
wheel" in the "Practical information"
section).
Immobilise the vehicle by placing
blocks at the front and at the rear of
one of the rear wheels.
Slide the front left-hand seat back
as far as possible.
L i f t u p t h e fl o o r p l u g B in the carpet
under the seat.
Remove the cap C on the tube D
with the unlocking device.
Place the unlocking device in the
tube D .
Turn the unlocking device clock-
wise. For safety reasons , it is
essential to continue turning the
device as far as it will go or until you
hear a knocking noise. The parking
brake is released.
Remove the unlocking device and
store it with the blocks in the tool-
box.
- The operation of the parking brake reinitialises when the igni-
tion is switched off then on again.
If the reinitialisation of the parking
brake proves impossible, contact a
PEUGEOT dealer.
- The subsequent time required for application may be longer than dur-
ing normal operation.
Front left seat moved back fully.
In the event of the electronic parking
brake malfunctioning or the battery run-
n i n g fl a t , a n e m e r g e n c y m a n u a l d e v i c e
can unlock the parking brake.
Page 137 of 290
133
Emergency unlocking
For safety reasons, after this
manoeuvre it is essential to
contact a PEUGEOT dealer
urgently.
Following an emergency unlocking,
immobilisation of the vehicle is no
longer guaranteed once the manual
emergency unlocking has been de-
ployed and the manual control does
not allow the re-application of your
parking brake.
Take no action, either on control A , or
stopping starting the engine while the
unlocking device is engaged.
Take care not to allow moisture or
dust in the proximity of the plug.
Immobilise the vehicle, with the en-
g i n e r u n n i n g , b y e n g a g i n g fi r s t g e a r
(manual gearbox), position P (auto-
matic gearbox) or M or R (6-speed
electronic gearbox).
Switch off the engine but leave the
ignition on. If it is impossible to im-
mobilise the vehicle, do not action
the control and urgently contact a
PEUGEOT dealer.
Fetch the two vehicle blocks and
the unlocking device, located under
the boot carpet (see "Changing a
wheel" in the "Practical information"
section).
Immobilise the vehicle by placing
blocks at the front and at the rear of
one of the rear wheels.
Slide the front left-hand seat back
as far as possible.
L i f t u p t h e fl o o r p l u g B in the carpet
under the seat.
Remove the cap C on the tube D
with the unlocking device.
Place the unlocking device in the
tube D .
Turn the unlocking device clock-
wise. For safety reasons , it is
essential to continue turning the
device as far as it will go or until you
hear a knocking noise. The parking
brake is released.
Remove the unlocking device and
store it with the blocks in the tool-
box.
- The operation of the parking brake reinitialises when the igni-
tion is switched off then on again.
If the reinitialisation of the parking
brake proves impossible, contact a
PEUGEOT dealer.
- The subsequent time required for application may be longer than dur-
ing normal operation.
Front left seat moved back fully.
In the event of the electronic parking
brake malfunctioning or the battery run-
n i n g fl a t , a n e m e r g e n c y m a n u a l d e v i c e
can unlock the parking brake.
Page 165 of 290
PRACTICAL INFORMATION
163
TEMPORARY TYRE REPAIR KIT
Complete system consisting of a com-
pressor and a bottle of sealant which per-
mits temporary repair of the tyre so that
you can drive to the nearest garage.
The kit is located in the boot under the
fl o o r . I t i s i n s t a l l e d i n t h e t o o l b o x , l o c a t e d
u n d e r t h e s t o r a g e b o x .
A l l o f t h e s e t o o l s a r e s p e c i fi c t o y o u r
vehicle. Do not use them for other
purposes.
1. Bottle.
Contains a sealant for temporary repair of the tyre.
2. 12 V compressor.
Permits adjustment of the pres- sure of the tyre.
3. Two chocks to immobilise the ve-
hicle.
4. Wheelbrace * .
Permits removal of the wheel trim a n d r e m o v a l o f t h e w h e e l fi x i n g
bolts.
5. Jack * with integrated handle.
Permits lifting of the vehicle.
List of tools
Other accessories
6. "Bolt cover" tool * .
Permits removal of the bolt pro- tectors (covers) on alloy wheels.
7. Centring guide * .
Permits the repositioning of alloy wheels on the hub.
8. Socket for anti-theft bolts (located
i n t h e g l o v e b o x ) * .
Permits adaptation of the wheel- brace to the special "anti-theft"
bolts.
Only tools 1 to 3 are necessary for
temporary repair of the tyre.
I f s u b s e q u e n t l y y o u w i s h t o c h a n g e
y o u r w h e e l , r e f e r t o " R e m o v i n g / fi t t i n g
a wheel" in this section.
9. R e m o v a b l e t o w i n g e y e .
R e f e r t o " E l e c t r i c p a r k i n g b r a k e "
in the "Driving" section.
R e f e r t o t h e p a r a g r a p h " T o w i n g
the vehicle".
10. E l e c t r i c b r a k e e m e r g e n c y r e l e a s e
control.
* According to version.
Page 169 of 290
PRACTICAL INFORMATION
167
CHANGING A WHEEL
The tools are installed in the boot under
t h e fl o o r .
T o g a i n a c c e s s t o t h e m :
o p e n t h e b o o t ,
p l a c e t h e m o v a b l e b o o t fl o o r a t a n
angle (refer to the "Layout" sec-
t i o n ) ,
r a i s e t h e fl o o r ,
secure it by hooking its cord on the
h o o k o n t h e r e a r s h e l f s u p p o r t ,
remove the polystyrene storage
b o x ,
unclip by pulling upwards then re-
m o v e t h e b o x c o n t a i n i n g t h e t o o l s .
Access to the tools
Procedure for changing a faulty wheel
for the spare wheel using the tools pro-
vided with the vehicle.
T o m a k e t h e o p e r a t i o n e a s i e r , r e -
m o v e t h e m o v a b l e b o o t fl o o r ,
u n s c r e w t h e y e l l o w c e n t r a l b o l t ,
With the JBL bass box
r e m o v e t h e b a s s b o x d i s c o n n e c t i n g
t h e e l e c t r i c a l h a r n e s s ,
remove the polystyrene storage
b o x .
Page 170 of 290
PRACTICAL INFORMATION
167
CHANGING A WHEEL
The tools are installed in the boot under
t h e fl o o r .
T o g a i n a c c e s s t o t h e m :
o p e n t h e b o o t ,
p l a c e t h e m o v a b l e b o o t fl o o r a t a n
angle (refer to the "Layout" sec-
t i o n ) ,
r a i s e t h e fl o o r ,
secure it by hooking its cord on the
h o o k o n t h e r e a r s h e l f s u p p o r t ,
remove the polystyrene storage
b o x ,
unclip by pulling upwards then re-
m o v e t h e b o x c o n t a i n i n g t h e t o o l s .
Access to the tools
Procedure for changing a faulty wheel
for the spare wheel using the tools pro-
vided with the vehicle.
T o m a k e t h e o p e r a t i o n e a s i e r , r e -
m o v e t h e m o v a b l e b o o t fl o o r ,
u n s c r e w t h e y e l l o w c e n t r a l b o l t ,
With the JBL bass box
r e m o v e t h e b a s s b o x d i s c o n n e c t i n g
t h e e l e c t r i c a l h a r n e s s ,
remove the polystyrene storage
b o x .
Page 172 of 290
PRACTICAL INFORMATION
169
Fixing the steel or "space-
saving" type spare wheel
I f y o u r v e h i c l e i s fi t t e d w i t h
a l l o y w h e e l s , i t i s n o r m a l t o n o t i c e ,
w h e n t i g h t e n i n g t h e b o l t s o n fi t t i n g ,
that the washers do not come into
contact with the steel or "space-sav-
ing" type spare wheel. The wheel
is secured by the conical contact of
each bolt.
Access to the spare wheel
The spare wheel is installed in the boot
u n d e r t h e fl o o r .
A c c o r d i n g t o c o u n t r y , t h e s p a r e w h e e l
m a y b e s t e e l , a l l o y o r o f t h e " s p a c e s a v -
ing" type.
T o g a i n a c c e s s t o i t , r e f e r t o t h e p a r a -
graph "Access to the tools" on the previ-
ous page.
Taking out the wheel
Unscrew the yellow central bolt.
R a i s e t h e s p a r e w h e e l t o w a r d s y o u
from the rear.
Take the wheel out of the boot.
Putting the wheel back in place
Put the wheel back in its housing.
Unscrew the yellow central bolt by a
few turns then put it in place in the
centre of the wheel.
Tighten fully until the central bolt
clicks to retain the wheel correctly.
P u t t h e b o x b a c k i n p l a c e i n t h e c e n -
tre of the wheel and clip it.
P u t t h e p o l y s t y r e n e s t o r a g e b o x
back in place.
T y r e u n d e r - i n fl a t i o n
detection
T h e s p a r e w h e e l i s n o t fi t t e d
with a sensor. The punctured wheel
m u s t b e r e p a i r e d b y a P E U G E O T
dealer.
Page 179 of 290
PRACTICAL INFORMATION
176
Changing the third brake light bulb Changing the number plate light
bulbs (W5-5W)
I n s e r t a t h i n s c r e w d r i v e r i n t o o n e o f
the outer holes of the lens.
Push it outwards to unclip.
R e m o v e t h e l e n s .
Pull the bulb and change it.
Changing side light bulbs (boot) Changing fog lamp b
ulbs
Open the boot.
R e m o v e t h e p l a s t i c fl a p u s i n g a
screwdriver.
R e m o v e t h e l i g h t fi x i n g n u t .
T u r n t h e b u l b a q u a r t e r o f a t u r n a n d
change it.
T o r e fi t , c a r r y o u t t h e s e o p e r a t i o n s i n r e -
verse order.
R e a c h u n d e r t h e b u m p e r .
T u r n t h e b u l b a q u a r t e r o f a t u r n a n d
change it.
C o n s u l t a P E U G E O T d e a l e r .
Page 183 of 290
PRACTICAL INFORMATION
180
Fuse N° Rating
(A) Functions
F29 30 Boot 12 V socket.
F30 5 H e a t e d e x t e r i o r m i r r o r s .
F31 15 R e f r i g e r a t o r s o c k e t .
F32 5 P i l o t e d m a n u a l g e a r b o x g e a r l e v e r .
F33 10 H e a d u p d i s p l a y , h a n d s - f r e e k i t , a i r c o n d i t i o n i n g .
F34 5 Seat belt warning lights display.
F35 10 P a r k i n g a s s i s t a n c e , H i - F i a m p l i fi e r a u t h o r i s a t i o n .
F36 10 T r a i l e r f u s e b o x c o n t r o l u n i t , d r i v e r ' s d o o r c o n t r o l
pad.
F37 20 H i - F i a m p l i fi e r .
F38 30 D r i v e r ' s e l e c t r i c s e a t .
F39 20 Panoramic glass roof shutter.
F40 - Not used.