2009.5 Citroen C4 PICASSO steering
[x] Cancel search: steeringPage 171 of 338
137
D R I V I N G
Operation in manual mode
Move the selector to po-
sition M .
Paddle controls
behind the steering
wheel
The paddles behind the steering
wheel give you access to the six for-
ward gears. Changing gear
Pull the "
+
" paddle to change up
a gear.
Pull the " -
" paddle to change
down a gear. The paddles do not permit you to
select neutral or reverse gear, or to
exit reverse gear.
- If the vehicle stops or reduces
speed (for example when ap-
proaching a stop sign), the gear-
box changes down automatically,
t o fi r s t g e a r i f n e e d e d .
- In manual mode, it is not neces-sary to release the accelerator
completely during gear changes.
- A request to change gear is ac- cepted only if the engine speed
permits it.
- For safety reasons, depending on the engine speed, a change down
may be performed automatically.
In situations of high engine
speeds (heavy acceleration),
a change up will not occur
unless the driver operates
the paddle.
Page 177 of 338
143
IX
D R I V I N G
FIXED CENTRED CONTROLS STEERING WHEEL
Cruise control/speed limiter
and parking space function
controls
1. Selection of parking space
function.
2. Selection of cruise control or
speed limiter.
3. Activation/Deactivation of speed
limiter.
Deactivation/Reactivation of cruise control.
4. Increase speed/Activation of
cruise control.
5. Decrease speed/Activation of
cruise control. Audio system controls
A. Volume decrease.
B. Volume increase.
C. Search of higher frequencies.
D. Scrolling of pre-set stations.
E. Mute.
(see chapter "Audio and Telematics")
Page 179 of 338
145
D R I V I N G
SPEED LIMITER
System which prevents the vehi-
cle from exceeding the speed pro-
grammed by the driver.
Once the limit speed has been
reached, the accelerator pedal no
longer has any effect.
The speed limiter is switched on
manually: a speed of at least 20 mph
(around 30 km/h) must be pro-
grammed.
The speed limiter controls are located
on the left-hand side of the steering
wheel. The programmed information is
grouped together in zone
A of the
instrument panel display.
Steering wheel controls
Displays on the instrument panel
Programming
Rotate the control 1 to the "LIM"
position. With the engine running, you can
adjust the memorised maximum
speed, by means of short or long
presses on:
button 4 to increase the memo-
rised maximum speed,
button 2 to decrease the memo-
rised maximum speed.
Successive presses will modify the
maximum speed in steps of 1 mph
and a sustained press in steps of
3 mph.
Activation
When the desired maximum speed
is displayed, press button 3 so that
the limitation is activated.
On selection of the
function, the previous
memorised speed and
the information "OFF"
are displayed on the
instrument panel. The information
"OFF"
then disappears from the
instrument panel display.
While the function is active, pressing
the accelerator pedal will not enable the
programmed speed to be exceeded,
except if you press the pedal hard down
to beyond the end-of-travel switch.
The speed of your vehicle may vary
slightly in relation to that memorised.
The speed limiter cannot, in any circum-
stances, take the place of the observ-
ance of speed limits or of the vigilance
and responsibility of the driver.
Page 181 of 338
147
IX
D R I V I N G
CRUISE CONTROL
System which automatically main-
tains the vehicle speed programmed
by the driver, without any action on
the accelerator pedal.
The cruise control is switched on
manually: the vehicle speed must be
at least 25 mph (approx. 40 km/h)
and you must engage:
- fourth gear on a manual gearbox,
- second gear, in sequential mode, on an electronic gearbox or au-
tomatic gearbox,
- position A on an electronic gear-
box or D on an automatic gearbox.
Steering wheel controls
The cruise control switches are lo-
cated on the left-hand side of the
steering wheel. The programmed information is
grouped together in zone
A of the
instrument panel display.
Displays on the instrument panel
Activation You can then release the accelerator
pedal. The vehicle will automatically
keep to the speed chosen.
The speed of your vehicle may vary
slightly in relation to that memo-
rised.
You can adjust the memorised speed
on the instrument panel display by
pressing on:
button 4 to increase the speed,
button 2 to decrease the speed.
Successive presses modify the
cruise speed in steps of 1 mph and a
sustained press in steps of 3 mph.
Deactivation
Either by pressing on the brake
pedal or on the clutch pedal.
Or by pressing button 3 .
Or if either the ESP or the ASR
system is active.
The cruise control is not active if the
gear lever is in neutral.
On selection of the
function via control
1,
no cruise speed has
yet been memorised.
Programming
Rotate the control
1 to the "REG"
position.
Once the desired speed has been
reached using the accelerator, press
button 2 or button 4 . The cruise
speed is then memorised. It is dis-
played in zone A of the instrument
panel. These actions cause
the information
"OFF"
to appear on the instru-
ment panel display.
These actions do
not cancel the cruise
speed which remains
displayed in the instru-
ment panel.
The cruise control cannot, in any
circumstances, take the place of the ob-
servance of speed limits or of the vigi-
lance and responsibility of the driver.
Page 274 of 338
238
4
1
2 3
51
2 3
4
51
2
3
4
STEERING WHEEL CONTROLS
STEERING WHEEL CONTROLS
1 . Volume increase.
2 . Volume decrease.
3 . Mute.
4 . RADIO: selection of the previous or next stored station. MP3/JUKEBOX: selection of the previous or next directory.
5 . R A D I O : a u t o m a t i c s e a r c h f o r a h i g h e r f r e q u e n c y . CD/MP3/JUKEBOX: selection of the next track. CD/MP3: continuous press: fast forwards play.
1 . Displays the main screen.
2 . Selection of the mode displayed ( T R I P , T E L , N A V o r A U D I O ) .
3 . A b a n d o n t h e o p e r a t i o n i n p r o g r e s s and return to the previous display.
4 . N a v i g a t i o n t h r o u g h t h e m e n u s .
5 . C o n fi r m a t i o n o f t h e f u n c t i o n s e l e c t e d .
1 . Short press: A c t i v a t i o n o f v o i c e r e c o g n i t i o n .
2 . WHEN THE TELEPHONE IS NOT IN USE: L o n g p r e s s : a c c e s s t o t h e t e l e p h o n e m e n u ( p h o n e b o o k , c a l l l i s t , . . . ) . INCOMING CALL: Short press to accept. L o n g p r e s s t o r e j e c t t h e c a l l . CALL IN PROGRESS: S h o r t p r e s s t o h a n g u p . L o n g p r e s s t o a c c e s s t h e t e l e p h o n e m e n u .
3 . Personalisation: S h o r t p r e s s : c o n fi r m a t i o n o f t h e s e l e c t i o n m a d e u s i n g t h e d i a l .
4 . Rotation: Move around the phone book, the call list. Selection of personalisation.
Page 324 of 338
290
06
4
1
23
51
23
4
5
2
1
STEERING WHEEL CONTROLS
1. Volume increase.
2. Volume decrease.
3. Mute.
4. RADIO: selection of the previous or next stored station. CD/MP3/USB: selection of the previous or next directory.
5. R A D I O : a u t o m a t i c s e a r c h f o r a h i g h e r f r e q u e n c y . CD/MP3/USB: selection of the next track. CD/MP3: continuous press: fast forwards play.
1. Displays the main screen.
2. S e l e c t i o n o f t h e t y p e o f i n f o r m a t i o n d i s p l a y e d o n t h e r i g h t -hand side of the screen for the monochrome screen A .
3. A b a n d o n t h e o p e r a t i o n i n p r o g r e s s and return to the previous display.
4. N a v i g a t i o n t h r o u g h t h e m e n u s .
5. C o n fi r m a t i o n o f t h e f u n c t i o n s e l e c t e d . I f y o u r v e h i c l e i s fi t t e d w i t h t h e B l u e t o o t h s y s t e m : p i c k u p a n i n c o m i n g c a l l o r h a n g u p a c a l l w h i c h i s i n p r o g r e s s .
I f y o u r v e h i c l e i s fi t t e d w i t h t h e B l u e t o o t h s y s t e m :
1. P r e s s : a c t i v a t i o n o f t e l e p h o n e v o i c e r e c o g n i t i o n(if the telephone offers this function).
2. Press: displays the phone book, of the call list.