Page 248 of 274

The other two blocks can remain in the wheel well.
After use
The foam block and spare wheel must be replaced in the reverse order. Note the arrow on the upper foam block. It
should point forward.
263 06 Maintenance and specifications
Wheels and tires
NOTE
If the floor hatch is not completely closed, the private locking feature (see page 58
) will not function.
Changing a tire:
1. Apply the parking brake.
2. Put the gear selector in P .
3. Block the wheels that are on the ground with wooden blocks or large stones.
4. Remove the wheel cover (where applicable) using the lug wrench in the tool bag.With the vehicle still on the
ground, use the lug wrench to loosen the wheel nuts 1/2-1 turns by exerting downward pressure.
5. Turn the nuts counterclockwise to loosen.
6. There are two jack attachment points on each side of the vehicle. Position the jack correctly in the attachment (see
illustration above) and crank while simultaneously guiding the base of the jack to the ground. The base of the jack
must be flat on a level, firm, non-slippery surface. Before raising the vehicle, check that the jack is still correctly
ProCarManuals.com
Page 249 of 274

positioned in the attachment.
7. Raise the vehicle until the wheel to be changed is lifted off the ground.
8. Unscrew the wheel nuts completely and carefully remove the wheel so as not to damage the threads on the studs.
264 06 Maintenance and specifications
Wheels and tires
9. Raise the vehicle until the wheel to be changed is lifted off the ground.
10. Unscrew the wheel nuts completely and carefully remove the wheel so as not to damage the threads on the studs.
WARNING
The jack must correctly engage the jack attachment.
Be sure the jack is on a firm, level, non-slippery surface.
Never allow any part of your body to be extended under a vehicle supported by a jack.
Use the jack intended for the vehicle when changing a tire. For any other job, use stands to support the vehicle.
Apply the parking brake and put the gear selector in the Park (P) position.
Block the wheels standing on the ground, use rigid wooden blocks or large stones.
The jack should be kept well-greased and clean, and should not be damaged.
No objects should be placed between the base of jack and the ground, or between the jack and the attachment bar
on the vehicle.
Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten crosswise until all nuts are snug.
4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 62 ft. lbs. (85 Nm).
5. Install the wheel cap (where applicable).
265 06 Maintenance and specifications
Vehicle care
ProCarManuals.com
Page 251 of 274

carefully. Solvents or stain removers should not be used.
CAUTION
Avoid waxing or polishing plastic or rubber components
Polishing chromed strips can wear away or damage the surface
Polishes containing abrasive substances should not be used
Automatic car wash
We do NOT recommend washing your car in an automatic wash during the first six months (because the paint will
not have hardened sufficiently).
An automatic wash is a simple and quick way to clean your car, but it is worth remembering that it may not be as
thorough as when you yourself go over the car with sponge and water. Keeping the underbody clean is most important,
especially in the winter. Some automatic washers do not have facilities for washing the underbody.
CAUTION
Before driving into an automatic car wash, turn off the optional rain sensor to avoid damaging the windshield
wipers.
Make sure that side view mirrors, auxiliary lamps, etc, are secure, and that any antenna(s) are retracted or
removed. Otherwise there is risk of the machine dislodging them.
Chromed wheels : Clean chrome-plated wheels using the same detergents used for the body of the vehicle.
Aggressive wheel-cleaning agents can permanently stain chrome-plated wheels.
WARNING
When the vehicle is driven immediately after being washed, apply the brakes, including the parking brake, several
times in order to remove any moisture from the brake linings.
Engine cleaning agents should not be used when the engine is warm. This constitutes a fire risk.
Exterior lighting
Condensation may form temporarily on the inside of the lenses of exterior lights such as headlights, fog lights, or
taillights. This is normal and the lights are designed to withstand moisture. Normally, condensation will dissipate after
the lights have been on for a short time.
267 06 Maintenance and specifications
Vehicle care
Polishing and waxing
Normally, polishing is not required during the first year after delivery, however, waxing may be beneficial.
Before applying polish or wax the vehicle must be washed and dried. Tar spots can be removed with kerosene or tar
remover. Difficult spots may require a fine rubbing compound.
After polishing use liquid or paste wax.
Several commercially available products contain both polish and wax.
Waxing alone does not substitute for polishing a dull surface.
A wide range of polymer-based waxes can be purchased today. These waxes are easy to use and produce a long-
lasting, high-gloss finish that protects the bodywork against oxidation, road dirt and fading.
Do not polish or wax your vehicle in direct sunlight (the surface of the vehicle should not be warmer than 113° F
ProCarManuals.com
Page 262 of 274
2 0 0 8
VOLVO V70
282 Index
12-volt sockets 188, 189
A
Accessory installation warning7
Active Bi -Xenon® headlights90
Active chassis system155
Active yaw control153
Adaptive cruise control158-161
Air conditioning132
Air distribution130
Air distribution table135
Air vents130
Airbags
disconnecting the front passenger's side 22-24
front19- 21
inflatable curtain27
side impact25
Alarm system 66-68
All Wheel Drive114
Anti-freeze194, 226
Anti-lock brake system115
warning light75
Approach lighting 54, 95
Audio system
audio functions 139
CD player/changer140, 141
menu control137
overview136
radio functions143
Sirius satellite radio145- 148
sound settings139
steering wheel keypad136
Auto brake (collision warning) 168
Auto-dim rearview mirror102
Automatic locking64
Automatic locking retractor33
ProCarManuals.com
Page 263 of 274
Automatic transmission
Geartronic113
general description112- 113
oil279
shiftlock override113
Axle weight 256
B
Battery
changing 238-239
maintenance238
remote control, replacing60
specifications280
warning symbols237
Black box 6, 220
Blind Spot Information System(BLIS)182-184
Blinkers (turn signals)93
Booster cushion, integrated45-47
Booster cushions41
Brake lights91
emergency brake lights91
Brake system
checking fluid level 227
emergency brake assistance116
fluid279
general information115
Hill Descent Control117, 118
warning light77
Bulbs
cargo area lighting 233
fog lights232
footwell lighting233
headlights228- 230
introduction228
license plate lights233
side marker lights231
specifications234
taillight232
vanity mirror234
C
Capacity weight 256
Cargo area
changing bulbs 23
cover209
floor rails205
ProCarManuals.com
Page 265 of 274
Current, conserving193
D
Defroster133
Detachable key blade57-58
Dimensions
V70 272
XC70273
Direction indicators 93
Disconnecting the front passenger's airbag22-24
Distance Alert165
Dome lighting93-94
Door mirrors101
Driver Alert system173
Driver distraction warning7
Driving economically192
Driving in cold weather194
Driving through water193
E
ECC131-133
Economical driving192
Electric parking brake119
Electrically operated tailgate203
Electronic Climate Control131-133
air distribution table135
Interior Air Quality System133
ventilated seats131
Emergency brake lights 91
Emergency locking retractor33
Emergency starting111
Emergency towing216-217
Emission inspection readiness222
Engine
overheating 77
specifications275
starting110
starting with keyless drive110
Engine compartment overview 223
Engine oil
checking 224
low pressure warning light76
specifications276
volumes278
Environment 9
Eyelets for anchoring loads205
ProCarManuals.com
Page 269 of 274
Net in cargo area210
O
Occupant safety14
Occupant weight sensor22-24
Octane recommendations197
Odometer, trip78
Oil
checking 224
low pressure warning light76
specifications276
volumes278
On Call Roadside Assistance 281
Overhead courtesy lighting93-94
Overheating, engine77
Oxygen sensors, heated201
P
Pacemaker (keyless drive warning)63
Paint, touching up269
Panic alarm55
Park assist178-180
Parking brake
electric, applying/releasing 119
warning light76
Parking lights 90
changing bulbs230
Personal Car Communicator, unique functions 55-56
Polishing the vehicle267
Power front seat
memory function 83
with keyless drive84
Power mirrors 101
defroster102
Power moonroof 103-104
Power steering
fluid 227
, 279
speed-dependent155
Power tailgate (option) 203
Power windows99-100
laminated glass100
Pregnancy, using seat belts during 17
Private locking58
Proposition 65 warning9, 111, 239, 280
R
Radio
ProCarManuals.com