2008 TOYOTA xB engine

[x] Cancel search: engine

Page 245 of 284

TOYOTA xB 2008  Owners Manual (in English) 237
NOTICE
Remember that battery and ignition
cables carry high currents or volt-
ages. Be careful of accidentally
causing a short circuit.
 Add only “Toyota Super Long Life
Coolant” or similar

Page 247 of 284

TOYOTA xB 2008  Owners Manual (in English) 239
When jacking up your vehicle with the
floor jack, position the jack correctly as
shown in the illustration.CAUTION
When jacking, be sure to observe the
following to reduce the possibility of
perso

Page 249 of 284

TOYOTA xB 2008  Owners Manual (in English) 241
DO�IT�YOURSELF MAINTENANCE
Engine and Chassis
Checking the engine oil level242
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 
Checking the engine coolant level 244
. . . . . .

Page 250 of 284

TOYOTA xB 2008  Owners Manual (in English) 242
82p001a
Low level Full level
Add oil O.K. Too full
With the engine at operating tempera-
ture and turned off, check the oil level
on the dipstick. 1. To get a correct reading, the vehicle should b

Page 251 of 284

TOYOTA xB 2008  Owners Manual (in English) 243
ENGINE OIL SELECTION
“Genuine Motor Oil” is used in your Scion
vehicle. Use Scion approved “Genuine Mo-
tor Oil” or equivalent to satisfy the follow-
ing grade and viscosity.
Oil grade:ILS

Page 252 of 284

TOYOTA xB 2008  Owners Manual (in English) 244
Look at the see�through coolant reser-
voir when the engine is cold. The cool-
ant level is satisfactory if it is between
the “FULL” and “LOW” lines on the
reservoir. If the level  is low,

Page 253 of 284

TOYOTA xB 2008  Owners Manual (in English) 245
If either of the above parts are extremely
dirty or you are not sure of their condi-
tion, take your vehicle to a Scion dealer.
CAUTION
To prevent burning yourself, be care-
ful not to touch the r

Page 263 of 284

TOYOTA xB 2008  Owners Manual (in English) 255
NOTICE
Be sure the engine and all accesso-
ries are off before performing main-
tenance.
 When checking the battery, remove
the ground cable from the negative
terminal (“–” mark) first and