2008 TOYOTA RAV4 lock

’08 Rav4_U (L/O 0802)
233
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
For example, nearby buildings and terrain
can interfere with FM reception. Power
lines or telephone wires can interfere with
AM signals. And of course, radio signals
have a limited range. The farther you are
from a station, the weaker its signal will
be. In addition, reception conditions
change constantly as your vehicle moves.
Here are some common reception prob-
lems that probably do not indicate a prob-
lem with your radio:
FM
Fading and drifting stations—Generally, the
effective range of FM is about 40 km (25
miles). Once outside this range, you may
notice fading and drifting, which increase
with the distance from the radio transmit-
ter. They are often accompanied by distor-
tion.
Multi−path—FM signals are reflective,
making it possible for two signals to reach
your antenna at the same time. If this
happens, the signals will cancel each oth-
er out, causing a momentary flutter or
loss of reception.
Static and fluttering—These occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass
level may reduce static and fluttering. Station swapping—If the FM signal you
are listening to is interrupted or weak-
ened, and there is another strong station
nearby on the FM band, your radio may
tune in the second station until the origi-
nal signal can be picked up again.
AM
Fading—AM broadcasts are reflected by
the upper atmosphere–especially at night.
These reflected signals can interfere with
those received directly from the radio sta-
tion, causing the radio station to sound
alternately strong and weak.
Station interference—When a reflected sig-
nal and a signal received directly from a
radio station are very nearly the same
frequency, they can interfere with each
other, making it difficult to hear the broad-
cast.
Static—AM is easily affected by external
sources of electrical noise, such as high
tension power lines, lightening, or electri-
cal motors. This results in static.
FCC ID: BABBT010A
NOTE: This device complies with Part
15 of the FCC Rules. Operation is sub-
ject to the following two conditions, (1)
This device may not cause harmful in-
terference and (2) This device must ac-
cept any interference received, including
interference that may cause undesired
operation.
CAUTION
FCC WARNING:
Changes or modifications in construc-
tion not expressly approved by the
party responsible for compliance
could void the user’s authority to op-
erate the equipment.
Radio frequently exposure. This de-
vice is approved for Mobile Applica-
tion only and, to comply with applica-
ble FCC radio frequency exposure
regulations, must be used with a dis-
tance of at least 7.9in. (20cm) be-
tween the antenna and the body of
any person at all time during use.

’08 Rav4_U (L/O 0802)
240
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
Security (see page 250)
Set PIN
The PIN can be set or changed.
Phone book lock
The phone book can be locked.
Phone book unlock
The locked phone book can be un-
locked.
System Setup (see page 254)
Adjust Guidance Volume
Guidance volume can be adjusted.
Initialize
Phone Book (see page 254)
Add Entry
Phone numbers and voice tags can be
registered.
Change Name
The registered names can be changed.
Delete Entry
The registered names can be deleted.
Delete Speed Dial
The registered speed dial can be de-
leted.
List names
The registered names can be checked.
Set Speed Dial
Speed dials can be set
Redial (see page 262)
Callback (see page 263)
Making a phone call (see page 265)
Receiving a phone call (see page 267)
Talking on the phone (see page 268)
—Some basics

’08 Rav4_U (L/O 0802)
250
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
To delete a phone1. Push the talk switch and say [Delete], or turn the “AUDIO CONTROL” knob
until [Delete] is displayed and push the
knob.
[Delete. Push the talk switch and say the
phone name to delete.] is heard. 2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
the phone name you want to delete is
displayed and push the knob.
When using a voice command:
[XXX (desired phone name) Push the talk
switch and say confirm. Otherwise, say go
back.] is heard and the phone name is
displayed.
Follow voice guidance instructions, or turn
the “AUDIO CONTROL” knob until [Con-
firm] is displayed and push the knob.
[Deleted. Returning to the phone setup.] is
heard and $ [Deleted]$ is displayed.
When using the knob:
[Deleted. Returning to the phone setup.] is
heard and [Deleted] is displayed. The system may not function in the follow-
ing cases:
If no phone has been registered.
If the system does not recognize the
voice command.
The security menu includes the following:
Set PIN (Personal Identification Num-
ber)
The PIN can be set or changed.
Phone book lock
The phone book can be locked.
When the phone book is locked, the fol-
lowing functions cannot be used:
Dial by name
Redial
Callback
Speed Dial
Phone Book
Phone book unlock
The locked phone book can be unlocked.
—Security

’08 Rav4_U (L/O 0802)
251
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
To enter the security menu1. Push the off −hook switch to turn the
hands −free system on.
2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Setup] is displayed and push the knob.
[Setup. Please push the talk switch and
say security, or phone setup.] is heard.
3. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Security] is displayed and push the
knob.
[Security. Push the talk switch and say
set PIN, phone book lock, or phone book
unlock.] is heard. To set a PIN
Push the talk switch and say [Set PIN],
or turn the “AUDIO CONTROL” knob until
[Set PIN] is displayed and push the knob.
[There is no PIN number set. Please reg-
ister a PIN number. Please push the talk
switch and say a four
−digit PIN number.]
is heard. When using a voice command:
1. Push the talk switch and say a new PIN number.
2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the
knob.
[The PIN number has been set. Returning
to the security.] is heard and [Completed]
is displayed.
When using the knob:
1. Turn the “AUDIO CONTROL” knob to select a number. Push the “AUDIO
CONTROL” knob to set.
2. Repeat the above procedure until the entire four −digit number is set.
3. When the PIN is set, push the “AUDIO CONTROL” knob.
4. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the
knob.
[The PIN number has been set. Returning
to the security.] is heard and [Completed]
is displayed.

’08 Rav4_U (L/O 0802)
252
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
If the PIN is to be changed:
[There is a PIN number in place. Push the
talk switch and say the correct PIN num-
ber.] is heard and [Current PIN?] is dis-
played.1. Follow voice guidance instructions, or use the “AUDIO CONTROL” knob to
input the current PIN number.
[Please push the talk switch and say a
four −digit PIN number.] is heard.
2. Push the talk switch and say new PIN number.
[The PIN number has been set. Returning
to the security.] is heard and [Completed]
is displayed.
If the current number is not correct, the
system does not function properly.
INFORMATION
Do not forget your PIN. If you forget
the PIN, initialization will be neces-
sary. For details about initialization,
see page 254.
To lock the phone book 1. Push the talk switch and say [Phone book lock], or turn the “AUDIO CON-
TROL” knob until [Phbk Lock] is dis-
played and push the knob.
[There is a PIN number in place. Push the
talk switch and say the correct PIN num-
ber.] is heard and [Current PIN?] is dis-
played. 2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob to
select a number. When using a voice command:
[XXXX (PIN number) Push the talk switch
and say confirm. Otherwise, say go back.]
is heard and PIN number is displayed.
Follow voice guidance instructions, or turn
the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the knob.
[PIN number accepted. The phone book is
now locked. Returning to the main menu.]
is heard and [Locked] is displayed.
When using the knob:
1. Turn the “AUDIO CONTROL” knob to select a number. Push the “AUDIO
CONTROL” knob to set.
2. When the PIN number is set, push the “AUDIO CONTROL” knob.
[XXXX Push the talk switch and say con-
firm. Otherwise, say go back.] is heard
and PIN number is displayed. 3. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the
knob.
[PIN number accepted. The phone book is
now locked. Returning to the main menu.]
is heard and [Locked] is displayed.

’08 Rav4_U (L/O 0802)
253
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
The system may not function in the follow-
ing cases:
If the current number is not correct.
If the phone book has already been
locked.
If the PIN number does not exist.
To unlock the phone book
1. Push the talk switch and say [Phone book unlock], or turn the “AUDIO CON-
TROL” knob until [Phbk Unlock] is dis-
played and push the knob.
[Phonebook unlock. There is a PIN num-
ber in place. Push the talk switch and say
the correct PIN number.] is heard and
[Current PIN?] is displayed. 2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob to
select a number. When using a voice command:
[XXXX (PIN number) Push the talk switch
and say confirm. Otherwise, say go back.]
is heard and the PIN number is displayed.
Follow voice guidance instructions, or turn
the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the knob.
[PIN number accepted. The phone book is
now unlocked. Returning to the main
menu.] is heard and [Unlocked] is dis-
played.
When using the knob:
1. Turn the “AUDIO CONTROL” knob to select a number. Push the “AUDIO
CONTROL” knob to set.
2. When the PIN number is set, push the “AUDIO CONTROL” knob.
[XXXX Push the talk switch and say con-
firm. Otherwise, say go back.] is heard
and the PIN number is displayed. 3. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the
knob.
[PIN number accepted. The phone book is
now unlocked. Returning to the main
menu.] is heard and [Unlocked] is dis-
played. The system may not function in the follow-
ing cases:
If the current number is not correct.
If the phone book has already been
unlocked.
INFORMATION
A shortcut to each of the following
functions is available. Enter the
phone book menu, push the offhook
switch, and say either of the follow-
ing:
Phone book lock
Phone book unlock

’08 Rav4_U (L/O 0802)
255
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
To enter the phone book menu1. Push the off −hook switch to turn the
hands −free system on.
2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Phonebook] is displayed and push the
knob.
[Phone book. Please push the talk switch
and say add entry, change name, delete
entry, list names, set speed dial or delete
speed dial.] is heard.
If the phone book is locked, the system
may not function properly. To add entry
The add entry includes the following:
(a) By Voice
(b) By Phone
(c) Call History
(d) Manual Input
Push the talk switch and say [Add entry],
or turn the “AUDIO CONTROL” knob until
[Add Entry] is displayed and push the
knob.
[Add Entry. How will the number be en-
tered. Push the talk switch and say by
voice, by phone, or call history.] is heard.(a) By Voice
1. Push the talk switch and say [By voice], or turn the “AUDIO CONTROL”
knob until [By Voice] is displayed and
push the knob.
[Voice entry. Push the talk switch and say
the number.] is heard. 2. Push the talk switch and say the dial number that you want to register.
[To store, push the talk switch and say
confirm. Otherwise, continue adding num-
bers, or say go back, or delete.] is heard
and number is displayed. 3. Follow voice guidance instructions.

’08 Rav4_U (L/O 0802)
263
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
Store1. Turn the “AUDIO CONTROL” knob until the dial number that you want to regis-
ter is displayed and push the knob.
2. Push the talk switch and say [Store], or turn the “AUDIO CONTROL” knob
until [Store] is displayed and push the
knob.
[Store. Push the talk switch and say con-
firm. Otherwise, say go back.] is heard. 3. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Confirm] is displayed and push the
knob.
Next, input a voice tag.
For further details, see page 255.
The system may not function in the follow-
ing cases:
If there is no outgoing history.
If the phone book is locked.
INFORMATION
Up to five outgoing calls can be
stored in the system.
When five outgoing calls are stored
in memory, the oldest outgoing call
is deleted to make room in memory
for new calls.
Only the latest outgoing call is
stored when the same telephone
number is dialed.
A shortcut to “Redial” is available.
Push the offhook switch and then
push the offhook switch.
The following can be performed:
Dial
Delete
Store
To enter the callback 1. Push the off −hook switch to turn the
hands −free system on.
2. Follow voice guidance instructions, or turn the “AUDIO CONTROL” knob until
[Callback] is displayed and push the
knob.
[Callback. Most recent incoming call was
XXXX (phone number)] is heard and in-
coming history is displayed.
[Please push the off −hook switch to dial.
Otherwise, push the talk switch and say
dial, previous, go back, store, or delete.]
is heard.
—Callback