2008 TOYOTA LAND CRUISER torque

472 5−2. Steps to take in an emergency
Firmly tighten each nut two or
three times in the order shown in
the illustration.
Tightening torque:
97 ftlbf (131 Nm, 13.4 kgfm)
Reinstall the wheel ornament.
Stowing the flat/spare tire, jack and tools
Lay down the tire with the outer
side facing up, and install the
holding bracket.
Raise the tire.
Pull the tire towards the rear of the vehicle when raising. After
raising, visually check that tire
is not interfering with compo−
nents.
Stow the tools and jack securely, and replace all covers.
STEP4
STEP 5
ITY52C033
STEP1
STEP 2
STEP 3

474 5−2. Steps to take in an emergency
CAUTION
n Replacing a flat tire
Observe the following precautions to reduce the risk of injury.
lLower the spare tire completely to the ground before removing it from
under the vehicle.
lDo not try to remove the wheel ornament by hand. Take due care in
handling the ornament to avoid unexpected personal injury.
lNever use oil or grease on the wheel bolts or wheel nuts.
The oil or grease can cause the wheel nuts to loosen, causing a seri−
ous accident. Remove any oil or grease on the wheel bolts or wheel
nuts.
lHave the wheel nuts tightened with a torque wrench to 97 ftlbf (131
Nm, 13.4 kgfm) as soon as possible after changing wheels.
Failure to follow these precautions could cause the nuts to loosen and
the wheels may fall off, which could lead to an accident causing death
or serious injury.
lDo not attach a heavily damaged wheel ornament, as it may fly off the
wheel while the ve
hicle is moving.

502 6−1. Specifications
Tires and wheels
Tire sizeP285/60R18 114V
Tire inflation pressure
(Recommended cold tire
inflation pressure)Normal driving
Front tires:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Rear tires:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Spare tire:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Trailer towing
Front tires:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Rear tires:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Spare tire:
33 psi (230 kPa, 2.3 kgf/cm
2 or bar)
Wheel size 18
8 J
Wheel nut torque
97 ftlbf (131 Nm, 13.4 kgfm)