2008 TOYOTA LAND CRUISER key

30 1−2. Opening, closing and locking the doors
nOperation signals
A buzzer sounds and the emergency flashers flash to indicate that the doors
have been locked/unlocked. (Locked: Once; Unlocked: Twice)
nDoor lock buzzer
If a door is not fully closed, a buzzer sounds continuously if an attempt to
lock the door is made. Fully close the door to stop the buzzer, and lock the
vehicle once more.
nConditions affecting operation
The smart key system uses weak radio waves. In the following situations,
the communication between the electronic key and the vehicle may be
affected, preventing the smart key system and wireless remote control from
operating properly. (Way of coping
P. 481)
lWhen the electronic key battery is depleted
lNear a TV tower, electric power plant, gas station, radio station, large dis−
play, airport or other facility that
generates strong radio waves or electri−
cal noise
lWhen carrying a portable radio, ce llular phone, cordless phone or other
wireless communication devices
lWhen the electronic key has come into contact with, or is covered by a
metallic object
lWhen multiple electronic keys are in the vicinity
lWhen carrying or using the electronic key together with the following
devices that emit radio waves
Another vehicle’s electronic key
A wireless key that emits radio waves
Personal computer
lIf window tint with a metallic content or metallic objects are attached to
the rear window

31
1−2. Opening, closing and locking the doors
1
Before driving
nSwitching the door unlock function
If it is possible to set which doors the entry function unlocks.
Turn the “ENGINE START STOP” switch OFF.
When the indicator on the key surface is turned off, press and hold
, or for approximately 5 seconds while pressing
on the key.
The setting changes each time an operation is preformed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step 2.)
STEP1
STEP 2
Multi−information
displayUnlocking function Beep
Hold the driver ’s door han−
dle to unlock only the
driver ’s door.Exterior: Beeps three
times
Interior: Pings once
Hold either door handle to
unlock all doors.
Exterior: Beeps twice
Interior: Pings once

32 1−2. Opening, closing and locking the doors
nBatterysaving function
In the following circumstances, the entry function is disabled in order to pre−
vent the vehicle and electronic key batteries from discharging.
lWhen the entry function has not been used for 2 weeks or more
lWhen the electronic key has been left within approximately 3 ft. (1 m) of
the vehicle for 10 minutes or more
The system will resume operation when...
lThe vehicle is locked using the door handle lock switch.
lThe vehicle is locked/unlocked using the wireless remote control function
(
P. 40) or the mechanical key. ( P. 481)
nElectronic key battery depletion
lThe standard battery life is 1 to 2 years. (The battery becomes depleted
even if the electronic key is not used.) If the smart key system or the
wireless remote control function does not operate, or the detection area
becomes smaller, the battery may be depleted. Replace the battery when
necessary. ( P. 410)
lTo avoid serious deterioration, do not leave the electronic key within 3 ft.
(1 m) of the following electrical appliances that produce a magnetic field.
TVs
Personal computers
Recharging cellular phones or cordless phones
Table lamps
nTo operate the system properly
Make sure to carry the electronic key when operating the system. Do not get
the electronic key too close to the vehicle when operating the system from
the outside of the vehicle.
Depending on the position and holding condition of the electronic key, the
key may not be detected correctly and the system may not operate properly.
(The alarm may go off accidentally, or
the door lock prevention may not func−
tion.)

33
1−2. Opening, closing and locking the doors
1
Before driving
nNote for the smart key system
lEven when the electronic key is within the effective range (detection
areas), the system may not operate properly in the following cases.
The electronic key is too close to the window or outside door handle,
near the ground, or in a high place when the doors are locked or
unlocked.
The electronic key is near the ground or in a high place, or too close to
the rear bumper center when the back door is locked or unlocked.
The electronic key is on the instrument panel, floor or in the glove box
when the engine is started or “ENGINE START STOP” switch modes
are changed.
lAs long as the electronic key is within the effective range, the doors may
be locked or unlocked by anyone.
lEven if the electronic key is not inside the vehicle, it may be possible to
start the engine if the electronic key is near the window.
lThe doors may unlock if a large amount of water splashes on the door
handle, such as in the rain or in a car wash. (The doors will automatically
be locked after approximately 60 seconds if the doors are not opened
and closed.)
lGripping the door handle when wearing a glove may not unlock the door.
lIf the wireless remote control is used to lock the doors when the elec−
tronic key is near the vehicle, there is a possibility that the door may not
be unlocked by the smart key system. (Use the wireless remote control to
unlock the doors.)
lA sudden approach to the effective range or door handle operation may
prevent the doors from being unlocked.
In this case, return the door han−
dle to the original position and check that the doors unlock before pulling
the door handle.
nWhen the vehicle is not driven for extended periods
To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2
m) of the vehicle.
nSecurity feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again.

34 1−2. Opening, closing and locking the doors
nAlarms and warning indicators
A combination of exterior and interior alarms as well as warnings displayed
on the multi−information display are used to prevent theft of the vehicle and
unforeseeable accidents resulting from erroneous operation. Perform the
appropriate correction procedure de
scribed in the following table.
AlarmSituation Correction procedure
Exterior alarm
sounds once for
2 secondsAn attempt was made to
lock the doors using the
entry function while the
electronic key was still
inside the passenger com−
partmentRetrieve the elec−
tronic key from the
passenger compart−
ment and lock the
doors again
Exterior alarm
sounds once for
60 secondsAn attempt was made to
exit the vehicle and lock
the doors without first turn−
ing the “ENGINE START
STOP” switch OFFTurn the “ENGINE
START STOP” switch
OFF and lock the
doors again
Exterior alarm
sounds once for
10 secondsAn attempt was made to
lock the vehicle while a
door is openClose all of the doors
and lock the doors
again
Interior alarm
pings continu−
ously
*1
The “ENGINE START
STOP” switch was turned
to ACCESSORY mode
while the driver ’s door was
open (or the driver ’s door
was opened while the
“ENGINE START STOP”
switch was in ACCES−
SORY mode)Turn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door
The “ENGINE START
STOP” switch was turned
OFF while the driver ’s door
was open
Close the driver ’s
door

35
1−2. Opening, closing and locking the doors
1
Before driving
AlarmSituation Correction procedure
Interior alarm
sounds continu−
ously
*1
When the “ENGINE
START STOP” switch is in
IGNITION ON or ACCES−
SORY mode, an attempt
was made to open the
door and exit the vehicle,
and the shift lever was not
in “P”Shift the shift lever to
“P” and turn the
“ENGINE START
STOP” switch OFF
Interior and exte−
rior alarms sound
continuously
*1
When the “ENGINE
START STOP” switch is in
IGNITION ON or ACCES−
SORY mode, the driver ’s
door was closed after the
key was carried outside
the vehicle, and the shift
lever not in “P”Shift the shift lever to
“P”, turn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door again
Interior alarm
pings once
*1
The electronic key has a
low batteryReplace the electronic
key battery
An attempt was made to
start the engine without the
electronic key being
present, or the electronic
key was not functioning
normallyStart the engine with
the electronic key
present*
2

36 1−2. Opening, closing and locking the doors
*1: A message will be shown on the multi−information display in the instru−
ment cluster.
*2: If the engine does not start when the electronic key is inside the vehicle,
the electronic key battery may be depleted or there may be difficulties
receiving signal front the key. (
P. 481)
nIf the smart key system does not operate properly
l
Locking and unlocking the doors: Use the mechanical key. ( P. 481)
lStarting the engine: P. 150
n
P. 410
nCustomization that can be configured at Toyota dealer
Settings (e.g. smart key system) can be changed. (Customizable features
P. 519)
AlarmSituation Correction procedure
Interior alarm
pings once and
exterior alarm
sounds 3 times
*1
The driver ’s door was
closed after the key was
carried outside the vehicle,
and the “ENGINE START
STOP” switch was not
turned OFFTurn the “ENGINE
START STOP” switch
OFF and close the
driver ’s door again
An occupant carried the
electronic key outside the
vehicle and closed the
door while the “ENGINE
START STOP” switch was
not OFF
Bring the electronic
key back into the vehi−
cle

37
1−2. Opening, closing and locking the doors
1
Before driving
nCertification for the smart key system
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer−
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible
for compliance could void the user ’s authority to operate the equipment.
FCC ID:NI4TMLF−5